參數資料
型號: TUA6036-T
廠商: INFINEON TECHNOLOGIES AG
元件分類: 調諧器
英文描述: 3-BAND, VIDEO TUNER, PDSO38
封裝: TSSOP-38
文件頁數: 43/65頁
文件大?。?/td> 1391K
代理商: TUA6036-T
Specification
48
V 2.51, 2006-01-11
TUA6034, TUA6036
TAIFUN
Reference
159. AGC output voltage V
AGCmax
3.6
3.8
4.0
V
maximum level,
IAGC = 9 A
160. AGC output voltage V
AGCmin
0
0.25 V
minimum level
161. RF voltage range to
switch the AGC
from active to
inactive mode
AGC
SLIP
0.5
dB
162. AGC output voltage AGC
RML
0
2.9
V
AGC bit high or
AGC active
163. AGC output voltage AGC
RMH
3.3
3.8
VCC-
0.5
or 4
V
AGC bit low or
AGC inactive
164. AGC leakage
current
AGC
LEAK
-50
50
nA
AL2, AL1, AL0 =
1,1,0
0 < V
AGC < VCC
165. AGC output voltage AGC
OFF
3.3
3.8
VCC-
0.5
or 4
V
AL2, AL1, AL0 =
1,1,1
AGC is disabled
■ This value is only guaranteed in lab.
1) The RF frequency range is defined by the oscillator frequency range and the intermediate frequency (IF).
2) This is the level of the RF unwanted signal (50% amplitude modulated with 1kHz) that causes a 1.1 kHz FM
modulation of the local oscillator and thus of the wanted signal; V
wanted = 100 dBV; funwanted = fwanted + 5.5 MHz.
3) Local oscillator FM modulation resulting from I
2C communication is measured at the IF output using a
modulation analyzer with a peak to peak detector ((P
+ +P-)/2) and a post detection filter 30 Hz - 200 kHz. The
I
2C messages are sent to the tuner in such a way that the tuner is addressed but the content of the PLL registers
are not altered. The refresh interval between each data set shall be 20 ms to 1s.
4) This is the level of the RF signal (100% amplitude modulated with 11.89 kHz) that causes a 750 Hz frequency
deviation on the oscillator signal producing sidebands 30 dB below the level of the oscillator signal.
5) Channel S02 beat is the interfering product of f
RFpix, fIF and fOSC of channel S02, fBEAT = 37.35 MHz. The possible
mechanisms are f
OSC - 2 x fIF or 2 x fRFpix - fOSC.
6) Channel A-5 beat is the interfering product of f
RFpix, fIF and fOSC of channel A-5; fBEAT= 45.5 MHz. The possible
mechanisms are: f
OSC - 2 x fIF or 2 x fRFpix - fOSC.
7) Channel 6 beat is the interfering product of f
RFpix + fRFsnd - fOSC of channel 6 at 42 MHz.
8) The IF output signal stays stable within the range of the f
ref step for a low level RF input up to 120 dBV.
9) N+5 -1 MHz is defined as the input level of channel N+5, at frequency 1 MHz lower, causing FM sidebands
30 dB below the wanted carrier.
#
Parameter
Symbol
Limit Values
Unit Test Conditions
min.
typ.
max.
相關PDF資料
PDF描述
TUA6039F-2 3-BAND, VIDEO TUNER, QCC48
TUA6037F 3-BAND, VIDEO TUNER, QCC48
TUA6039 3-BAND, VIDEO TUNER, QCC48
TUA6039-2 3-BAND, VIDEO TUNER, QCC48
TUA6037 3-BAND, VIDEO TUNER, QCC48
相關代理商/技術參數
參數描述
TUA6036TXT 制造商:Infineon Technologies AG 功能描述:Tuners PAL/NTSC 863.25MHz 38-Pin TSSOP
TUA6037 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:3 Band Digital / Hybrid Tuner IC with integrated IF AGC amplifier
TUA6037F 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:3 Band Digital / Hybrid Tuner IC with integrated IF AGC amplifier
TUA6037FXT 制造商:Infineon Technologies AG 功能描述:Tuners PAL/NTSC 863.25MHz 48-Pin VQFN EP
TUA6039 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:3 Band Digital / Hybrid Tuner IC with integrated IF AGC amplifier