- 您現在的位置：買賣IC網 > PDF目錄98282 > TPS54260QDGQRQ1 (TEXAS INSTRUMENTS INC) 2.5 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO10 PDF資料下載
參數資料
| 型號： | TPS54260QDGQRQ1 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 2.5 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
| 封裝： | GREEN, PLASTIC, MSOP-10 |
| 文件頁數： | 18/48頁 |
| 文件大?。?/td> | 1456K |
| 代理商： | TPS54260QDGQRQ1 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁
SLVSAH8A
– DECEMBER 2010 – REVISED APRIL 2011
DETAILED DESCRIPTION (continued)
The PWRGD pin is pulled low when the VSENSE is lower than 92% or greater than 109% of the nominal internal
reference voltage. Also, the PWRGD is pulled low, if the UVLO or thermal shutdown are asserted or the EN pin
pulled low.
Overvoltage Transient Protection
The TPS54260-Q1 incorporates an overvoltage transient protection (OVTP) circuit to minimize voltage overshoot
when recovering from output fault conditions or strong unload transients on power supply designs with low value
output capacitance. For example, when the power supply output is overloaded the error amplifier compares the
actual output voltage to the internal reference voltage. If the VSENSE pin voltage is lower than the internal
reference voltage for a considerable time, the output of the error amplifier will respond by clamping the error
amplifier output to a high voltage. Thus, requesting the maximum output current. Once the condition is removed,
the regulator output rises and the error amplifier output transitions to the steady state duty cycle. In some
applications, the power supply output voltage can respond faster than the error amplifier output can respond, this
actuality leads to the possibility of an output overshoot. The OVTP feature minimizes the output overshoot, when
using a low value output capacitor, by implementing a circuit to compare the VSENSE pin voltage to OVTP
threshold which is 109% of the internal voltage reference. If the VSENSE pin voltage is greater than the OVTP
threshold, the high side MOSFET is disabled preventing current from flowing to the output and minimizing output
overshoot. When the VSENSE voltage drops lower than the OVTP threshold, the high side MOSFET is allowed
to turn on at the next clock cycle.
Thermal Shutdown
The device implements an internal thermal shutdown to protect itself if the junction temperature exceeds 182
°C.
The thermal shutdown forces the device to stop switching when the junction temperature exceeds the thermal
trip threshold. Once the die temperature decreases below 182
°C, the device reinitiates the power up sequence
by discharging the SS/TR pin.
Small Signal Model for Loop Response
Figure 46 shows an equivalent model for the TPS54260-Q1 control loop which can be modeled in a circuit
simulation program to check frequency response and dynamic load response. The error amplifier is a
transconductance amplifier with a gmEA of 310 μA/V. The error amplifier can be modeled using an ideal voltage
controlled current source. The resistor Ro and capacitor Co model the open loop gain and frequency response of
the amplifier. The 1mV ac voltage source between the nodes a and b effectively breaks the control loop for the
frequency response measurements. Plotting c/a shows the small signal response of the frequency compensation.
Plotting a/b shows the small signal response of the overall loop. The dynamic loop response can be checked by
replacing RL with a current source with the appropriate load step amplitude and step rate in a time domain
analysis. This equivalent model is only valid for continuous conduction mode designs.
Copyright
2010–2011, Texas Instruments Incorporated
25
相關PDF資料 |
PDF描述 |
|---|---|
| TPS5430MDDAREPG4 | 8.5 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, PDSO8 |
| TPS54310MPWPREP | 6 A SWITCHING REGULATOR, 775 kHz SWITCHING FREQ-MAX, PDSO20 |
| TPS54310PWPRG4 | 6 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO20 |
| TPS54320RHLR | SWITCHING REGULATOR, 1320 kHz SWITCHING FREQ-MAX, PQCC14 |
| TPS54320RHL | SWITCHING REGULATOR, PQCC14 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS54260QDRCRQ1 | 功能描述:Buck Switching Regulator IC Positive Adjustable 0.8V 1 Output 2.5A 10-VFDFN Exposed Pad 制造商:texas instruments 系列:汽車級，AEC-Q100，Eco-Mode? 包裝:剪切帶（CT） 零件狀態:有效 功能:降壓 輸出配置:正 拓撲:降壓 輸出類型:可調式 輸出數:1 電壓 - 輸入（最小值）:3.5V 電壓 - 輸入（最大值）:60V 電壓 - 輸出（最小值/固定）:0.8V 電壓 - 輸出（最大值）:60V 電流 - 輸出:2.5A 頻率 - 開關:100kHz ~ 2.5MHz 同步整流器:無 工作溫度:-40°C ~ 125°C（TA） 安裝類型:表面貼裝 封裝/外殼:10-VFDFN 裸露焊盤 供應商器件封裝:10-VSON（3x3） 標準包裝:1 |
| TPS54260QDRCTQ1 | 功能描述:Buck Switching Regulator IC Positive Adjustable 0.8V 1 Output 2.5A 10-VFDFN Exposed Pad 制造商:texas instruments 系列:汽車級，AEC-Q100，Eco-Mode? 包裝:剪切帶（CT） 零件狀態:有效 功能:降壓 輸出配置:正 拓撲:降壓 輸出類型:可調式 輸出數:1 電壓 - 輸入（最小值）:3.5V 電壓 - 輸入（最大值）:60V 電壓 - 輸出（最小值/固定）:0.8V 電壓 - 輸出（最大值）:60V 電流 - 輸出:2.5A 頻率 - 開關:100kHz ~ 2.5MHz 同步整流器:無 工作溫度:-40°C ~ 125°C（TA） 安裝類型:表面貼裝 封裝/外殼:10-VFDFN 裸露焊盤 供應商器件封裝:10-VSON（3x3） 標準包裝:1 |
| TPS54262EVM | 功能描述:電源管理IC開發工具 TPS54262EVM Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS54262QPWPRQ1 | 功能描述:DC/DC 開關控制器 Auto Cat 2A 60V step down DC/DC converter RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| TPS54283 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:SWIFT Converter Product Portfolio |
發布緊急采購，3分鐘左右您將得到回復。