參數資料
型號： 20-101-0709
廠商： Rabbit Semiconductor
文件頁數： 20/90頁
文件大?。?/td> 0K
描述： INTERFACE GRAPHIC DISPLAY OP6700
標準包裝： 1
系列： SBC
模塊/板類型： 單板計算機模塊
適用于相關產品： OP6700
其它名稱： 20-101-709
20-101-709-ND
User’s Manual
23
3.2.1 RS-232
The Intellicom’s RS-232 serial channel is connected to an RS-232 transceiver, U11. U11
provides the voltage output, slew rate, and input voltage immunity required to meet the
RS-232 serial communication protocol. Basically, the chip translates the Rabbit 2000’s 0
V to +Vcc signals to RS-232 signal levels. Note that the polarity is reversed in an RS-232
circuit so that +5 V is output as approximately -10 V and 0 V is output as approximately
+10 V. U11 also provides the proper line loading for reliable communication.
The maximum baud rate is 115,200 bps. RS-232 can be used effectively at this baud rate
for distances up to 15 m.
3.2.2 RS-485
The Intellicom has one RS-485 serial channel, which is connected to the Rabbit 2000
serial port B through U10, an RS-485 transceiver. The chip’s slew rate limiters provide for
a maximum baud rate of 250,000 bps, which allows for a network of up to 1200 m (or
4000 ft). The half-duplex communication uses the Rabbit 2000’s PC0 pin to control the
data enable on the communication line.
The RS-485 signals are available on pins 3 and 4 of header J7, and on J5, the RJ-12 jack.
The Intellicom can be used in an RS-485 multidrop network. Connect the 485+ to 485+
and 485– to 485– using single twisted-pair wires (nonstranded, tinned) as shown in
Alternatively, the RS-485 multidrop network may be hooked up using cables with RJ-12
plugs. Note that the RJ-12 jack has +RAW_485 and GND, which means that only one
Intellicom needs to be connected to an external power source via an AC adapter. When
doing so, ensure that the AC adapter has sufficient capacity for the network — each Intel-
licom unit nominally draws 100 mA at 24 VDC.
CAUTION: If you plan to connect a power supply to more than one
Intellicom unit
in an RS-485 network using the RJ-12 jacks, rework the RS-485 cables so they do not
connect +RAW_RS485 through the RJ-12 jack to the boards in the network.
NOTE: The RS-485 port is available only in the factory default configuration. The RS-485
port will not be available when you select the configuration option for both 3-wire
RS-232 ports or one 5-wire RS-232 port.
相關PDF資料
PDF描述
AT45DB081B-RI IC FLASH 8MBIT 20MHZ 28SOIC
AT45DB081B-RC IC FLASH 8MBIT 20MHZ 28SOIC
AT45DB081B-CI IC FLASH 8MBIT 20MHZ 14CBGA
AT45DB081B-CC IC FLASH 8MBIT 20MHZ 14CBGA
AT45DB041B-TC IC FLASH 4MBIT 20MHZ 28TSOP
相關代理商/技術參數
參數描述
20-101-0727 功能描述:模塊化系統 - SOM BL2010 W/ 512K FLASH RoHS:否 制造商:Digi International 外觀尺寸:ConnectCore 9P 處理器類型:ARM926EJ-S 頻率:150 MHz 存儲容量:8 MB, 16 MB 存儲類型:NOR Flash, SDRAM 接口類型:I2C, SPI, UART 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 尺寸:1.97 in x 1.97 in x 6.1 in
20-101-0732 功能描述:單板計算機 OP7100 W/512K SRAM RoHS:否 制造商:Ampro By ADLINK 外觀尺寸:EPIC 處理器類型:Intel Atom D510 頻率:1.66 GHz 存儲容量:2 GB (max) 存儲類型:DDR2, L2 Cache 接口類型:Ethernet, PS/2, SATA, Serial, USB 工作電源電壓:5 V, 12 V 功耗:13 W 最大工作溫度:+ 70 C 尺寸:165.1 mm x 114.3 mm
20-101-0737 制造商:Digi International 功能描述:SMARTBLOCK OEM W/RTC - MOQ: 50 - Bulk 制造商:Digi International Inc 功能描述:SMARTBLOCK OEM W/RTC MOQ: 50 制造商:Rabbit Semiconductor 功能描述:Smartblock OEM w/RTC
20-101-0738 功能描述:單板計算機 SR9150 Eth 512K SRAM RoHS:否 制造商:Ampro By ADLINK 外觀尺寸:EPIC 處理器類型:Intel Atom D510 頻率:1.66 GHz 存儲容量:2 GB (max) 存儲類型:DDR2, L2 Cache 接口類型:Ethernet, PS/2, SATA, Serial, USB 工作電源電壓:5 V, 12 V 功耗:13 W 最大工作溫度:+ 70 C 尺寸:165.1 mm x 114.3 mm
20-101-0739 制造商:Digi International 功能描述:BL1700 16IN/16OUT 512K SRAM 256K FLASH - MOQ: 25 - Boxed Product (Development Kits) 制造商:Digi International Inc 功能描述:ETH CTLR BL1700 16I/O 256K FLASH 制造商:Rabbit Semiconductor 功能描述:BL1700 512K SRAM 16 In/Out 256K Flash
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*