- 您現在的位置：買賣IC網 > PDF目錄1976 > XRT73L04BIV-F (Exar Corporation)IC LIU E3/DS3/STS-1 4CH 144LQFP PDF資料下載
參數資料
| 型號： | XRT73L04BIV-F |
| 廠商： | Exar Corporation |
| 文件頁數： | 49/64頁 |
| 文件大小： | 0K |
| 描述： | IC LIU E3/DS3/STS-1 4CH 144LQFP |
| 標準包裝： | 60 |
| 類型： | 線路接口裝置（LIU） |
| 驅動器/接收器數： | 4/4 |
| 規程： | DS3，E3，STS-1 |
| 電源電壓： | 3.135 V ~ 3.465 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 144-LQFP |
| 供應商設備封裝： | 144-LQFP（20x20） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁當前第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁
XRT73L04B
4 CHANNEL DS3/E3/STS-1 LINE INTERFACE UNIT
REV. 1.0.1
49
b. Operating in the Hardware Mode.
To configure Channel (n) to operate in the Digital Lo-
cal Loop-Back Mode, pull both the LLB input pin and
the RLB input pin "High".
4.3
THE REMOTE LOOP-BACK MODE
When a given channel is configured to operate in the
Remote Loop-Back Mode, the channel ignores any
signals that are input to the TPData and TNData input
pins. The channel receives the incoming line signal
via the RTIP and RRing input pins. This data is pro-
cessed through the entire Receive Section and is out-
put to the Receive Terminal Equipment via the RPOS,
RNEG and RxClk output pins. Additionally, this data
is also internally looped back into the Pulse-Shaping
block within the Transmit Section. At this point, this
data is routed through the remainder of the Transmit
Section of the channel and transmitted out onto the
line via the TTIP_(n) and TRing_(n) output pins.
Figure 35 illustrates the path that the data takes when
the chip is configured to operate in the Remote Loop-
Back Mode.
Configure a channel to operate in the Remote Loop-
Back Mode by employing either one of the following
two steps
a. Operating in the HOST Mode
To configure Channel (n) to operate in the Remote
Loop-Back Mode, write a "1" into the RLB bit-field,
and a "0" into the LLB bit-field, within Command Reg-
ister CR4.
b. Operating in the Hardware Mode
To configure Channel(n) to operate in the Remote
Loop-Back Mode, pull both the RLB_(n) input pin to
“High" and the LLB_(n) input pin to "Low".
FIGURE 35. THE REMOTE LOOP-BACK PATH, WITHIN A GIVEN CHANNEL
AGC/
Equalizer
Peak
Detector
LOS Detector
Slicer
Clock
Recovery
Data
Recovery
Invert
Loop MUX
HDB3/
B3ZS
Decoder
LOSTHR_(n)
SDI
SDO
SClk
CS/(SR/DR)
REGR
RTIP_(n)
RRing_(n)
REQEN_(n)
RxClk_(n)
RPOS_(n)
RNEG_(n)
LCV_(n)
RLOS_(n)
LLB_(n)
RLB_(n)
TAOS_(n)
TPData_(n)
TNData_(n)
TxClk_(n)
Notes: 1. (n) = 0, 1, 2, or 3 for respective Channels
2. Serial Processor Interface input pins are shared by the four Channels in HOST Mode and redefined in
Hardware Mode.
RLOL_(n) EXClk_(n)
Device
Monitor
MTIP_(n)
MRing_(n)
Transmit
Logic
Duty Cycle Adjust
TxLEV_(n)
TxOFF_(n)
DMO_(n)
TTIP_(n)
TRing_(n)
Pulse
Shaping
HDB3/
B3ZS
Encoder
Serial
Processor
Interface
Remote
Loop-Back Path
COMMAND REGISTER CR4-(n)
D4
D3
D2
D1
D0
X
STS-1/DS3_(n)
E3_(n)
LLB_(n)
RLB_(n)
XX
X
0
1
相關PDF資料 |
PDF描述 |
|---|---|
| XRT73L06IB-F | IC LIU E3/DS3/STS-1 6CH 217BGA |
| XRT73LC00AIV-F | IC LIU STS1/DS3/E3 SGL 44TQFP |
| XRT73LC03AIV-F | IC LIU E3/DS3/STS-1 3CH 120LQFP |
| XRT73LC04AIV-F | IC LIU E3/DS3/STS-1 4CH 144LQFP |
| XRT73R06IB-F | IC LIU E3/DS3/STS-1 6CH 217BGA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XRT73L06 | 制造商:EXAR 制造商全稱:EXAR 功能描述:SIX CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT |
| XRT73L06ES | 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| XRT73L06IB | 功能描述:外圍驅動器與原件 - PCI RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| XRT73L06IB-F | 功能描述:接口 - 專用 RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59 |
| XRT73L06IQ | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecomm/Datacomm |
發布緊急采購，3分鐘左右您將得到回復。