- 您現在的位置：買賣IC網 > PDF目錄376424 > UPD17245MC-xxx-5A4 (NEC Corp.) 4-BIT SINGLE-CHIP MICROCONTROLLERS FOR SMALL GENERAL-PURPOSE INFRARED REMOTE CONTROL TRANSMITTERS PDF資料下載
參數資料
| 型號： | UPD17245MC-xxx-5A4 |
| 廠商： | NEC Corp. |
| 英文描述： | 4-BIT SINGLE-CHIP MICROCONTROLLERS FOR SMALL GENERAL-PURPOSE INFRARED REMOTE CONTROL TRANSMITTERS |
| 中文描述： | 4位單片微控制器的小型通用兩用紅外遙控遞質 |
| 文件頁數： | 34/102頁 |
| 文件大?。?/td> | 461K |
| 代理商： | UPD17245MC-XXX-5A4 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁當前第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁
34
Data Sheet U15002EJ1V0DS
μ
PD17240, 17241, 17242, 17243, 17244, 17245, 17246
3.
PORTS
3.1
Port 0A (P0A
0
to P0A
3
)
This is a 4-bit input port. Data is read using port register P0A (address 70H of BANK0). This port is a CMOS input
port with a pull-up resistor, and can be used as the key return input lines of a key matrix.
In the standby mode, the standby status is released when a low level is input to at least one of these pins.
3.2
Port 0B (P0B
0
to P0B
3
)
This is a 4-bit I/O port which can be set to the input or output mode in 1-bit units by using P0BBIO (address 26H)
of the register file.
In the input mode, each bit of this port serves as a CMOS input pin with a pull-up resistor and can be used as a
key return input line of a key matrix. In the standby mode, the standby status is released when a low level is input
to at least one of these pins.
In the output mode, these pins serve as N-ch open-drain output pins and can be used as the key source lines of
a key matrix.
The data input to this port can be read or the data output from this port can be set by using the P0B register (address
71H of BANK0). When this port is read in the output mode, the contents of the output latch are read.
In the input mode, a pull-up resistor of 200 k
is connected to each bit of this port. In the output mode, the pull-
up resistor is disconnected.
After reset, this port is set to the input mode.
3.3
Port 0C (P0C
0
to P0C
3
)
This is a 4-bit I/O port which can be set to the input or output mode in 4-bit units (group I/O) by using P0CDGIO
(bit 2 of address 37H) of the register file.
In the input mode, each bit of this port serves as a CMOS input pin with a pull-up resistor and can be used as a
key return input line of a key matrix. In the standby mode, the standby status is released when a low level is input
to at least one of these pins.
In the output mode, these pins serve as N-ch open-drain output pins and can be used as the key source lines of
a key matrix.
The data input to this port can be read or the data output from this port can be set by using the P0C register (address
72H of BANK0). When this port is read in the output mode, the contents of the output latch are read.
In the input mode, a pull-up resistor of 200 k
is connected to each bit of this port. In the output mode, the pull-
up resistor is disconnected.
After reset, this port is set to the output mode and outputs a low level.
3.4
Port 0D (P0D
0
to P0D
3
)
This is a 4-bit I/O port which can be set to the input or output mode in 4-bit units (group I/O) by using P0CDGIO
(bit 3 of address 37H) of the register file.
In the input mode, each bit of this port serves as a CMOS input pin with a pull-up resistor and can be used as a
key return input line of a key matrix. In the standby mode, the standby status is released when a low level is input
to at least one of these pins.
In the output mode, these pins serve as N-ch open-drain output pins and can be used as the key source lines of
a key matrix.
The data input to this port can be read or the data output from this port can be set by using the P0D register (address
73H of BANK0). When this port is read in the output mode, the contents of the output latch are read.
In the input mode, a pull-up resistor of 200 k
is connected to each bit of this port. In the output mode, the pull-
up resistor is disconnected.
After reset, this port is set to the output mode and outputs a low level.
相關PDF資料 |
PDF描述 |
|---|---|
| UPD17246MC-xxx-5A4 | 4-BIT SINGLE-CHIP MICROCONTROLLERS FOR SMALL GENERAL-PURPOSE INFRARED REMOTE CONTROL TRANSMITTERS |
| UPD1724x | 4-BIT SINGLE-CHIP MICROCONTROLLERS FOR SMALL GENERAL-PURPOSE INFRARED REMOTE CONTROL TRANSMITTERS |
| UPD17709GC | 4-BIT SINGLE-CHIP MICROCONTROLLERS WITH DEDICATED HARDWARE FOR DIGITAL TUNING SYSTEM |
| UPD17707GC | 4-BIT SINGLE-CHIP MICROCONTROLLERS WITH DEDICATED HARDWARE FOR DIGITAL TUNING SYSTEM |
| UPD17704 | 4-BIT SINGLE-CHIP MICROCONTROLLERS WITH DEDICATED HARDWARE FOR DIGITAL TUNING SYSTEM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| UPD17246 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microcontrollers for Remote Controllers Pamphlet | Pamphlet[11/2002] |
| UPD17246MC-XXX-5A4 | 制造商:NEC 制造商全稱:NEC 功能描述:4-BIT SINGLE-CHIP MICROCONTROLLERS FOR SMALL GENERAL-PURPOSE INFRARED REMOTE CONTROL TRANSMITTERS |
| UPD1724X | 制造商:NEC 制造商全稱:NEC 功能描述:4-BIT SINGLE-CHIP MICROCONTROLLERS FOR SMALL GENERAL-PURPOSE INFRARED REMOTE CONTROL TRANSMITTERS |
| UPD17704 | 制造商:NEC 制造商全稱:NEC 功能描述:4-BIT SINGLE-CHIP MICROCONTROLLERS WITH DEDICATED HARDWARE FOR DIGITAL TUNING SYSTEM |
| UPD17704A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:UPD17704A.17705A.17707A.17708A.17709A Data Sheet | Data Sheet[10/2001] |
發布緊急采購，3分鐘左右您將得到回復。