參數資料
型號: XRT8020IL
廠商: EXAR CORP
元件分類: 數字傳輸電路
英文描述: 650 MHZ CLOCK & CRYSTAL MULTIPLIER WITH LVDS OUTPUTS
中文描述: ATM/SONET/SDH SUPPORT CIRCUIT, QCC16
封裝: 4 X 4 MM, QFN-16
文件頁數: 12/12頁
文件大?。?/td> 425K
代理商: XRT8020IL
XRT8020
650 MHZ CLOCK & CRYSTAL MULTIPLIER WITH LVDS OUTPUTS
REV. 1.0.2
11
NOTICE
EXAR Corporation reserves the right to make changes to the products contained in this publication in order
to improve design, performance or reliability. EXAR Corporation assumes no responsibility for the use of
any circuits described herein, conveys no license under any patent or other right, and makes no represen-
tation that the circuits are free of patent infringement. Charts and schedules contained here in are only for
illustration purposes and may vary depending upon a user’s specific application. While the information in
this publication has been carefully checked; no responsibility, however, is assumed for inaccuracies.
EXAR Corporation does not recommend the use of any of its products in life support applications where
the failure or malfunction of the product can reasonably be expected to cause failure of the life support sys-
tem or to significantly affect its safety or effectiveness. Products are not authorized for use in such applica-
tions unless EXAR Corporation receives, in writing, assurances to its satisfaction that: (a) the risk of injury
or damage has been minimized; (b) the user assumes all such risks; (c) potential liability of EXAR Corpo-
ration is adequately protected under the circumstances.
Copyright 2003 EXAR Corporation
Datasheet November 2003.
Reproduction, in part or whole, without the prior written consent of EXAR Corporation is prohibited.
REVISIONS
P1.0.1 Accumulated output jitter in electrical specs changed from 25 ps @ 624MHz to 20 @ 622Mhz and
TBD to 20 ps @312Mhz. Pin 9 has internal a pull-down resistor instead of pull-up. Table 1 FS0 and FS1 bit
pattern changed.
P1.0.2 Changed typical jitter to 6ps and changed package to QFN
P1.0.3 Corrected package dimension dimension "e" to 0.65 mm BSC. Updated electrical tables. Added de-
scriptive sections on Calibration, Crystal Selection and Data and Plots.
1.0.0 Final Release. Added intrinsic jitter measurements to the electrical characteristics.
1.0.1 Changed the page numbering. Changed the QLP to QFN in the Features on page 1.
1.0.2 Changed the Package Drawing and Dimensions.
相關PDF資料
PDF描述
XRT81L27IV SEVEN CHANNEL E1 LINE INTERFACE UNIT WITH CLOCK RECOVERY
XRT81L27 Seven Channel E1 Line Interface Unit with Clock Recovery(7通道 E1線接口單元(帶時鐘恢復))
XRT82D20 Single Channel E1 Line Interface Unit(單通道E1線接口單元)
XRT82L24IV QUAD E1 LINE TRANSCEIVER WITH CLOCK RECOVERY AND JITTER ATTENUATOR
XRT82L24 Quad E1 Line Transceiver with Clock Recovery and Jitter Attenuator(四E1線收發器(帶時鐘恢復和振動衰減器))
相關代理商/技術參數
參數描述
XRT8020IL-F 功能描述:鎖相環 - PLL RoHS:否 制造商:Silicon Labs 類型:PLL Clock Multiplier 電路數量:1 最大輸入頻率:710 MHz 最小輸入頻率:0.002 MHz 輸出頻率范圍:0.002 MHz to 808 MHz 電源電壓-最大:3.63 V 電源電壓-最小:1.71 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:QFN-36 封裝:Tray
XRT81L17IV-F 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
XRT81L27 制造商:EXAR 制造商全稱:EXAR 功能描述:SEVEN CHANNEL E1 LINE INTERFACE UNIT WITH CLOCK RECOVERY
XRT81L27IV 功能描述:外圍驅動器與原件 - PCI RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
XRT81L27IV-F 功能描述:外圍驅動器與原件 - PCI RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray