參數資料
型號： 20-101-0446
廠商： Rabbit Semiconductor
文件頁數： 91/100頁
文件大小： 0K
描述： MODULE RABBITCORE RCM2130
標準包裝： 1
系列： RabbitCore®
模塊/板類型： MPU 核心模塊
適用于相關產品： RCM2130
產品目錄頁面： 620 (CN2011-ZH PDF)
其它名稱： 316-1088
84
RabbitCore RCM2100
C.2 Chip Select Circuit
The RCM2100 has provision for battery backup, which kicks in to keep VRAM from
dropping below 2 V.
The current drain on the battery in a battery-backed circuit must be kept to a minimum.
When the RCM2100 is not powered, the battery keeps the SRAM memory contents and the
real-time clock (RTC) going. The SRAM has a powerdown mode that greatly reduces power
consumption. This powerdown mode is activated by raising the chip select (CS) signal line.
Normally the SRAM requires Vcc to operate. However, only 2 V is required for data reten-
tion in powerdown mode. Thus, when power is removed from the circuit, the battery voltage
needs to be provided to both the SRAM power pin and to the CS signal line. The CS control
circuit accomplishes this task for the CS signal line.
Figure C-4 shows a schematic of the chip select circuit.
Figure C-4. Chip Select Circuit
In a powered-up condition, the CS control circuit must allow the processor’s chip select sig-
nal /CS1 to control the SRAM’s CS signal /CSRAM. So, with power applied, /CSRAM
must be the same signal as /CS1, and with power removed, /CSRAM must be held high (but
only needs to be as high as the battery voltage). Q4 and Q5 are MOSFET transistors with
opposing polarity. They are both turned on when power is applied to the circuit. They allow
the CS signal to pass from the processor to the SRAM so that the processor can periodically
access the SRAM. When power is removed from the circuit, the transistors will turn off and
isolate /CSRAM from the processor. The isolated /CSRAM line has a 100 k
pullup resistor
to VRAM (R16). This pullup resistor keeps /CSRAM at the VRAM voltage level (which
under no power condition is the backup battery’s regulated voltage at a little more than 2 V).
Transistors Q4 and Q5 are of opposite polarity so that a rail-to-rail voltages can be passed.
When the /CS1 voltage is low, Q4 will conduct. When the /CS1 voltage is high, Q5 will
conduct. It takes time for the transistors to turn on, creating a propagation delay. This
delay is typically very small, about 10 ns to 15 ns.
/CS1
/CSRAM
/RESET
Q4
Q5
R14
R16
VRAM
10 kW
100 kW
U2
R17
100 kW
C23
1 nF
1
2
相關PDF資料
PDF描述
AT25256-10PI-2.7 IC EEPROM 256KBIT 3MHZ 8DIP
345-030-524-801 CARDEDGE 30POS DUAL .100 GREEN
345-030-524-204 CARDEDGE 30POS DUAL .100 GREEN
345-030-524-202 CARDEDGE 30POS DUAL .100 GREEN
345-030-524-201 CARDEDGE 30POS DUAL .100 GREEN
相關代理商/技術參數
參數描述
20-101-0453 功能描述:模塊化系統 - SOM RCM2300 RabbitCore Module RoHS:否 制造商:Digi International 外觀尺寸:ConnectCore 9P 處理器類型:ARM926EJ-S 頻率:150 MHz 存儲容量:8 MB, 16 MB 存儲類型:NOR Flash, SDRAM 接口類型:I2C, SPI, UART 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 尺寸:1.97 in x 1.97 in x 6.1 in
20-101-0454 功能描述:模塊化系統 - SOM RCM2200 RABBITCORE RoHS:否 制造商:Digi International 外觀尺寸:ConnectCore 9P 處理器類型:ARM926EJ-S 頻率:150 MHz 存儲容量:8 MB, 16 MB 存儲類型:NOR Flash, SDRAM 接口類型:I2C, SPI, UART 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 尺寸:1.97 in x 1.97 in x 6.1 in
20-101-0455 功能描述:單板計算機 BL2010 RoHS:否 制造商:Ampro By ADLINK 外觀尺寸:EPIC 處理器類型:Intel Atom D510 頻率:1.66 GHz 存儲容量:2 GB (max) 存儲類型:DDR2, L2 Cache 接口類型:Ethernet, PS/2, SATA, Serial, USB 工作電源電壓:5 V, 12 V 功耗:13 W 最大工作溫度:+ 70 C 尺寸:165.1 mm x 114.3 mm
20-101-0456 功能描述:單板計算機 BL2020 RoHS:否 制造商:Ampro By ADLINK 外觀尺寸:EPIC 處理器類型:Intel Atom D510 頻率:1.66 GHz 存儲容量:2 GB (max) 存儲類型:DDR2, L2 Cache 接口類型:Ethernet, PS/2, SATA, Serial, USB 工作電源電壓:5 V, 12 V 功耗:13 W 最大工作溫度:+ 70 C 尺寸:165.1 mm x 114.3 mm
20-101-0457 功能描述:單板計算機 BL2030 Board RoHS:否 制造商:Ampro By ADLINK 外觀尺寸:EPIC 處理器類型:Intel Atom D510 頻率:1.66 GHz 存儲容量:2 GB (max) 存儲類型:DDR2, L2 Cache 接口類型:Ethernet, PS/2, SATA, Serial, USB 工作電源電壓:5 V, 12 V 功耗:13 W 最大工作溫度:+ 70 C 尺寸:165.1 mm x 114.3 mm
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*