參數資料
型號: TWL1110GQE
廠商: TEXAS INSTRUMENTS INC
元件分類: 消費家電
英文描述: SPECIALTY CONSUMER CIRCUIT, PBGA80
封裝: PLASTIC, MICRO, BGA-80
文件頁數: 34/37頁
文件大?。?/td> 496K
代理商: TWL1110GQE
TWL1110
VOICE-BAND AUDIO PROCESSOR (VBAP
)
SLWS103 – NOVEMBER 2000
6
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
functional description (continued)
analog modulator
The transmit channel modulator is a third-order sigma-delta design.
transmit filter and PGA
The transmit filter is a digital filter designed to meet CCITT G.714 requirements. The device operates either in
the 15-bit linear or 8-bit companded
-law or in the A-law mode, which is selectable through the I2C interface.
The transmit PGA defaults to 0 dB.
sidetone
A portion of the transmitted audio is attenuated and fed back to the receive channel through the sidetone path.
The sidetone path defaults to the mute condition. The default gain of -12 dB is set in the sidetone control register.
The sidetone path can be enabled by writing to the power control register.
receive volume control
The receive volume control block acts as an attenuator with a range of –18 dB to 0 dB in 2-dB steps for control
of the receive channel volume. The receive volume control gain defaults to 0 dB.
receive filter and PGA
The receive filter is a digital filter that meets CCITT G.714 requirements with a high-pass filter that is selectable
through the I2C interface. The device operates either in the 15-bit linear or the 8-bit
-law or the A-law
companded mode, which is selectable through the I2C interface. The gain defaults to –4 dB, representing a
3-dBm level for a 32-
load impedance and the corresponding digital full scale PCMI code.
digital modulator and filter
The second-order digital modulator and filter convert the received digital PCM data to the analog output required
by the earphone interface.
earphone amplifiers
The analog signal can be routed to either of two earphone amplifiers, one with differential output (EAR1ON and
EAR1OP) and one with single-ended output (EAR2O). Clicks and pops are suppressed for EAR1 differential
output only.
tone generator
The tone generator provides generation of standard DTMF tones which are output to (1) the buzzer driver, as
a PDM signal, (2) the receive path DAC for outputting through the earphone, or (3) as PCMO data. The integer
value is loaded into one of two 8-bit registers, the high-tone register (04), or the low-tone register (05) (see the
Register Map Addressing section). The tone output is 2 dB higher when applied to the high tone register (04).
The high DTMF tones must be applied to the high-tone register, and the low DTMF tones to the low-tone register.
The tone signals can be generated with 3 different resolutions at
F= 7.8125 Hz, 15.625 Hz, and 31.250 Hz.
The resolution option can be selected by setting the register (06).
analog mux
The analog switch can be used to source an analog signal to two different loads. The output can be reselected
by setting the auxiliary register (06).
相關PDF資料
PDF描述
TWL1110PBSR SPECIALTY CONSUMER CIRCUIT, PQFP32
TWL1110GQER SPECIALTY CONSUMER CIRCUIT, PBGA80
TWL1110PBS SPECIALTY CONSUMER CIRCUIT, PQFP32
TWL2213CAPFBR 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQFP48
TWL2214CAGQER 1-CHANNEL POWER SUPPLY SUPPORT CKT, PBGA48
相關代理商/技術參數
參數描述
TWL1110GQER 制造商:Texas Instruments 功能描述:VOICE BAND AUD PROCESSOR 80BGA MICROSTAR JUNIOR - Tape and Reel
TWL1110PBS 制造商:Rochester Electronics LLC 功能描述:- Bulk
TWL1110PBSR 制造商:Rochester Electronics LLC 功能描述:- Bulk
TWL1110TQFP 制造商:TI 制造商全稱:Texas Instruments 功能描述:VOICE-BAND AUDIO PROCESSOR VBAPE
TWL1200 制造商:TI 制造商全稱:Texas Instruments 功能描述:SDIO, UART, AND AUDIO VOLTAGE-TRANSLATION TRANSCEIVER