參數資料
型號： 20-101-0709
廠商： Rabbit Semiconductor
文件頁數： 79/90頁
文件大?。?/td> 0K
描述： INTERFACE GRAPHIC DISPLAY OP6700
標準包裝： 1
系列： SBC
模塊/板類型： 單板計算機模塊
適用于相關產品： OP6700
其它名稱： 20-101-709
20-101-709-ND
76
Intellicom (OP6600/OP6700)
A message reports “No Rabbit Processor Detected” in cases where the wall transformer
is either not connected or is not plugged in.
The programming cable must be connected to the Intellicom board. (The colored wire
on the programming cable is closest to pin 1 on header J4 on the Intellicom board, as
shown in Figure 1.) The other end of the programming cable must be connected to the
PC serial port. The COM port specified in the Dynamic C Options menu must be the
same as the one the programming cable is connected to.
To check if you have the correct serial port, select Compile, then Compile BIOS, or
type <ctrl-Y>. If the “BIOS successfully compiled …” message does not display, try a
different serial port using the Dynamic C Options menu until you find the serial port
you are plugged into. Don’t change anything in this menu except the COM number.
The baud rate should be 115,200 bps and the stop bits should be 1.
D.2.1 Single-Stepping
Compile or re-compile DEMOBRD1.C by clicking the Compile button on the task bar. The
program will compile and the screen will come up with a highlighted character (green) at
the first executable statement of the program. Use the F8 key to single-step. Each time the
F8
key is pressed, the cursor will advance one statement. When you get to the for(j=0,
j< ...
statement, it becomes impractical to single-step further because you would have
to press F8 thousands of times. We will use this statement to illustrate watch expressions.
D.2.1.1 Watch Expression
Type <ctrl-W> or chose Add/Del Watch Expression in the Inspect menu. A box will
come up. Type the lower case letter j and click on add to top and close. Now continue sin-
gle-stepping with F8. Each time you step, the watch expression (j) will be evaluated and
printed in the watch window. Note how the value of j advances when the statement j++ is
executed.
D.2.1.2 Break Point
Move the cursor to the start of the statement:
for(j=0; j<20000; j++);
To set a break point on this statement, type F2 or select Breakpoint from the Run menu. A
red highlight will appear on the first character of the statement. To get the program run-
ning at full speed, type F9 or select Run on the Run menu. The program will advance until
it hits the break point. The break point will start flashing both red and green colors. Note
that LED1 on the Demonstration Board is now solidly turned on. This is because we have
passed the statement turning on LED1.
To remove the break point, type F2 or select Toggle Breakpoint on the Run menu. To
continue program execution, type F9 or select Run from the Run menu. Now LED1
should be flashing again because the program is running at full speed.
You can set break points while the program is running by positioning the cursor to a state-
ment and using the F2 key. If the execution thread hits the break point, a break point will
相關PDF資料
PDF描述
AT45DB081B-RI IC FLASH 8MBIT 20MHZ 28SOIC
AT45DB081B-RC IC FLASH 8MBIT 20MHZ 28SOIC
AT45DB081B-CI IC FLASH 8MBIT 20MHZ 14CBGA
AT45DB081B-CC IC FLASH 8MBIT 20MHZ 14CBGA
AT45DB041B-TC IC FLASH 4MBIT 20MHZ 28TSOP
相關代理商/技術參數
參數描述
20-101-0727 功能描述:模塊化系統 - SOM BL2010 W/ 512K FLASH RoHS:否 制造商:Digi International 外觀尺寸:ConnectCore 9P 處理器類型:ARM926EJ-S 頻率:150 MHz 存儲容量:8 MB, 16 MB 存儲類型:NOR Flash, SDRAM 接口類型:I2C, SPI, UART 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 尺寸:1.97 in x 1.97 in x 6.1 in
20-101-0732 功能描述:單板計算機 OP7100 W/512K SRAM RoHS:否 制造商:Ampro By ADLINK 外觀尺寸:EPIC 處理器類型:Intel Atom D510 頻率:1.66 GHz 存儲容量:2 GB (max) 存儲類型:DDR2, L2 Cache 接口類型:Ethernet, PS/2, SATA, Serial, USB 工作電源電壓:5 V, 12 V 功耗:13 W 最大工作溫度:+ 70 C 尺寸:165.1 mm x 114.3 mm
20-101-0737 制造商:Digi International 功能描述:SMARTBLOCK OEM W/RTC - MOQ: 50 - Bulk 制造商:Digi International Inc 功能描述:SMARTBLOCK OEM W/RTC MOQ: 50 制造商:Rabbit Semiconductor 功能描述:Smartblock OEM w/RTC
20-101-0738 功能描述:單板計算機 SR9150 Eth 512K SRAM RoHS:否 制造商:Ampro By ADLINK 外觀尺寸:EPIC 處理器類型:Intel Atom D510 頻率:1.66 GHz 存儲容量:2 GB (max) 存儲類型:DDR2, L2 Cache 接口類型:Ethernet, PS/2, SATA, Serial, USB 工作電源電壓:5 V, 12 V 功耗:13 W 最大工作溫度:+ 70 C 尺寸:165.1 mm x 114.3 mm
20-101-0739 制造商:Digi International 功能描述:BL1700 16IN/16OUT 512K SRAM 256K FLASH - MOQ: 25 - Boxed Product (Development Kits) 制造商:Digi International Inc 功能描述:ETH CTLR BL1700 16I/O 256K FLASH 制造商:Rabbit Semiconductor 功能描述:BL1700 512K SRAM 16 In/Out 256K Flash
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*