參數資料
型號： XRT75VL00IVTR
廠商： Exar Corporation
文件頁數： 26/50頁
文件大?。?/td> 0K
描述： IC LIU E3/DS3/STS-1 1CH 52TQFP
標準包裝： 1,000
類型： 線路接口裝置（LIU）
驅動器/接收器數： 1/1
規程： DS3，E3，STS-1
電源電壓： 3.135 V ~ 3.465 V
安裝類型： 表面貼裝
封裝/外殼： 52-LQFP
供應商設備封裝： 52-TQFP（10x10）
包裝： 帶卷 (TR)
XRT75VL00
30
E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR
REV. 1.0.6
5.2
Clock and Data Recovery:
The Clock and Data Recovery Circuit extracts the embedded clock, from the sliced digital data stream and
provides the retimed data to the B3ZS (HDB3) decoder.
The Clock Recovery PLL can be in one of the following two modes:
TRAINING MODE:
In the absence of input signals at RTIP and RRing pins, or when the frequency difference between the
recovered line clock signal and the reference clock applied on the ExClk input pin exceed 0.5%, the clock
recovery unit enters into Training Mode and a Loss of Lock condition is declared by toggling RLOL output pin
“High” (in Hardware Mode) or setting the RLOL bit to “1” in the control registers (in Host Mode). Also, the clock
output on the RxClk pin is the same as the reference clock applied on ExClk pin.
DATA/CLOCK RECOVERY MODE:
In the presence of input line signals on the RTIP and RRing input pins and when the frequency difference
between the recovered clock signal and the reference clock signal is less than 0.5%, the clock that is output on
the RxClk out pin is the Recovered Clock signal.
5.3
B3ZS/HDB3 Decoder:
The decoder block takes the output from clock and data recovery block and decodes the B3ZS (for DS3 or
STS-1) or HDB3 (for E3) encoded line signal and detects any coding errors or excessive zeros in the data
stream.
Whenever the input signal violates the B3ZS or HDB3 coding sequence for bipolar violation or contains three
(for B3ZS) or four (for HDB3) or more consecutive zeros, an active “High” pulse is generated on the RLCV
output pins to indicate line code violation.
NOTE: In Single- Rail (NRZ) mode, the decoder is bypassed.
5.4
LOS (Loss of Signal) Detector:
5.4.1
DS3/STS-1 LOS Condition:
A Digital Loss of Signal (DLOS) condition occurs when a string of 175 ± 75 consecutive zeros occur on the line.
When the DLOS condition occurs, the DLOS bit is set to “1” in the status control register. DLOS condition is
cleared when the detected average pulse density is greater than 33% for 175 ± 75 pulses.
Analog Loss of Signal (ALOS) condition occurs when the amplitude of the incoming line signal is below the
threshold as shown in the Table 10.The status of the ALOS condition is reflected in the ALOS status control
register.
TABLE 9: INTERFERENCE MARGIN TEST RESULTS
MODE
CABLE LENGTH (ATTENUATION)
INTERFERENCE TOLERANCE
E3
0 dB
-14 dB
12 dB
-18 dB
DS3
0 feet
-17 dB
225 feet
-16 dB
450 feet
-16 dB
STS-1
0 feet
-16 dB
225 feet
-15 dB
450 feet
-15 dB
相關PDF資料
PDF描述
IDT7207L35P IC FIFO 16384X18 35NS 28DIP
VI-BNF-MX-B1 CONVERTER MOD DC/DC 72V 75W
VE-BN1-MY CONVERTER MOD DC/DC 12V 50W
ADV7623BSTZ-RL IC TXRX HDMI 1:4 144LQFP
MS27497T14B5SA CONN RCPT 5POS WALL MNT W/SCKT
相關代理商/技術參數
參數描述
XRT75VL00IVTR-F 功能描述:時鐘合成器/抖動清除器 3.3V 1 CH E3/DS3/STS W/JITTER ATTEN RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel
XRT79L71 制造商:EXAR 制造商全稱:EXAR 功能描述:1-CHANNEL DS3/E3 ATM UNI/PPP/CLEAR-CHANNEL FRAMER IC -
XRT79L71_07 制造商:EXAR 制造商全稱:EXAR 功能描述:1-CHANNEL DS3/E3 ATM UNI/PPP/CLEAR-CHANNEL FRAMER IC - HARDWARE
XRT79L71_1 制造商:EXAR 制造商全稱:EXAR 功能描述:1-CHANNEL DS3/E3 ATM UNI/PPP/CLEAR-CHANNEL FRAMER IC -
XRT79L71ES 功能描述:時鐘合成器/抖動清除器 1 CH DS3/E3 ATM /UNI/PPP COMBO RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*