參數資料
型號： 20-101-0446
廠商： Rabbit Semiconductor
文件頁數： 30/100頁
文件大小： 0K
描述： MODULE RABBITCORE RCM2130
標準包裝： 1
系列： RabbitCore®
模塊/板類型： MPU 核心模塊
適用于相關產品： RCM2130
產品目錄頁面： 620 (CN2011-ZH PDF)
其它名稱： 316-1088
User’s Manual
29
4.2 Serial Communication
The RCM2100 board does not have an RS-232 or an RS-485 transceiver directly on the
board. However, an RS-232 or RS-485 interface may be incorporated on the board the
RCM2100 is mounted on. For example, the Prototyping Board supports a standard
RS-232 transceiver chip.
4.2.1 Serial Ports
There are four serial ports designated as Serial Ports A, B, C, and D. All four serial ports
can operate in an asynchronous mode up to the baud rate of the system clock divided by
32. An asynchronous port can handle 7 or 8 data bits. A 9th bit address scheme, where an
additional bit is sent to mark the first byte of a message, is also supported. Serial Ports A
and B can be operated alternately in the clocked serial mode. In this mode, a clock line
synchronously clocks the data in or out. Either of the two communicating devices can sup-
ply the clock. When the Rabbit 2000 provides the clock, the baud rate can be up to 1/4 of
the system clock frequency, or 5.52 Mbps for a 22.1 MHz clock speed.
4.2.2 Ethernet Port
Figure 7 shows the pinout for the RJ-45 Ethernet port (J4). Note that there are two stan-
dards for numbering the pins on this connector—the convention used here, and numbering
in reverse to that used here.
Figure 7. RJ-45 Ethernet Port Pinout
The transformer/connector assembly ground is con-
nected to the RCM2100 printed circuit board digital
ground via a 0
resistor “jumper,” R5, as shown in
The factory default is for the 0
resistor “jumper” at
R5 to be installed. In high-noise environments, it may
be useful to ground the transformer/connector assem-
bly directly through the chassis ground. This will be
especially helpful to minimize EMI problems.
Figure 8. Isolation Resistor R5
ETHERNET
RJ-45 Plug
1. E_Tx+
2. E_Tx
3. E_Rx+
6. E_Rx
1
8
RJ-45 Jack
RJ-45 Ethernet Plug
R5
Chassis
Ground
Board
Ground
相關PDF資料
PDF描述
AT25256-10PI-2.7 IC EEPROM 256KBIT 3MHZ 8DIP
345-030-524-801 CARDEDGE 30POS DUAL .100 GREEN
345-030-524-204 CARDEDGE 30POS DUAL .100 GREEN
345-030-524-202 CARDEDGE 30POS DUAL .100 GREEN
345-030-524-201 CARDEDGE 30POS DUAL .100 GREEN
相關代理商/技術參數
參數描述
20-101-0453 功能描述:模塊化系統 - SOM RCM2300 RabbitCore Module RoHS:否 制造商:Digi International 外觀尺寸:ConnectCore 9P 處理器類型:ARM926EJ-S 頻率:150 MHz 存儲容量:8 MB, 16 MB 存儲類型:NOR Flash, SDRAM 接口類型:I2C, SPI, UART 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 尺寸:1.97 in x 1.97 in x 6.1 in
20-101-0454 功能描述:模塊化系統 - SOM RCM2200 RABBITCORE RoHS:否 制造商:Digi International 外觀尺寸:ConnectCore 9P 處理器類型:ARM926EJ-S 頻率:150 MHz 存儲容量:8 MB, 16 MB 存儲類型:NOR Flash, SDRAM 接口類型:I2C, SPI, UART 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 尺寸:1.97 in x 1.97 in x 6.1 in
20-101-0455 功能描述:單板計算機 BL2010 RoHS:否 制造商:Ampro By ADLINK 外觀尺寸:EPIC 處理器類型:Intel Atom D510 頻率:1.66 GHz 存儲容量:2 GB (max) 存儲類型:DDR2, L2 Cache 接口類型:Ethernet, PS/2, SATA, Serial, USB 工作電源電壓:5 V, 12 V 功耗:13 W 最大工作溫度:+ 70 C 尺寸:165.1 mm x 114.3 mm
20-101-0456 功能描述:單板計算機 BL2020 RoHS:否 制造商:Ampro By ADLINK 外觀尺寸:EPIC 處理器類型:Intel Atom D510 頻率:1.66 GHz 存儲容量:2 GB (max) 存儲類型:DDR2, L2 Cache 接口類型:Ethernet, PS/2, SATA, Serial, USB 工作電源電壓:5 V, 12 V 功耗:13 W 最大工作溫度:+ 70 C 尺寸:165.1 mm x 114.3 mm
20-101-0457 功能描述:單板計算機 BL2030 Board RoHS:否 制造商:Ampro By ADLINK 外觀尺寸:EPIC 處理器類型:Intel Atom D510 頻率:1.66 GHz 存儲容量:2 GB (max) 存儲類型:DDR2, L2 Cache 接口類型:Ethernet, PS/2, SATA, Serial, USB 工作電源電壓:5 V, 12 V 功耗:13 W 最大工作溫度:+ 70 C 尺寸:165.1 mm x 114.3 mm
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*