- 您現在的位置：買賣IC網 > PDF目錄299980 > TLV2771QDBVRQ1 (TEXAS INSTRUMENTS INC) OP-AMP, 2700 uV OFFSET-MAX, 4.8 MHz BAND WIDTH, PDSO5 PDF資料下載
參數資料
| 型號： | TLV2771QDBVRQ1 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 運算放大器 |
| 英文描述： | OP-AMP, 2700 uV OFFSET-MAX, 4.8 MHz BAND WIDTH, PDSO5 |
| 封裝： | PLASTIC, SOT-23, 5 PIN |
| 文件頁數： | 26/45頁 |
| 文件大?。?/td> | 986K |
| 代理商： | TLV2771QDBVRQ1 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁
TLV277x-Q1, TLV277xA-Q1
FAMILY OF 2.7-V HIGH-SLEW-RATE RAIL-TO-RAIL OUTPUT
OPERATIONAL AMPLIFIERS WITH SHUTDOWN
SGLS179D SEPTEMBER 2003 REVISED AUGUST 2008
32
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
gain calculation
Since the TLV2772 is capable of rail-to-rail output using a 3-V supply, VO = 0 (min) to 3 V (max). With no signal
from the sensor, nominal VO = reference voltage = 1.23 V. Therefore, the maximum negative swing from nominal
is 0 V 1.23 V = 1.23 V and the maximum positive swing is 3 V 1.23 V = 1.77 V. By modeling the shock sensor
as a low impedance voltage source with output of 2.25 mV/g (max) in the x and y axis and 1.7 mV/g (max) in
the z axis, the gain of the circuit is calculated by equation 1.
Gain
+
Output Swing
Sensor Signal
Acceleration
(1)
To avoid saturation of the operational amplifier, the gain calculations are based on the maximum negative swing
of 1.23 V and the maximum sensor output of 2.25 mV/g (x and y axis) and 1.70 mV/g (z axis).
Gain (x, y)
+
* 1.23 V
2.25 mV g
* 50 g
+ 10.9
(2)
Gain (z)
+
–1.23 V
1.70 mV g
–50 g
+ 14.5
(3)
and
By selecting R3 = 10 k
and R4 = 100 k, in the x and y channels, a gain of 11 is realized. By selecting
R3 = 7.5 k
and R4 = 100 k, in the z channel, a gain of 14.3 is realized. The schematic shows the configuration
for either the x- or y-axis.
bandwidth calculation
To calculate the component values for the frequency shaping characteristics of the signal conditioning circuit,
1 Hz and 500 Hz are selected as the minimum required 3-dB bandwidth.
To minimize the value of the input capacitor (C1) required to set the lower cutoff frequency requires a large value
resistor for R2 is required. A 1-M
resistor is used in this example. To set the lower cutoff frequency, the required
capacitor value for C1 is:
C1
+
1
2
p f
LOW R2
+ 0.159 F
(4)
Using a value of 0.22
F, a more common value of capacitor, the lower cutoff frequency is 0.724 Hz.
To minimize the phase shift in the feedback loop caused by the input capacitance of the TLV2772, it is best to
minimize the value of the feedback resistor R4. However, to reduce the required capacitance in the feedback
loop a large value for R4 is required. Therefore, a compromise for the value of R4 must be made. In this circuit,
a value of 100 k
has been selected. To set the upper cutoff frequency, the required capacitor value for C2 is:
C2
+
1
2
p f
HIGH R4
+ 3.18 F
(5)
Using a 2.2-nF capacitor, the upper cutoff frequency is 724 Hz.
R5 and C3 also cause the signal response to roll off. Therefore, it is beneficial to design this roll-off point to begin
at the upper cutoff frequency. Assuming a value of 1 k
for R5, the value for C3 is calculated to be
0.22
F.
相關PDF資料 |
PDF描述 |
|---|---|
| TLV2773AQDRQ1 | DUAL OP-AMP, 5.1 MHz BAND WIDTH, PDSO14 |
| TLV2773QDRQ1 | DUAL OP-AMP, 5.1 MHz BAND WIDTH, PDSO14 |
| TLV2780CDBVRG4 | OP-AMP, 4500 uV OFFSET-MAX, 8 MHz BAND WIDTH, PDSO6 |
| TLV2780CDBVTG4 | OP-AMP, 4500 uV OFFSET-MAX, 8 MHz BAND WIDTH, PDSO6 |
| TLV2780IDBVTG4 | OP-AMP, 4500 uV OFFSET-MAX, 8 MHz BAND WIDTH, PDSO6 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLV2772ACD | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Texas Instruments 功能描述: |
| TLV2772AID | 功能描述:運算放大器 - 運放 Dual 2.7V Rail-Rail RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| TLV2772AID | 制造商:Texas Instruments 功能描述:IC SM OP-AMP DUAL RRO/P |
| TLV2772AIDG4 | 功能描述:運算放大器 - 運放 Dual 2.7-V High-Slew Rate R-To-R Output RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| TLV2772AIDR | 功能描述:運算放大器 - 運放 Dual 2.7-V High-Slew Rate R-To-R Output RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。