- 您現在的位置：買賣IC網 > PDF目錄379493 > UPD17201A (NEC Corp.) 4-BIT SINGLE-CHIP MICROCONTROLLER WITH LCD CONTROLLER/DRIVER AND A/D CONVERTER FOR INFRARED REMOTE CONTROL TRANSMITTERS PDF資料下載
參數資料
| 型號： | UPD17201A |
| 廠商： | NEC Corp. |
| 英文描述： | 4-BIT SINGLE-CHIP MICROCONTROLLER WITH LCD CONTROLLER/DRIVER AND A/D CONVERTER FOR INFRARED REMOTE CONTROL TRANSMITTERS |
| 中文描述： | 4位單片機與LCD控制器/驅動器和A / D轉換器紅外遙控遞質 |
| 文件頁數： | 54/120頁 |
| 文件大小： | 516K |
| 代理商： | UPD17201A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁當前第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁
μ
PD17201A, 17207
54
10. SERIAL INTERFACE
Serial interface consists of an 8-bit shift register, a 4-bit shift mode register, and a 3-bit counter, and transmits data
in series to and from the bus.
10.1
SERIAL INTERFACE FUNCTION
10.1.1
8-bit Data Transfer in Synchronization with Clocks (Simultaneous transmission and reception)
Input and output of serial data on serial interface is controlled by the serial clock (SCK) signal. At the falling edge
of the SCK signal, the most significant bit of the shift register is output from the SO pin (pin 59; also used as P1A
1
).
At the rising edge of the SCK signal, the contents of the shift register are shifted left by one bit and, at the same time,
data input via the SI pin (pin 60; also used as P1A
2
) is set in the least significant bit of the shift register.
The 3-bit counter counts serial clock pulses. Each time the counter counts eight clock pulses (each time serial
data of 8 bits is transferred), the IRQSIO flag (bit 3, address 3BH) of the register file is turned on (“1”) to make an
interrupt request.
10.1.2
8-bit Data Reception in Synchronism with Clocks (High-impedance SO output)
This operation is basically the same as the above operation except that the SI pin (pin 59; also used as P1A
1
) goes
into a high-impedance state and does not output serial data. Therefore, the SO pin can be used as a port (P1A
1
).
10.2
SERIAL INTERFACE OPERATION
10.2.1
Serial Interface Operation Modes
P1A
2
/SI (pin 60), P1A
1
/SO (pin 59), and P1A
0
/SCK (pin 58) are placed in Serial Interface mode when the SIOEN
flag (bit 0, address 23H) of the register file is turned on (“1”). These pins can be used as port pins when the SIOEN
flag is off (“0”). As this operation mode disables transfer of serial data, the shift register can be used as an 8-bit register.
10.2.2
Serial Operation Mode
The serial operation mode is determined by the status of the SIOHIZ flag (bit 2, address 22H) of the register file.
When this flag is off (“0”), a clock-synchronous 8-bit transmission/reception mode is set. When this flag is on (“1”),
a clock-synchronous 8-bit reception mode is set. Figure 10-1 shows shift timing waveforms. The only difference
between these two modes is whether the SO pin (pin 59; also used as P1A
1
) goes into a high-impedance state.
In transmission of serial data, data to be transmitted is set in the shift register SIOSFR (peripheral address 01H)
via the data buffer (DBF) by an PUT instruction, and the SIOTS flag (bit3, address 22H) of the register file is turned
on (“1”). Thus serial data trasfer starts. When 8 bits of data are transferred, the SIOTS flag is automatically turned
off (“0”) and the IRQSIO flag (bit 3, address 3BH) of the register file is turned on (“1”) to generate an interrupt. If
generation of an interrupt is disabled, the end of transfer can be indicated by the SIOTS and IRQSIO flags.
Reception of serial data is basically the same as the transmission of serial data except that data is output from
the SO pin.
The
μ
PD17207 supports four kinds of clock signals (three internal clocks and one external clock) to be selected
as the serial clock source. These clock signals are selected by SIOCK1 (bit 1, address 22H) and SIOCK0 (bit 0,
address 22H) of the register file.
If one of the three internal clock signals is selected as the serial clock source, it is supplied to serial interface when
the SIOTS flag turns on (“1”). The clock controls input/output of serial data and is output from the SCK pin (pin 58;
also used as P1A0). When eight clock pulses are supplied to the serial interface, the SIOTS flag is automatically turned
off (“0”) and the supply of clock pulses to the serial interface is stopped. Then, the SCK pin is held high. At this time,
the IRQSIO flag (bit 3, address 3BH) of the register file is turned on (“1”).
相關PDF資料 |
PDF描述 |
|---|---|
| UPD17201AGF | 4-BIT SINGLE-CHIP MICROCONTROLLER WITH LCD CONTROLLER/DRIVER AND A/D CONVERTER FOR INFRARED REMOTE CONTROL TRANSMITTERS |
| UPD17207 | 4-BIT SINGLE-CHIP MICROCONTROLLER WITH LCD CONTROLLER/DRIVER AND A/D CONVERTER FOR INFRARED REMOTE CONTROL TRANSMITTERS |
| UPD17207GF | 4-BIT SINGLE-CHIP MICROCONTROLLER WITH LCD CONTROLLER/DRIVER AND A/D CONVERTER FOR INFRARED REMOTE CONTROL TRANSMITTERS |
| UPD17202AGF-011 | Circular Connector; No. of Contacts:56; Series:MS27467; Body Material:Aluminum; Connecting Termination:Crimp; Connector Shell Size:25; Circular Contact Gender:Socket; Circular Shell Style:Straight Plug; Insert Arrangement:25-4 RoHS Compliant: No |
| UPD17202AGF-011-3BE | Circular Connector; No. of Contacts:56; Series:MS27467; Body Material:Aluminum; Connecting Termination:Crimp; Connector Shell Size:25; Circular Contact Gender:Pin; Circular Shell Style:Straight Plug; Insert Arrangement:25-4 RoHS Compliant: No |
相關代理商/技術參數 |
參數描述 |
|---|---|
| UPD17201AGF | 制造商:NEC 制造商全稱:NEC 功能描述:4-BIT SINGLE-CHIP MICROCONTROLLER WITH LCD CONTROLLER/DRIVER AND A/D CONVERTER FOR INFRARED REMOTE CONTROL TRANSMITTERS |
| UPD17201AGF-XXX-3B9 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:4-Bit Microcontroller |
| UPD17202A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:UPD17202AGF-011 Preliminary Data Sheet | Data Sheet[05/1997] |
| UPD17202AGF-011 | 制造商:NEC 制造商全稱:NEC 功能描述:4-BIT SINGLE-CHIP MICROCONTROLLER WITH LCD CONTROLLER/DRIVER AND KEY SCAN CIRCUIT FOR FPC FRONT PANEL CONTROLLER |
| UPD17202AGF-011-3BE | 制造商:NEC 制造商全稱:NEC 功能描述:4-BIT SINGLE-CHIP MICROCONTROLLER WITH LCD CONTROLLER/DRIVER AND KEY SCAN CIRCUIT FOR FPC FRONT PANEL CONTROLLER |
發布緊急采購，3分鐘左右您將得到回復。