參數資料
型號: XR16C2850CM48
廠商: EXAR CORP
元件分類: 微控制器/微處理器
英文描述: 3.3V AND 5V DUART WITH 128-BYTE FIFO
中文描述: 2 CHANNEL(S), 6.25M bps, SERIAL COMM CONTROLLER, PQFP48
封裝: 7 X 7 MM, 1 MM HEIGHT, TQFP-48
文件頁數: 11/43頁
文件大小: 611K
代理商: XR16C2850CM48
XR16C2850
REV. 2.0.0
3.3V AND 5V DUART WITH 128-BYTE FIFO
á
11
2.10 T
RANSMITTER
The transmitter section comprises of an 8-bit Transmit
Shift Register (TSR) and 128 bytes of FIFO which in-
cludes a byte-wide Transmit Holding Register (THR).
TSR shifts out every data bit with the 16X/8X internal
clock. A bit time is 16 (8) clock periods (see CLK8/16
pin description). The transmitter sends the start-bit
followed by the number of data bits, inserts the proper
parity-bit if enabled, and adds the stop-bit(s). The sta-
tus of the FIFO and TSR are reported in the Line Sta-
tus Register (LSR bit-5 and bit-6).
2.10.1 Transmit Holding Register (THR) - Write
Only
The transmit holding register is an 8-bit register pro-
viding a data interface to the host processor. The host
writes transmit data byte to the THR to be converted
into a serial data stream including start-bit, data bits,
parity-bit and stop-bit(s). The least-significant-bit (Bit-
0) becomes first data bit to go out. The THR is the in-
put register to the transmit FIFO of 128 bytes when
FIFO operation is enabled by FCR bit-0. Every time a
write operation is made to the THR, the FIFO data
pointer is automatically bumped to the next sequential
data location.
2.10.2 Transmitter Operation in non-FIFO Mode
The host loads transmit data to THR one character at
a time. The THR empty flag (LSR bit-5) is set when
the data byte is transferred to TSR. THR flag can
generate a transmit empty interrupt (ISR bit-1) when
it is enabled by IER bit-1. The TSR flag (LSR bit-6) is
set when TSR becomes completely empty.
2.10.3 Transmitter Operation in FIFO Mode
The host may fill the transmit FIFO with up to 128
bytes of transmit data. The THR empty flag (LSR bit-
5) is set whenever the FIFO is empty. The THR empty
flag can generate a transmit empty interrupt (ISR bit-
1) when the amount of data in the FIFO falls below its
programmed trigger level. The transmit empty inter-
rupt is enabled by IER bit-1. The TSR flag (LSR bit-6)
is set when TSR/FIFO becomes empty.
F
IGURE
7. T
RANSMITTER
O
PERATION
IN
NON
-FIFO M
ODE
Transmit
Holding
Register
(THR)
Transmit Shift Register (TSR)
Data
Byte
L
S
B
M
S
B
THR Interrupt (ISR bit-1)
Enabled by IER bit-1
TXNOFIFO1
16X or 8X
Clock
(EMSR Bit-7)
F
IGURE
8. T
RANSMITTER
O
PERATION
IN
FIFO
AND
F
LOW
C
ONTROL
M
ODE
Transmit Data Shift Register
(TSR)
Transmit
Data Byte
THR Interrupt (ISR bit-1) falls
below the programmed Trigger
Level and then when becomes
empty. FIFO is Enabled by FCR
bit-0=1
Transmit
FIFO
16X or 8X
Clock
Auto CTS Flow Control (CTS# pin)
Auto Software Flow Control
Flow Control Characters
(Xoff1/2 and Xon1/2 Reg.
TXFIFO1
相關PDF資料
PDF描述
XR16C2850CP40 3.3V AND 5V DUART WITH 128-BYTE FIFO
XR16C2850IJ44 3.3V AND 5V DUART WITH 128-BYTE FIFO
XR16C2850IM48 3.3V AND 5V DUART WITH 128-BYTE FIFO
XR16C2850IP40 3.3V AND 5V DUART WITH 128-BYTE FIFO
XR16C2850CJ DUAL UART WITH 128-byte FIFO’s AND RS-485 HALF DUPLEX CONTROL
相關代理商/技術參數
參數描述
XR16C2850CM-F 功能描述:UART 接口集成電路 2.97V-5.5V 128B FIFO temp 0C to 70C; UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
XR16C2850CMTR-F 制造商:Exar Corporation 功能描述:UART 2-CH 128Byte FIFO 3.3V/5V 48-Pin TQFP T/R 制造商:Exar Corporation 功能描述:XR16C2850CMTR-F
XR16C2850CP 制造商:EXAR 制造商全稱:EXAR 功能描述:DUAL UART WITH 128-byte FIFO’s AND RS-485 HALF DUPLEX CONTROL
XR16C2850CP40 制造商:EXAR 制造商全稱:EXAR 功能描述:3.3V AND 5V DUART WITH 128-BYTE FIFO
XR16C2850IJ 制造商:Exar Corporation 功能描述:UART 2-CH 128Byte FIFO 3.3V/5V 44-Pin PLCC 制造商:Rochester Electronics LLC 功能描述: