參數資料
型號: TPS40210DGQG4
廠商: TEXAS INSTRUMENTS INC
元件分類: 穩壓器
英文描述: SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO10
封裝: GREEN, PLASTIC, MSOP-10
文件頁數: 13/47頁
文件大?。?/td> 1375K
代理商: TPS40210DGQG4
Q
VDD
VDD(en)
P
V
I
=
f
G
VDD
g
SW
P
V
Q
=
E
VDD
EXT
P
V
I
=
SLUS772D – MARCH 2008 – REVISED APRIL 2010
www.ti.com
BP Regulator
The TPS40210/11 has an on board linear regulator the supplies power for the internal circuitry of the controller,
including the gate driver. This regulator has a nominal output voltage of 8 V and must be bypassed with a 1-mF
capacitor. If the voltage at the VDD pin is less than 8 V, the voltage on the BP pin will also be less and the gate
drive voltage to the external FET is reduced from the nominal 8 V. This should be considered when choosing a
FET for the converter.
Connecting external loads to this regulator can be done, but care must be taken to ensure that the thermal rating
of the device is observed since there is no thermal shutdown feature in this controller. Exceeding the thermal
ratings cause out of specification behavior and can lead to reduced reliability. The controller dissipates more
power when there is an external load on the BP pin and is tested for dropout voltage for up to 5-mA load. When
the controller is in the disabled state, the BP pin regulator also shuts off so loads connected there power down
as well. When the controller is disabled with the DIS/EN pin, this regulator is turned off.
The total power dissipation in the controller can be calculated as follows. The total power is the sum of PQ, PG
and PE.
(19)
(20)
(21)
Where:
PQ is the quiescent power of the device in W
VVDD is the VDD pin voltage in V
IVDD(en) is the quiescent current of the controller when enabled but not switching in A
PG is the power dissipated by driving the gate of the FET in W
Qg is the total gate charge of the FET at the voltage on the BP pin in C
f SW is the switching frequency in Hz
PE is the dissipation caused be external loading of the BP pin in W
IEXT is the external load current in A
Shutdown (DIS/EN Pin)
The DIS/EN pin is an active high shutdown command for the controller. Pulling this pin above 1.2 V causes the
controller to completely shut down and enter a low current consumption state. In this state, the regulator
connected to the BP pin is turned off. There is an internal 1.1-M
pull-down resistor connected to this pin that
keeps the pin at GND level when left floating. If this function is not used in an application, it is best to connect
this pin to GND.
20
Copyright 2008–2010, Texas Instruments Incorporated
Product Folder Link(s): TPS40210 TPS40211
相關PDF資料
PDF描述
TPS40304ADRCT SWITCHING CONTROLLER, PQCC10
TPS40304ADRCR SWITCHING CONTROLLER, PQCC10
TPS5100IPWRG4 SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
TPS5100PWLE SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
TPS5100PWR SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
相關代理商/技術參數
參數描述
TPS40210DGQR 功能描述:電流型 PWM 控制器 Wide Input Rnge Crnt Mode Boost Cntrlr RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14
TPS40210DGQRG4 功能描述:電流型 PWM 控制器 Wide In Range Crnt Mode Boost Cntrlr RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14
TPS40210DRCR 功能描述:電流型 PWM 控制器 Wide Inp Rng Crnt Mode Boost Cntrlr RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14
TPS40210DRCRG4 功能描述:電流型 PWM 控制器 Wide In Range Crnt Mode Boost Cntrlr RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14
TPS40210DRCT 功能描述:電流型 PWM 控制器 Wide Inp Rng Crnt Mode Boost Cntrlr RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14