- 您現在的位置：買賣IC網 > PDF目錄371258 > X4645S8 CPU Supervisor with 64K EEPROM PDF資料下載
參數資料
| 型號： | X4645S8 |
| 元件分類： | EEPROM |
| 英文描述： | CPU Supervisor with 64K EEPROM |
| 中文描述： | CPU監控與64K的EEPROM的 |
| 文件頁數： | 9/22頁 |
| 文件大?。?/td> | 408K |
| 代理商： | X4645S8 |
X4643/5 – Preliminary Information
Characteristics subject to change without notice.
9 of 22
REV 1.26 4/30/02
www.xicor.com
Serial Write Operations
B
YTE
W
RITE
For a write operation, the device requires the Slave
Address Byte and a Word Address Byte. This gives the
master access to any one of the words in the array. After
receipt of the Word Address Byte, the device responds
with an acknowledge, and awaits the next eight bits of
data. After receiving the 8 bits of the Data Byte, the
device again responds with an acknowledge. The mas-
ter then terminates the transfer by generating a stop
condition, at which time the device begins the internal
write cycle to the nonvolatile memory. During this inter-
nal write cycle, the device inputs are disabled, so the
device will not respond to any requests from the master.
The SDA output is at high impedance. See Figure 8.
Figure 8. Byte Write Sequence
S
t
a
r
S
t
o
Slave
Word Address
Byte 0
Data
A
C
K
A
C
K
A
C
K
SDA Bus
Signals from
the Slave
Signals from
the Master
0
Word Address
Byte 1
A
C
K
0
1
0
1
A write to a protected block of memory will suppress
the acknowledge bit.
Page Write
The device is capable of a page write operation. It is
initiated in the same manner as the byte write opera-
tion; but instead of terminating the write cycle after the
first data byte is transferred, the master can transmit
an unlimited number of 8-bit bytes. After the receipt of
each byte, the device will respond with an acknowl-
edge, and the address is internally incremented by
one. The page address remains constant. When the
counter reaches the end of the page, it “rolls over” and
goes back to ‘0’ on the same page. This means that the
master can write 64-bytes to the page starting at any
location on that page. If the master begins writing at
location 60, and loads 12-bytes, then the first 4-bytes
are written to locations 60 through 63, and the last
8-bytes are written to locations 0 through 7. After-
wards, the address counter would point to location 8 of
the page that was just written. If the master supplies
more than 64-bytes of data, then new data over-writes
the previous data, one byte at a time.
Figure 9. Page Write Operation
S
t
a
r
S
t
o
Slave
Word Ad-
Data
A
C
A
C
A
C
SDA Bus
Signals from
the Slave
Signals from
the Master
0
Data
A
C
(1 < n < 64)
Word Ad-
A
C
1
0
1
0
相關PDF資料 |
PDF描述 |
|---|---|
| X4645S8-2.7 | CPU Supervisor with 64K EEPROM |
| X4645S8-2.7A | CPU Supervisor with 64K EEPROM |
| X4645S8-4.5A | CPU Supervisor with 64K EEPROM |
| X4645S8I | CPU Supervisor with 64K EEPROM |
| X4645S8I-2.7 | CPU Supervisor with 64K EEPROM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| X4645S8-2.7 | 功能描述:IC CPU SUPRV 64K EE RST HI 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:1 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:開路漏極或開路集電極 復位:低有效 復位超時:標準傳輸延遲為 60 µs 電壓 - 閥值:3V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SC-74A，SOT-753 供應商設備封裝:SOT-23-5 包裝:Digi-Reel® 其它名稱:LM8364BALMF30DKR |
| X4645S8-2.7A | 功能描述:IC SUPERVISOR CPU 64K EE 8-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:100 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:- 復位:低有效 復位超時:最小為 100 ms 電壓 - 閥值:4.38V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:8-TSSOP 包裝:管件 |
| X4645S8-4.5A | 功能描述:IC SUPERVISOR CPU 64K EE 8-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:100 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:- 復位:低有效 復位超時:最小為 100 ms 電壓 - 閥值:4.38V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:8-TSSOP 包裝:管件 |
| X4645S8I | 功能描述:IC CPU SUPRV 64K EE RST HI 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:1 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:開路漏極或開路集電極 復位:低有效 復位超時:標準傳輸延遲為 60 µs 電壓 - 閥值:3V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SC-74A，SOT-753 供應商設備封裝:SOT-23-5 包裝:Digi-Reel® 其它名稱:LM8364BALMF30DKR |
| X4645S8I-2.7 | 功能描述:IC CPU SUPRV 64K EE RST HI 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:1 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:開路漏極或開路集電極 復位:低有效 復位超時:標準傳輸延遲為 60 µs 電壓 - 閥值:3V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SC-74A，SOT-753 供應商設備封裝:SOT-23-5 包裝:Digi-Reel® 其它名稱:LM8364BALMF30DKR |
發布緊急采購，3分鐘左右您將得到回復。