- 您現在的位置：買賣IC網 > PDF目錄371342 > XM28C020I-12 5 Volt, Byte Alterable E2PROM PDF資料下載
參數資料
| 型號： | XM28C020I-12 |
| 英文描述： | 5 Volt, Byte Alterable E2PROM |
| 中文描述： | 5伏，可變E2PROM的字節 |
| 文件頁數： | 9/16頁 |
| 文件大小： | 74K |
| 代理商： | XM28C020I-12 |
XM28C020
9
SYSTEM CONSIDERATIONS
Because the XM28C020 is frequently used in large
memory arrays it is provided with a two line control
architecture for both read and write operations. Proper
usage can provide the lowest possible power dissipation
and eliminate the possibility of contention where mul-
tiple I/O pins share the same bus.
To gain the most benefit it is recommended that
CE
be
decoded from the address bus and be used as the
primary device selection input. Both
OE
and
WE
would
then be common among all devices in the array. For a
read operation this assures that all deselected devices
are in their standby mode and that only the selected
device(s) is outputting data on the bus.
Because the XM28C020 has two power modes, standby
and active, proper decoupling of the memory array is of
prime concern. Enabling
CE
will cause transient current
spikes. The magnitude of these spikes is dependent on
the output capacitive loading of the I/Os. Therefore, the
larger the array sharing a common bus, the larger the
transient spikes. The voltage peaks associated with the
current transients can be suppressed by the proper
selection and placement of decoupling capacitors. As a
minimum, it is recommended that a 0.1
μ
F high fre-
quency ceramic capacitor be used between V
CC
and
V
SS
at each device. Depending on the size of the array,
the value of the capacitor may have to be larger.
In addition, it is recommended that a 4.7
μ
F electrolytic
bulk capacitor be place between V
CC
and V
SS
for every
two modules employed in the array. This bulk capacitor
is employed to overcome the voltage droop caused by
the inductive effects of the PC board traces.
相關PDF資料 |
PDF描述 |
|---|---|
| XM28C020PM-20 | 5 Volt, Byte Alterable E2PROM |
| XM28C020PM-25 | 5 Volt, Byte Alterable E2PROM |
| XM28C020-12 | 5 Volt, Byte Alterable E2PROM |
| XM28C020-15 | 5 Volt, Byte Alterable E2PROM |
| XM28C020-20 | 5 Volt, Byte Alterable E2PROM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XM28C020I-15 | 制造商:XICOR 制造商全稱:Xicor Inc. 功能描述:5 Volt, Byte Alterable E2PROM |
| XM28C020I-20 | 制造商:XICOR 制造商全稱:Xicor Inc. 功能描述:5 Volt, Byte Alterable E2PROM |
| XM28C020I-25 | 制造商:XICOR 制造商全稱:Xicor Inc. 功能描述:5 Volt, Byte Alterable E2PROM |
| XM28C020M-12 | 制造商:XICOR 制造商全稱:Xicor Inc. 功能描述:5 Volt, Byte Alterable E2PROM |
| XM28C020M-15 | 制造商:XICOR 制造商全稱:Xicor Inc. 功能描述:5 Volt, Byte Alterable E2PROM |
發布緊急采購，3分鐘左右您將得到回復。