- 您現在的位置：買賣IC網 > PDF目錄371396 > 24AA512 (Microchip Technology Inc.) 512K I2C CMOS Serial EEPROM PDF資料下載
參數資料
| 型號： | 24AA512 |
| 廠商： | Microchip Technology Inc. |
| 英文描述： | 512K I2C CMOS Serial EEPROM |
| 中文描述： | 為512k的I2C的CMOS串行EEPROM |
| 文件頁數： | 8/26頁 |
| 文件大?。?/td> | 420K |
| 代理商： | 24AA512 |
24AA512/24LC512/24FC512
DS21754E-page 8
2004 Microchip Technology Inc.
5.0
DEVICE ADDRESSING
A control byte is the first byte received following the
Start condition from the master device (Figure 5-1).
The control byte consists of a 4-bit control code; for the
24XX512 this is set as ‘
1010
’
binary for read and write
operations. The next three bits of the control byte are
the Chip Select bits (A2, A1 and A0). The Chip Select
bits allow the use of up to eight 24XX512 devices on
the same bus and are used to select which device is
accessed. The Chip Select bits in the control byte must
correspond to the logic levels on the corresponding A2,
A1 and A0 pins for the device to respond. These bits
are in effect the three Most Significant bits of the word
address.
The last bit of the control byte defines the operation to
be performed. When set to a one a read operation is
selected and when set to a zero a write operation is
selected. The next two bytes received define the
address of the first data byte (Figure 5-2). Because all
A15…A0 are used, there are no upper address bits that
are “don’t care”. The upper address bits are transferred
first, followed by the Less Significant bits.
Following the Start condition, the 24XX512 monitors
the SDA bus checking the device type identifier being
transmitted. Upon receiving a ‘
1010
’
code and appro-
priate device select bits, the slave device outputs an
Acknowledge signal on the SDA line. Depending on the
state of the R/W bit, the 24XX512 will select a read or
write operation.
FIGURE 5-1:
CONTROL BYTE FORMAT
5.1
Contiguous Addressing Across
Multiple Devices
The Chip Select bits A2, A1 and A0 can be used to
expand the contiguous address space for up to 4 Mbit
by adding up to eight 24XX512s on the same bus. In
this case, software can use A0 of the
control byte
as
address bit A16; A1, as address bit A17; and A2, as
address bit A18. It is not possible to sequentially read
across device boundaries.
FIGURE 5-2:
ADDRESS SEQUENCE BIT ASSIGNMENTS
1
0
1
0
A2
A1
A0
S
ACK
R/W
Control Code
Chip Select
Bits
Slave Address
Acknowledge Bit
Start Bit
Read/Write Bit
1
0
1
0
A
2
A
1
A
A
11
A
10
A
9
A
7
A
0
A
8
A
12
CONTROL BYTE
ADDRESS HIGH BYTE
ADDRESS LOW BYTE
CONTROL
CODE
CHIP
SELECT
BITS
A
13
A
14
A
15
相關PDF資料 |
PDF描述 |
|---|---|
| 24LC512 | 512K I2C CMOS Serial EEPROM |
| 24FC515 | 512K I2C CMOS Serial EEPROM |
| 24AA515 | 512K I2C CMOS Serial EEPROM |
| 24LC515 | 512K I2C CMOS Serial EEPROM |
| 24FC65-IP | 64K 5.0V 1 MHz I 2 C Smart Serial EEPROM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 24AA512/S16K | 制造商:Microchip Technology Inc 功能描述:512K, 64K X 8, 1.8V SER EE,DIE - Gel-pak, waffle pack, wafer, diced wafer on film |
| 24AA512/W16K | 制造商:Microchip Technology Inc 功能描述:512K, 64K X 8, 1.8V SER EE,WAFER - Gel-pak, waffle pack, wafer, diced wafer on film |
| 24AA512/WF16K | 制造商:Microchip Technology Inc 功能描述:512K, 64K X 8, 1.8V SER EE,WAF - Gel-pak, waffle pack, wafer, diced wafer on film |
| 24AA512-I/MF | 功能描述:電可擦除可編程只讀存儲器 64kx8 - 1.8V RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
| 24AA512-I/MS | 制造商:Microchip Technology Inc 功能描述:512K, 64K X 8, 1.8V SER EE, IND - Rail/Tube 制造商:Microchip Technology Inc 功能描述:IC EEPROM 512KBIT 400KHZ 8MSOP 制造商:Microchip Technology Inc 功能描述:512K, 64K X 8, 1.8V SER EE, IND, 8 MSOP 3x3mm TUBE |
發布緊急采購，3分鐘左右您將得到回復。