參數資料
型號: TPA3004D2PHPG4
廠商: TEXAS INSTRUMENTS INC
元件分類: 音頻控制
英文描述: 2 CHANNEL(S), VOLUME CONTROL CIRCUIT, PQFP48
封裝: GREEN, PLASTIC, HTQFP-48
文件頁數: 31/46頁
文件大小: 838K
代理商: TPA3004D2PHPG4
C
IN
Audio Power
Amplifier
Generator
Low–Pass
RC Filter
C
IN
R
GEN
R
GEN
R
IN
R
IN
V
GEN
R
OUT
R
OUT
Analyzer
R
ANA
R
ANA
C
ANA
Low–Pass
RC Filter
R
L
C
ANA
Twisted–Pair Wire
Evaluation Module
Twisted–Pair Wire
www.ti.com
SLOS407E – FEBRUARY 2003 – REVISED JANUARY 2011
Figure 50. Differential Input—BTL output Measurement Circuit
The generator should have balanced outputs and the signal should be balanced for best results. An unbalanced
output can be used, but it may create a ground loop that will affect the measurement accuracy. The analyzer
must also have balanced inputs for the system to be fully balanced, thereby cancelling out any common mode
noise in the circuit and providing the most accurate measurement.
The following general rules should be followed when connecting to APAs with differential inputs and BTL outputs:
Use a balanced source to supply the input signal.
Use an analyzer with balanced inputs.
Use twisted-pair wire for all connections.
Use shielding when the system environment is noisy.
Ensure the cables from the power supply to the APA, and from the APA to the load, can handle the large
currents (see Table 4).
Table 4 shows the recommended wire size for the power supply and load cables of the APA system. The real
concern is the dc or ac power loss that occurs as the current flows through the cable. These recommendations
are based on 12-inch long wire with a 20-kHz sine-wave signal at 25°C.
Table 4. Recommended Minimum Wire Size for Power Cables
POUT
RL
DC Power Loss
AC Power Loss
AWG Size
(W)
(
)
(mW)
10
4
18
22
16
40
18
42
2
4
18
22
3.2
8.0
3.7
8.5
1
8
22
28
2.0
8.0
2.1
8.1
< 0.75
8
22
28
1.5
6.1
1.6
6.2
CLASS-D RC LOW-PASS FILTER
An RC filter is used to reduce the square-wave output when the analyzer inputs cannot process the pulse-width
modulated class-D output waveform. This filter has little effect on the measurement accuracy because the cutoff
frequency is set above the audio band. The high frequency of the square wave has negligible impact on
measurement accuracy because it is well above the audible frequency range and the speaker cone cannot
respond at such a fast rate. The RC filter is not required when an LC low-pass filter is used, such as with the
class-D APAs that employ the traditional modulation scheme (TPA032D0x, TPA005Dxx).
The component values of the RC filter are selected using the equivalent output circuit as shown in Figure 51. RL
is the load impedance that the APA is driving for the test. The analyzer input impedance specifications should be
available and substituted for RANA and CANA. The filter components, RFILT and CFILT, can then be derived for the
system. The filter should be grounded to the APA near the output ground pins or at the power supply ground pin
to minimize ground loops.
Copyright 2003–2011, Texas Instruments Incorporated
37
Product Folder Link(s): TPA3004D2
相關PDF資料
PDF描述
TPA3005D2PHPR 6 W, 2 CHANNEL, AUDIO AMPLIFIER, PQFP48
TPA3005D2PHP 6 W, 2 CHANNEL, AUDIO AMPLIFIER, PQFP48
TPA3005D2PHPG4 6 W, 2 CHANNEL, AUDIO AMPLIFIER, PQFP48
TPA3005D2PHPRG4 6 W, 2 CHANNEL, AUDIO AMPLIFIER, PQFP48
TPA3007D1PWR 6.5 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO24
相關代理商/技術參數
參數描述
TPA3004D2PHPR 功能描述:音頻放大器 Stereo Hi-Pwr Filter-Free Class-D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TPA3004D2PHPR 制造商:Texas Instruments 功能描述:AUDIO POWER AMPLIFIER IC
TPA3004D2PHPRG4 功能描述:音頻放大器 Stereo Hi-Pwr Filter-Free Class-D RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TPA3005D2 制造商:TI 制造商全稱:Texas Instruments 功能描述:6-W STEREO CLASS-D AUDIO POWER AMPLIFIER
TPA3005D2EVM 功能描述:音頻 IC 開發工具 TPA3005D2 Eval Mod RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V