參數資料
型號： TPS51211DSCR
廠商： TEXAS INSTRUMENTS INC
元件分類： 穩壓器
英文描述： SWITCHING CONTROLLER, 314 kHz SWITCHING FREQ-MAX, PDSO10
封裝： PLASTIC, SON-10
文件頁數： 10/26頁
文件大?。?/td> 674K
代理商： TPS51211DSCR
UDG-10163
TPS51211
Thermal Pad
DRVL
4
5
VIN
1 mF
VFB
V5IN
6
V
OUT
2
TRIP
5
TST
0.1 mF
100 W
VTT_SENSE
VSS_SENSE
GND
TPS51211
SLUSAA7 – NOVEMBER 2010
www.ti.com
source of the low-side MOSFET through ground. Connect negative node of V5IN capacitor, source of the
low-side MOSFET and GND pad of the device at ground as close as possible. (Refer to loop #3 of
Since the TPS51211 controls output voltage referring to voltage across VOUT capacitor, the top-side resistor of
the voltage divider should be connected to the positive node of VOUT capacitor. In a same manner both
bottom side resistor and GND pad of the device should be connected to the negative node of VOUT capacitor.
The trace　from these resistors to the VFB pin should be short and thin. Place on the component side and
avoid via(s) between these resistors and the device.
Connect the overcurrent setting resistors from TRIP pin to ground and make the connections as close as
possible to the device. The trace from TRIP pin to resistor and from resistor to ground should avoid coupling
to a high-voltage switching node.
Connect the frequency setting resistor from TST pin to ground, or to the PGOOD pin, and make the
connections as close as possible to the device. The trace from the TST pin to the resistor and from the
resistor to ground should avoid coupling to a high-voltage switching node.
Connections from gate drivers to the respective gate of the high-side or the low-side MOSFET should be as
short as possible to reduce stray inductance. Use 0.65 mm (25 mils) or wider trace　and via(s) of at least
0.5 mm (20 mils) diameter along this trace.
The PCB trace defined as switch node, which connects to source of high-side MOSFET, drain of low-side
MOSFET and high-voltage side of the inductor, should be as short and wide as possible.
LAYOUT CONSIDERATIONS TO REMOTE SENSING
Figure 17. Remote Sensing of Output Voltage Using the TPS51211
Make a Kelvin connection to the load device.
Run the feedback signals as a differential pair to the device. The distance of these parallel pair should be as
short as possible.
Run the lines in a quiet layer. Isolate them from noisy signals by a voltage or ground plane.
18
Copyright 2010, Texas Instruments Incorporated
相關PDF資料
PDF描述
TPS51220ARTVR DUAL SWITCHING CONTROLLER, 333 kHz SWITCHING FREQ-MAX, PQCC32
TPS51221RTVRG4 DUAL SWITCHING CONTROLLER, 333 kHz SWITCHING FREQ-MAX, PQCC32
TPS51315RGFR SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PQCC40
TPS51315RGFT SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PQCC40
TPS51317RGBT SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PQCC20
相關代理商/技術參數
參數描述
TPS51211DSCT 功能描述:DC/DC 開關控制器 Hi-Perf,Single Synch Step-Down Controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS51212DSCR 制造商:Texas Instruments 功能描述:LOW COST SINGLE PHASE DC/DC CONTROLLER
TPS51216 制造商:TI 制造商全稱:Texas Instruments 功能描述:Complete DDR2, DDR3 and DDR3L Memory Power Solution Synchronous Buck Controller, 2-A LDO, Buffered Reference
TPS51216MRUKREP 功能描述:D-CAP? Controller, DDR Voltage Regulator IC 2 Output 20-WQFN (3x3) 制造商:texas instruments 系列:D-CAP?? 包裝:剪切帶（CT） 零件狀態:有效 應用:控制器，DDR 電壓 - 輸入:4.5 V ~ 5.5 V 輸出數:2 電壓 - 輸出:0.7 V ~ 1.8 V 工作溫度:-55°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:20-WFQFN 裸露焊盤 供應商器件封裝:20-WQFN（3x3） 標準包裝:1
TPS51216RUKR 功能描述:DC/DC 開關控制器 Memory Power Sol Sync Buck Controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*