參數資料
型號： TPS40210DGQG4
廠商： TEXAS INSTRUMENTS INC
元件分類： 穩壓器
英文描述： SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO10
封裝： GREEN, PLASTIC, MSOP-10
文件頁數： 5/47頁
文件大?。?/td> 1375K
代理商： TPS40210DGQG4
T
8
10
2
7
4
6
9
2
SW
T
SW
T
1
R
5.8
10
f
C
8
10
f
1.4
10
f
1.5
10
1.7
10
C
4
10
C
-
=
+
+
-
+
-
+
1
RC
150 mV
S
Q
R
+
8
5
VDD
GND
R
RC
C
RC
CLK
External Frequency
Synchronization
(optional)
V
IN
TPS40210/11
UDG-08063
www.ti.com
SLUS772D – MARCH 2008 – REVISED APRIL 2010
Setting the Oscillator Frequency
The oscillator frequency is determined by a resistor and capacitor connected to the RC pin of the TPS40210. The
capacitor is charged to a level of approximately VVDD/20 by current flowing through the resistor and is then
discharged by a transistor internal to the TPS40210. The required resistor for a given oscillator frequency is
found from either Figure 1 or Equation 5.
(5)
Where:
RT is the timing resistance in k
f SW is the switching frequency in kHz
CT is the timing capacitance in pF
For most applications a capacitor in the range of 68 pF to 120 pF gives the best results. Resistor values should
be limited to between 100 k
and 1 M as well. If the resistor value falls below 100 k, decrease the capacitor
size and recalculate the resistor value for the desired frequency. As the capacitor size decreases below 47 pF,
the accuracy of Equation 5 degrades and empirical means may be needed to fine tune the timing component
values to achieve the desired switching frequency.
Synchronizing the Oscillator
The TPS40210 and TPS40211 can be synchronized to an external clock source. Figure 20 shows the functional
diagram of the oscillator. When synchronizing the oscillator to an external clock, the RC pin must be pulled below
150 mV for 20 ns or more. The external clock frequency must be higher than the free running frequency of the
converter as well. When synchronizing the controller, if the RC pin is held low for an excessive amount of time,
erratic operation may occur. The maximum amount of time that the RC pin should be held low is 50% of a
nominal output pulse, or 10% of the period of the synchronization frequency.
Under circumstances where the duty cycle is less than 50%, a Schottky diode connected from the RC pin to an
external clock may be used to synchronize the oscillator. The cathode of the diode is connected to the RC pin.
The trip point of the oscillator is set by an internal voltage divider to be 1/20 of the input voltage. The clock signal
must have an amplitude higher than this trip point. When the clock goes low, it allows the reset current to restart
the RC ramp, synchronizing the oscillator to the external clock. This provides a simple, single-component method
for clock synchronization.
Figure 20. Oscillator Functional Diagram
Copyright 2008–2010, Texas Instruments Incorporated
13
Product Folder Link(s): TPS40210 TPS40211
相關PDF資料
PDF描述
TPS40304ADRCT SWITCHING CONTROLLER, PQCC10
TPS40304ADRCR SWITCHING CONTROLLER, PQCC10
TPS5100IPWRG4 SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
TPS5100PWLE SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
TPS5100PWR SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
相關代理商/技術參數
參數描述
TPS40210DGQR 功能描述:電流型 PWM 控制器 Wide Input Rnge Crnt Mode Boost Cntrlr RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14
TPS40210DGQRG4 功能描述:電流型 PWM 控制器 Wide In Range Crnt Mode Boost Cntrlr RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14
TPS40210DRCR 功能描述:電流型 PWM 控制器 Wide Inp Rng Crnt Mode Boost Cntrlr RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14
TPS40210DRCRG4 功能描述:電流型 PWM 控制器 Wide In Range Crnt Mode Boost Cntrlr RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14
TPS40210DRCT 功能描述:電流型 PWM 控制器 Wide Inp Rng Crnt Mode Boost Cntrlr RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*