channe" />
參數資料
型號: 20-101-0497
廠商: Rabbit Semiconductor
文件頁數: 27/110頁
文件大?。?/td> 0K
描述: MODULE OP6810 W/O ETH/MEM EXPANS
標準包裝: 1
系列: SBC
模塊/板類型: 單板計算機模塊
適用于相關產品: OP6810
其它名稱: 20-101-497
20-101-497-ND
User’s Manual
19
3.3 Serial Communication
The OP6800 has two RS-232 serial ports, which can be configured as one RS-232 serial
channel (with RTS/CTS) or as two RS-232 (3-wire) channels using the serMode software
function call. Table 3 summarizes the options.
The OP6800 also has one RS-485 serial channel and one CMOS serial channel. The
CMOS serial channel serves as the programming port.
All four serial ports operate in an asynchronous mode. An asynchronous port can handle 7
or 8 data bits. A 9th bit address scheme, where an additional bit is sent to mark the first byte
of a message, is also supported. Serial Port A, the CMOS programming port, can be oper-
ated alternately in the clocked serial mode. In this mode, a clock line synchronously clocks
the data in or out. Either of the two communicating devices can supply the clock. The
OP6800 boards typically use all four ports in the asynchronous serial mode. Serial Ports B
and C are used for RS-232 communication, and Serial Port D is used for RS-485 commu-
nication. The OP6800 uses an 11.0592 MHz crystal, which is doubled to 22.1184 MHz. At
this frequency, the OP6800 supports standard asynchronous baud rates up to a maximum
of 230,400 bps.
3.3.1 RS-232
The OP6800 RS-232 serial communication is supported by an RS-232 transceiver. This
transceiver provides the voltage output, slew rate, and input voltage immunity required to
meet the RS-232 serial communication protocol. Basically, the chip translates the Rabbit
2000’s CMOS/TTL signals to RS-232 signal levels. Note that the polarity is reversed by
an RS-232 circuit so that a +5 V input becomes approximately -10 V and 0 V is output as
+10 V. The RS-232 transceiver also provides the proper line loading for reliable commu-
nication.
RS-232 can be used effectively at the OP6800’s maximum baud rate for distances of up to
15 m.
3.3.2 RS-485
The OP6800 has one RS-485 serial channel, which is connected to the Rabbit 2000 Serial
Port D through an RS-485 transceiver. The half-duplex communication uses the Rabbit
2000’s PB6 pin to control the transmit enable on the communication line.
The OP6800 can be used in an RS-485 multidrop network. Connect the 485+ to 485+ and
485– to 485– using single twisted-pair wires (nonstranded, tinned) as shown in Figure 11.
Note that a common ground is recommended.
Table 3. Serial Communication Configurations
Mode
Serial Port
B
C
D
0
RS-232, 3-wire
RS-485
1
RS-232, 5-wire
CTS/RTS
RS-485
相關PDF資料
PDF描述
20-101-0464 COMPUTER SINGLE-BOARD BL2130
SOMOMAP3503-21-1670AGCR SYSTEM ON MODULE LV OMAP3503
101-0600 COMPUTER SNGLBD BL2510 512K FLSH
101-0575 COMPUTER SNGLBD BL2500 256K FLSH
20-101-0526 COMPUTER SNGLBD LP3510 FOX7.4MHZ
相關代理商/技術參數
參數描述
201-01050 功能描述:鋁質電解電容器 - 帶引線 1 uF Electrolytic Capacitor RoHS:否 制造商:Kemet 引線類型: 電容:220 uF 容差:20 % 電壓額定值:25 V 工作溫度范圍: 端接類型:Radial 外殼直徑:8 mm 外殼長度:11 mm 引線間隔:5 mm 產品:General Purpose Electrolytic Capacitors 封裝:Bulk
201-0105-01 功能描述:印刷電路板和試驗板 JTAG 20 Pin Connector RoHS:否 制造商:3M Electronic Solutions Division 產品:Jumper & Insulated Wires 描述/功能:Jumper wire, 22 AWG 0.1 inch 長度:0.1 in 寬度:
20-101-0502 功能描述:處理器配件 Keypad/Display Unit 5V Panle Mount RoHS:否 制造商:Olimex Ltd. 產品:Cable 用于:
20-101-0504 功能描述:程序設計器配件 Cable KDU w/mount Hardware RoHS:否 制造商:Lattice 產品:ispDOWNLOAD Cables 用于:In-system Programming
20-101-0506 功能描述:單板計算機 SR9160 CPU Card RoHS:否 制造商:Ampro By ADLINK 外觀尺寸:EPIC 處理器類型:Intel Atom D510 頻率:1.66 GHz 存儲容量:2 GB (max) 存儲類型:DDR2, L2 Cache 接口類型:Ethernet, PS/2, SATA, Serial, USB 工作電源電壓:5 V, 12 V 功耗:13 W 最大工作溫度:+ 70 C 尺寸:165.1 mm x 114.3 mm