- 您現在的位置：買賣IC網 > PDF目錄98302 > TSC2111IRGZR (TEXAS INSTRUMENTS INC) 0.4 W, 1 CHANNEL, AUDIO AMPLIFIER, QCC48 PDF資料下載
參數資料
| 型號： | TSC2111IRGZR |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 0.4 W, 1 CHANNEL, AUDIO AMPLIFIER, QCC48 |
| 封裝： | PLASTIC, QFN-48 |
| 文件頁數： | 25/99頁 |
| 文件大?。?/td> | 1143K |
| 代理商： | TSC2111IRGZR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁當前第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁
TSC2111
SLAS495A JUNE 2006 REVISED OCTOBER 2007
www.ti.com
31
For the cap interface, this feature can be disabled by setting bit D0 of control register 20H/page 2. In the case
of the cap-less interface, VGND short circuit protection must also be disabled, which can be achieved by setting
bit D4 of control register 21H/page 2.
The TSC2111 implements a pop reduction scheme to reduce audible artifacts during powerup and powerdown
of headphone drivers. The scheme can be controlled by programming bits D5 and D4 of control register
25H/page 2. By default, the driver pop reduction scheme is enabled and can be disabled by programming bit
D5 of control register 25H/page 2 to 1. When this scheme is enabled and the virtual ground connection is not
used (VGND amplifier is powered down), the audio output driver slowly charges up any external ac-coupling
capacitors to reduce audible artifacts. Bit D4 of control register 25H/page 2 provides control of the charging time
for the ac-coupling capacitor as either 0.8 sec or 4 sec. When the virtual ground amplifier is powered up and
used, the external ac-coupling capacitor is eliminated, and the powerup time becomes 1 ms. This scheme takes
effect whenever any of the headphone drivers are powered up.
D Speaker Driver
The TSC2111 has an integrated speaker driver (OUT8POUT8N) capable of driving an 8
differential load.
The speaker driver, powered directly from the battery supply (3.5 V to 4.2 V) on the BVDD pin can deliver 400
mW at 3.9 V supply. It allows connecting one or both DAC channel to speaker driver. The TSC2111 also has a
short circuit protection feature for the speaker driver which can be enabled by setting bit D5 of control register
21H/page 2.
D Receiver Driver
The TSC2111 includes a receiver driver (SPK1OUT32N), which can drive a 32
differential load. It is
capable of delivering 82 mW into a 32
load. The TSC2111 does not allow both the receiver driver and
headphone drivers to be turned on at the same time. Also, when the receiver driver is being used, the
headphone driver load must be disconnected.
D Simultaneous DAC Playback to Headphone and Speaker Outputs
The TSC2111 allows simultaneous DAC playback by using the BUZZ_IN PGA to route the SPL1 and SPK2
signals to the OUT8P and OUT8N drivers (bits D7 and D6, Register 25h, page 2). By utilizing the BUZZ_IN
PGA fully independent volume control of the headphone and of the speaker driver outputs are achieved.
Headset Interface
The TSC2111 supports all standard headset interfaces. It is capable of interfacing with 3-wire stereo headset,
3-wire cellular headset and 4-wire stereo-cellular headsets. It supports both capacitor-coupled (cap) and
capacitor-less (capless) interface for headset through software programming.
D Capless Interface
Figure 22 shows the connection diagram to the TSC2111 for capless interface. VGND acts as a ground of
headset jack. Voltage at VGND is 1.5 V and MICBIAS_HED voltage is programmed to 3.3 V. With this, the
voltage across microphone is configured to be 1.8 V. In order to minimize the effect of routing resistance on
VGND inside the device and on the printed circuit board (PCB), SPKFC should be shorted to VGND at the
jack. This reduces crosstalk from speaker to microphone because of common ground as VGND.
相關PDF資料 |
PDF描述 |
|---|---|
| TSC2111IRGZT | 0.4 W, 1 CHANNEL, AUDIO AMPLIFIER, QCC48 |
| TSC2111IRGZRG4 | 0.4 W, 1 CHANNEL, AUDIO AMPLIFIER, QCC48 |
| TSC2111IRGZTG4 | 0.4 W, 1 CHANNEL, AUDIO AMPLIFIER, QCC48 |
| TSC2117IRGZR | SPECIALTY CONSUMER CIRCUIT, QCC48 |
| TSC2117IRGZT | SPECIALTY CONSUMER CIRCUIT, QCC48 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSC2111IRGZRG4 | 功能描述:觸摸屏轉換器和控制器 SMART 4-Wire with Audio RoHS:否 制造商:Microchip Technology 類型:Resistive Touch Controllers 輸入類型:3 Key 數據速率:140 SPS 分辨率:10 bit 接口類型:4-Wire, 5-Wire, 8-Wire, I2C, SPI 電源電壓:2.5 V to 5.25 V 電源電流:17 mA 工作溫度:- 40 C to + 85 C 封裝 / 箱體:SSOP-20 |
| TSC2111IRGZT | 功能描述:觸摸屏轉換器和控制器 SMART 4-Wire with Audio RoHS:否 制造商:Microchip Technology 類型:Resistive Touch Controllers 輸入類型:3 Key 數據速率:140 SPS 分辨率:10 bit 接口類型:4-Wire, 5-Wire, 8-Wire, I2C, SPI 電源電壓:2.5 V to 5.25 V 電源電流:17 mA 工作溫度:- 40 C to + 85 C 封裝 / 箱體:SSOP-20 |
| TSC2111IRGZTG4 | 功能描述:觸摸屏轉換器和控制器 SMART 4-Wire with Audio RoHS:否 制造商:Microchip Technology 類型:Resistive Touch Controllers 輸入類型:3 Key 數據速率:140 SPS 分辨率:10 bit 接口類型:4-Wire, 5-Wire, 8-Wire, I2C, SPI 電源電壓:2.5 V to 5.25 V 電源電流:17 mA 工作溫度:- 40 C to + 85 C 封裝 / 箱體:SSOP-20 |
| TSC-2-1-15 | 制造商:Micrel Inc 功能描述: |
| TSC2117 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:Low-Power Audio Codec With Embedded miniDSP, Stereo Class-D Speaker Amplifier, and Smart Four-Wire Touch-Screen Controller |
發布緊急采購，3分鐘左右您將得到回復。