- 您現在的位置：買賣IC網 > PDF目錄382673 > TPA032D02DCAR Dual Audio Amplifier PDF資料下載
參數資料
| 型號： | TPA032D02DCAR |
| 元件分類： | 運動控制電子 |
| 英文描述： | Dual Audio Amplifier |
| 中文描述： | 雙音頻放大器 |
| 文件頁數： | 28/31頁 |
| 文件大?。?/td> | 445K |
| 代理商： | TPA032D02DCAR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁當前第28頁第29頁第30頁第31頁
TPA0312
2-W STEREO AUDIO POWER AMPLIFIER
WITH FOUR SELECTABLE GAIN SETTINGS AND MUX CONTROL
SLOS335 –DECEMBER 2000
28
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
SE/BTL operation
The ability of the TPA0312 to easily switch between BTL and SE modes is one of its most important cost saving
features. This feature eliminates the requirement for an additional headphone amplifier in applications where
internal stereo speakers are driven in BTL mode but external headphone or speakers must be accommodated.
Internal to the TPA0312, two separate amplifiers drive OUT+ and OUT–. The SE/BTL input (terminal 15)
controls the operation of the follower amplifier that drives LOUT– and ROUT– (terminals 9 and 16). When
SE/BTL is held low, the amplifier is on and the TPA0312 is in the BTL mode. When SE/BTL is held high, the OUT–
amplifiers are in a high output impedance state, which configures the TPA0312 as an SE driver from LOUT+
and ROUT+ (terminals 4 and 21). I
DD
is reduced by approximately one-half in SE mode. Control of the SE/BTL
input can be from a logic-level CMOS source or, more typically, from a resistor divider network as shown in
Figure 42.
ROUT+
21
R
MUX
RHPIN
RLINEIN
+
–
23
20
8
RIN
ROUT–
16
+
–
1 k
COUTR
330
μ
F
100 k
SE/BTL
15
100 k
VDD
Figure 42. TPA0312 Resistor Divider Network Circuit
Using a readily available 1/8-in. (3.5 mm) stereo headphone jack, the control switch is closed when no plug is
inserted. When closed the 100-k
/1-k
divider pulls the SE/BTL input low. When a plug is inserted, the 1-k
resistor is disconnected and the SE/BTL input is pulled high. When the input goes high, the OUT– amplifier is
shut down causing the speaker to mute (virtually open-circuits the speaker). The OUT+ amplifier then drives
through the output capacitor (C
O
) into the headphone jack.
相關PDF資料 |
PDF描述 |
|---|---|
| TPA100RL | SINGLE BIDIRECTIONAL BREAKOVER DIODE|133V V(BO) MAX|800MA I(S)|DO-204AC |
| TPA120RL | DIP Switch; No. of Switch Positions:6; Circuitry:SPST; Contact Current Max:25mA; Switch Terminals:SMT Gull Wing; Overall Length:8.75mm; Pitch Spacing:1.28mm; Series:TDA; Actuator Style:Flush Slide RoHS Compliant: Yes |
| TPA130RL | SINGLE BIDIRECTIONAL BREAKOVER DIODE|173V V(BO) MAX|800MA I(S)|DO-204AC |
| TPA180RL | SINGLE BIDIRECTIONAL BREAKOVER DIODE|240V V(BO) MAX|800MA I(S)|DO-204AC |
| TPA200RL | Pushbutton Switch; Actuator Diameter:0.1"; Circuitry:SPST; Switch Operation:(On)-Off; Contact Rating:0.4VA at 20VAC/VDC; Features:Plunger Actuator; Leaded Process Compatible:Yes; Mounting Type:PCB; Peak Reflow Compatible (260 C):Yes |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPA032D02DCARG4 | 功能描述:音頻放大器 Stereo Medium Power Class-D Audio Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA032D02EVM | 制造商:Texas Instruments 功能描述:CLASS-D STEREO AUDIO POWER AMP EVM - Bulk |
| TPA032D03 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:10-W MONO CLASS-D AUDIO POWER AMPLIFIER |
| TPA032D03_07 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:10-W MONO CLASS-D AUDIO POWER AMPLIFIER |
| TPA032D03DCA | 功能描述:音頻放大器 10W Monaur RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。