- 您現在的位置：買賣IC網 > PDF目錄3912 > 20-101-0446 (Rabbit Semiconductor)MODULE RABBITCORE RCM2130 PDF資料下載
參數資料
| 型號： | 20-101-0446 |
| 廠商： | Rabbit Semiconductor |
| 文件頁數： | 29/100頁 |
| 文件大?。?/td> | 0K |
| 描述： | MODULE RABBITCORE RCM2130 |
| 標準包裝： | 1 |
| 系列： | RabbitCore® |
| 模塊/板類型： | MPU 核心模塊 |
| 適用于相關產品： | RCM2130 |
| 產品目錄頁面： | 620 (CN2011-ZH PDF) |
| 其它名稱： | 316-1088 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁當前第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁
28
RabbitCore RCM2100
4.1.1 Dedicated Inputs
PB0 and PB1 are designated as inputs because the Rabbit 2000 is operating in an asyn-
chronous mode. Four of the input-only pins are located on PB2–PB5. These pins are used
for the slave port. PB2 and PB3 are slave write and slave read strobes, while PB4 and PB5
serve as slave address lines SA0 and SA1, and are used to access the slave registers (SD0–
SD7), which is the alternate assignment for parallel port A. When Port C is used as a paral-
lel port, PC1, PC3, PC5, and PC7 are inputs only. These pins can alternately be selectively
enabled to serve as the serial data inputs for Serial Ports D, C, B, and A.
4.1.2 Dedicated Outputs
Two of the output-only pins are located on PB6–PB7. PB7 can also be used with the slave port as the
/SLAVEATTN output. This configuration signifies that the slave is requesting attention from the
master. When Port C is used as a parallel port, PC0, PC2, PC4 and PC6 are outputs only. These pins
can alternately serve as the serial data outputs for Serial Ports D, C, B, and A.
4.1.3 Memory I/O Interface
Thirteen of the Rabbit 2000 buffered address lines (A0–A12) and all the buffered data
lines (D0–D7) are available as outputs. I/0 write (/IOWR), I/0 read (/IORD), buffer enable
(/BUFEN), and Watchdog Output (/WDO) are also available for interfacing to external
devices.
The STATUS output has three different programmable functions:
1. It can be driven low on the first op code fetch cycle.
2. It can be driven low during an interrupt acknowledge cycle.
3. It can also serve as a general-purpose output.
The output clock is available on the PCLK pin. The primary function of PCLK is as a
peripheral clock or a peripheral clock ÷ 2, but PCLK can instead be used as a digital out-
put. PCLK can also be disabled by removing R20 if there is a need to reduce radiated
emissions. Removing R20 will disable the PCLK output on pin 3 of header J1. Alterna-
tively, PCLK can be disabled in software using Dynamic C version 7.03 or later.
4.1.4 Additional I/0
Two status mode pins, SMODE0 and SMODE1, are available as inputs. The logic state of
these two pins determines the startup procedure after a reset.
/RES_IN is an external input used to reset the Rabbit 2000 microprocessor and the Rabbit-
Core RCM2100 memory. /RES_OUT is an output from the reset circuitry that can be used
to reset other peripheral devices.
相關PDF資料 |
PDF描述 |
|---|---|
| AT25256-10PI-2.7 | IC EEPROM 256KBIT 3MHZ 8DIP |
| 345-030-524-801 | CARDEDGE 30POS DUAL .100 GREEN |
| 345-030-524-204 | CARDEDGE 30POS DUAL .100 GREEN |
| 345-030-524-202 | CARDEDGE 30POS DUAL .100 GREEN |
| 345-030-524-201 | CARDEDGE 30POS DUAL .100 GREEN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 20-101-0453 | 功能描述:模塊化系統 - SOM RCM2300 RabbitCore Module RoHS:否 制造商:Digi International 外觀尺寸:ConnectCore 9P 處理器類型:ARM926EJ-S 頻率:150 MHz 存儲容量:8 MB, 16 MB 存儲類型:NOR Flash, SDRAM 接口類型:I2C, SPI, UART 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 尺寸:1.97 in x 1.97 in x 6.1 in |
| 20-101-0454 | 功能描述:模塊化系統 - SOM RCM2200 RABBITCORE RoHS:否 制造商:Digi International 外觀尺寸:ConnectCore 9P 處理器類型:ARM926EJ-S 頻率:150 MHz 存儲容量:8 MB, 16 MB 存儲類型:NOR Flash, SDRAM 接口類型:I2C, SPI, UART 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 尺寸:1.97 in x 1.97 in x 6.1 in |
| 20-101-0455 | 功能描述:單板計算機 BL2010 RoHS:否 制造商:Ampro By ADLINK 外觀尺寸:EPIC 處理器類型:Intel Atom D510 頻率:1.66 GHz 存儲容量:2 GB (max) 存儲類型:DDR2, L2 Cache 接口類型:Ethernet, PS/2, SATA, Serial, USB 工作電源電壓:5 V, 12 V 功耗:13 W 最大工作溫度:+ 70 C 尺寸:165.1 mm x 114.3 mm |
| 20-101-0456 | 功能描述:單板計算機 BL2020 RoHS:否 制造商:Ampro By ADLINK 外觀尺寸:EPIC 處理器類型:Intel Atom D510 頻率:1.66 GHz 存儲容量:2 GB (max) 存儲類型:DDR2, L2 Cache 接口類型:Ethernet, PS/2, SATA, Serial, USB 工作電源電壓:5 V, 12 V 功耗:13 W 最大工作溫度:+ 70 C 尺寸:165.1 mm x 114.3 mm |
| 20-101-0457 | 功能描述:單板計算機 BL2030 Board RoHS:否 制造商:Ampro By ADLINK 外觀尺寸:EPIC 處理器類型:Intel Atom D510 頻率:1.66 GHz 存儲容量:2 GB (max) 存儲類型:DDR2, L2 Cache 接口類型:Ethernet, PS/2, SATA, Serial, USB 工作電源電壓:5 V, 12 V 功耗:13 W 最大工作溫度:+ 70 C 尺寸:165.1 mm x 114.3 mm |
發布緊急采購，3分鐘左右您將得到回復。