- 您現在的位置：買賣IC網 > PDF目錄376459 > XRD98L23 (Exar Corporation) 8-Bit, High-speed Linear CIS/CCD Sensor Signal Processor with Serial Control(8位高速線性CIS/CCD傳感信號處理器（帶串行控制）) PDF資料下載
參數資料
| 型號： | XRD98L23 |
| 廠商： | Exar Corporation |
| 英文描述： | 8-Bit, High-speed Linear CIS/CCD Sensor Signal Processor with Serial Control(8位高速線性CIS/CCD傳感信號處理器（帶串行控制）) |
| 中文描述： | 8位高速線性獨聯體/串行控制與CCD傳感器信號處理器（8位高速線性獨聯體/防治荒漠化公約傳感信號處理器（帶串行控制）） |
| 文件頁數： | 27/33頁 |
| 文件大小： | 205K |
| 代理商： | XRD98L23 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁當前第27頁第28頁第29頁第30頁第31頁第32頁第33頁
XRD98L23
27
Rev. P2.00
Preliminary
Mode 2. DC Coupled
Typical CCDs have outputs with black references.
Therefore, DC Coupled is not recommended for CCD
applications.
Offset Control DAC
The offset DAC is controlled by 8-bits. The offset range
is 480 mV ranging from -120 mV to +380 mV (when DB5
is set to 0) and -240 mV to +240 mV (when DB5 is set
to 1). Therefore, the resolution of the 8-bit offset DAC
is 1.88 mV. However, the XRD98L23 has +/- 60 mV
reserved for internal offsets. Therefore, the effective
range for adjusting for CIS offsets or black reference is
600 mV. The offset adjustment is used primarily to
correct for the difference between the black level of the
image sensor and the bottom ladder reference voltage
(VRB) of the ADC. By adjusting the black level to
correspond to VRB, the entire range of the ADC can be
used.
If the offset of the CIS output is greater than 500 mV an
external reference can be applied to VDCEXT. The
external reference can be used to adjust for large
offsets only when the internal mode is configured
through the serial port.
Since the offset DAC adjustment is done before the
gain stage, it is gain-dependent. For example, if the
gain needs to be changed between lines (red to blue,
etc.), the offset is calibrated before the signal passes
through the PGA.
PGA (Programmable Gain Amplifier) DAC
The gain of the input waveform is controlled by a 6-Bit
PGA. The PGA is used along with the offset DAC for
the purpose of using the entire range of the ADC. The
PGA has a linear gain from 1 to 10. Figure 20, is a plot
of the transfer curve for the PGA gain.
PGA GAIN TRANSFER CURVE
GAIN 1 - 10
1
2
3
4
5
6
7
8
9
10
0
10
20
30
40
50
60
CODE
G
Figure 21. Transfer Curve for the 6-Bit PGA
After the signal is level shifted to correspond with the
bottom ladder reference voltage, the system can be
calibrated such that a white video pixel can represent
the top ladder reference voltage to the ADC. This allows
for a full scale conversion maximizing the resolution of
the ADC.
Analog to Digital Converter
The ADC is an 8-bit, 10 MSPS analog-to-digital con-
verter for high speed and high accuracy. The ADC uses
a subranging architecture to maintain low power con-
sumption at high conversion rates. The output of the
ADC is on 8-bit databus. The 8-bit databus supports
6x6 or 8x4 output data. ADCCLK samples the input on
its falling edge. After the input is sampled, the MSB is
latched to the output drivers. On the rising edge of the
ADCCLK, the LSB is latched to the output drivers. The
output needs to be demultiplexed with external circuitry
or a digital ASIC. There is an 8 clock cycle latency
(Config 00, 11) or 6 pixel count latency (Config 01, 10)
for the analog-to-digital converter.
The V
and V
reference voltages for the ADC are
generated internally, unless the external V
is se-
lected. In the external V
mode, the V
voltage is set
through the VREF+ pin. This allows the user to select
the dynamic range of the ADC.
相關PDF資料 |
PDF描述 |
|---|---|
| XRD98L62ACV | CCD Image Digitizers with CDS, PGA and 12-Bit A/D |
| XRD98L62 | CCD Image Digitizers with CDA，PGS and 12-Bit A/D(CCD圖像數字轉換器（帶CDA，PGS和12位A/D轉換器）) |
| XRDAN28 | Frequency Response Effects of Overampling and Averaging on A/D Output Data |
| XRDAN29 | Criteria for Accurate Sampling of Analog Signals |
| XRDAN30 | CMOS Current Output D/A Converter Design Concepts for Wide Bandwidth Applications |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XRD98L23ACD | 功能描述:視頻模擬/數字化轉換器集成電路 8-Bit Linear CIS/CCD Sensor Signal Prcssr RoHS:否 制造商:Texas Instruments 輸入信號類型:Differential 轉換器數量:1 ADC 輸入端數量:4 轉換速率:3 Gbps 分辨率:8 bit 結構: 輸入電壓:3.3 V 接口類型:SPI 信噪比: 電壓參考: 電源電壓-最大:3.45 V 電源電壓-最小:3.15 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:TCSP-48 封裝:Reel |
| XRD98L23ACD-F | 功能描述:視頻模擬/數字化轉換器集成電路 RoHS:否 制造商:Texas Instruments 輸入信號類型:Differential 轉換器數量:1 ADC 輸入端數量:4 轉換速率:3 Gbps 分辨率:8 bit 結構: 輸入電壓:3.3 V 接口類型:SPI 信噪比: 電壓參考: 電源電壓-最大:3.45 V 電源電壓-最小:3.15 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:TCSP-48 封裝:Reel |
| XRD98L23ACDTR-F | 功能描述:視頻模擬/數字化轉換器集成電路 RoHS:否 制造商:Texas Instruments 輸入信號類型:Differential 轉換器數量:1 ADC 輸入端數量:4 轉換速率:3 Gbps 分辨率:8 bit 結構: 輸入電壓:3.3 V 接口類型:SPI 信噪比: 電壓參考: 電源電壓-最大:3.45 V 電源電壓-最小:3.15 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:TCSP-48 封裝:Reel |
| XRD98L23ACU | 功能描述:視頻模擬/數字化轉換器集成電路 RoHS:否 制造商:Texas Instruments 輸入信號類型:Differential 轉換器數量:1 ADC 輸入端數量:4 轉換速率:3 Gbps 分辨率:8 bit 結構: 輸入電壓:3.3 V 接口類型:SPI 信噪比: 電壓參考: 電源電壓-最大:3.45 V 電源電壓-最小:3.15 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:TCSP-48 封裝:Reel |
| XRD98L23ACU-F | 功能描述:視頻模擬/數字化轉換器集成電路 RoHS:否 制造商:Texas Instruments 輸入信號類型:Differential 轉換器數量:1 ADC 輸入端數量:4 轉換速率:3 Gbps 分辨率:8 bit 結構: 輸入電壓:3.3 V 接口類型:SPI 信噪比: 電壓參考: 電源電壓-最大:3.45 V 電源電壓-最小:3.15 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:TCSP-48 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。