參數資料
型號： XRT73R06IB-F
廠商： Exar Corporation
文件頁數： 57/68頁
文件大小： 0K
描述： IC LIU E3/DS3/STS-1 6CH 217BGA
標準包裝： 126
類型： 線路接口裝置（LIU）
驅動器/接收器數： 6/6
規程： DS3，E3，STS-1
電源電壓： 3.135 V ~ 3.465 V
安裝類型： 表面貼裝
封裝/外殼： 217-BBGA
供應商設備封裝： 217-BGA（23x23）
包裝： 托盤
XRT73R06
á
REV. 1.0.0
SIX CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT
57
0x04 (ch 0)
0x14 (ch 1)
0x24 (ch 2)
0x34 (ch 3)
0x44 (ch 4)
0x54 (ch 5)
R/W
Transmit
Control
D0
TxLEV_n
This bit should be set when the transmitter is driving
a line greater than 225 feet in the DS3 or STS-1
modes. It is not active in E3 mode.
0
D1
TxCLKINV
_n
Set this bit to sample the data on TPOS/TNEG pins
on the rising edge of TxCLK.Default is to sample on
the falling edge of TxCLK.
0
D2
TAOS_n
This bit should be set to transmit a continuous “all
ones” data pattern. Timing will come from TxCLK if
available otherwise from channel refernce clock.
0
D3
Reserved
D4
INSPRBS_
n
This bit causes a single bit error to be inserted in the
transmitted PRBS pattern if the PRBS generator/
detector has been enabled.
0
D5
TxMON_n
When set, this bit enables the DMO circuit to moni-
tor its own channel’s transmit driver. Otherwise, it
uses the MTIP/MRING pins to monitor another
channel or device.
0
D7-D6
Reserved
0x05 (ch 0)
0x15 (ch 1)
0x25 (ch 2)
0x35 (ch 3)
0x45 (ch 4)
0x55 (ch 5)
R/W
Receive
Control
D0
REQEN_n
This bit enables the Receiver Equalizer. When set,
the equalizer boosts the high frequency components
of the signal to make up for cable losses.
NOTE: See section 5.01 for detailed description.
0
D1
RxMON_n
Set this bit to place the Receiver in the monitoring
mode. In this mode, it can process signals (at RTIP/
RRING) with 20dB of flat loss. This mode allows the
channel to act as monitor of aline without loading the
circuit.
0
D2
LOSMUT_
n
When set, the data on RPOS/RNEG is forced to
zero when LOS occurs. Thus any residual noise on
the line is not output as spurious data.
NOTE: If this bit has been set, it will remain set evan
after the LOS condition is cleared.
0
D3
RxCLKINV
_n
When this bit is set, RPOS and RNEG will change
on the falling edge of RCLK.Default is for the data to
change on the rising edge of RCLK and be sampled
by the terminal equipment on the falling edge of
RCLK.
0
D4
ALOSDIS_
n
This bit is set to disable the ALOS detector. This flag
and the DLOSDIS are normally used in diagnostic
mode. Normal operation of DS3 and STS-1 would
have ALOS disabled.
0
D5
DLOSDIS_
n
This bit disables the digital LOS detector. This would
normally be disabled in E3 mode as E3 is a function
of the level of the input.
0
D7-D6
Reserved
TABLE 18: REGISTER MAP DESCRIPTION - CHANNEL N
ADDRESS
(HEX)
TYPE
REGISTER
NAME
BIT#
SYMBOL
DESCRIPTION
DEFAULT
VALUE
相關PDF資料
PDF描述
XRT73R12IB-L IC LIU E3/DS3/STS-1 12CH 420TBGA
XRT75L00DIV-F IC LIU E3/DS3/STS-1 SGL 52TQFP
XRT75L00IV-F IC LIU E3/DS3/STS-1 SGL 52TQFP
XRT75L02DIV-F IC LIU E3/DS3/STS-1 2CH 100TQFP
XRT75L03DIV-F IC LIU E3/DS3/STS-1 3CH 128LQFP
相關代理商/技術參數
參數描述
XRT73R12 制造商:EXAR 制造商全稱:EXAR 功能描述:TWELVE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT
XRT73R12_07 制造商:EXAR 制造商全稱:EXAR 功能描述:TWELVE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT
XRT73R12_0710 制造商:EXAR 制造商全稱:EXAR 功能描述:TWELVE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT
XRT73R12ES 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
XRT73R12IB 功能描述:外圍驅動器與原件 - PCI RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*