參數資料
型號: TPA3003D2PFB
廠商: TEXAS INSTRUMENTS INC
元件分類: 音頻控制
英文描述: 2 CHANNEL(S), VOLUME CONTROL CIRCUIT, PQFP48
封裝: GREEN, PLASTIC, TQFP-48
文件頁數: 10/36頁
文件大小: 755K
代理商: TPA3003D2PFB
TPA3003D2
SLOS406A FEBRUARY 2003 REVISED MARCH 2003
18
www.ti.com
APPLICATION INFORMATION
when to use an output filter (continued)
0.1
F
0.1
F
0.47
F
33
H
33
H
OUTP
OUTN
L1
L2
C1
C2
C3
Figure 24. Typical LC Output Filter, Cutoff Frequency of 41 kHz, Speaker Impedance = 8
1 nF
Ferrite
Chip Bead
OUTP
OUTN
Ferrite
Chip Bead
1 nF
Figure 25. Typical Ferrite Chip Bead Filter (Chip bead example: Fair-Rite 2512067007Y3)
volume control operation
The VOLUME terminal controls the internal amplifier gain. This pin is controlled with a dc voltage, which should
not exceed VREF. Table 1 lists the gain as determined by the voltage on the VOLUME pin in reference to the
voltage on VREF.
If using a resistor divider to fix the gain of the amplifier, the VREF terminal can be directly connected to
AVDDREF and a resistor divider can be connected across VREF and REFGND. (See Figure 21 in the
Application Information Section). For fixed gain, calculate the resistor divider values necessary to center the
voltage between the two percentage points given in the first column of Table 1. For example, if a gain of 10.7
dB is desired, the resistors in the divider network can both be 10 k
. With these resistor values, a voltage of
50%*VREF will be present at the VOLUME pin and result in a class-D gain of 10.7 dB.
If using a DAC to control the class-D gain, VREF and REFGND should be connected to the reference voltage
for the DAC and the GND terminal of the DAC, respectively. For the DAC application, AVDDREF would be left
unconnected. The reference voltage of the DAC provides the reference to the internal gain circuitry through the
VREF input and any fluctuations in the DAC output voltage will not affect the TPA3003D2 gain. The percentages
in the first column of Table 1 should be used for setting the voltages of the DAC when the voltage on the VOLUME
terminal is increased. The percentages in the second column should be used for the DAC voltages when
decreasing the voltage on the VOLUME terminal. Two lookup tables should be used in software to control the
gain based on an increase or decrease in the desired system volume. This is explained further in a section
below.
相關PDF資料
PDF描述
TPA3003D2PFBRG4 2 CHANNEL(S), VOLUME CONTROL CIRCUIT, PQFP48
TPA3003D2PFBG4 2 CHANNEL(S), VOLUME CONTROL CIRCUIT, PQFP48
TPA3004D2PHPRG4 2 CHANNEL(S), VOLUME CONTROL CIRCUIT, PQFP48
TPA3004D2PHPG4 2 CHANNEL(S), VOLUME CONTROL CIRCUIT, PQFP48
TPA3005D2PHPR 6 W, 2 CHANNEL, AUDIO AMPLIFIER, PQFP48
相關代理商/技術參數
參數描述
TPA3003D2PFBG4 功能描述:音頻放大器 Ster Lo-Pwr Wide Sply Vltg Class-D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TPA3003D2PFBR 功能描述:音頻放大器 Ster Lo-Pwr Wide Sply Vltg Class-D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TPA3003D2PFBRG4 功能描述:音頻放大器 Ster Lo-Pwr Wide Sply Vltg Class-D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TPA3004 制造商:TI 制造商全稱:Texas Instruments 功能描述:12-W STEREO CLASS-D AUDIO POWER AMPLIFIER WITH DC VOLUME CONTROL
TPA3004D2 制造商:TI 制造商全稱:Texas Instruments 功能描述:12-W STEREO CLASS-D AUDIO POWER AMPLIFIER WITH DC VOLUME CONTROL