- 您現在的位置：買賣IC網 > PDF目錄371438 > 29F001T-90 (Macronix International Co., Ltd.) 1M-BIT [128K x 8] CMOS FLASH MEMORY PDF資料下載
參數資料
| 型號： | 29F001T-90 |
| 廠商： | Macronix International Co., Ltd. |
| 英文描述： | 1M-BIT [128K x 8] CMOS FLASH MEMORY |
| 中文描述： | 100萬位[128K的× 8]的CMOS閃存 |
| 文件頁數： | 12/42頁 |
| 文件大?。?/td> | 600K |
| 代理商： | 29F001T-90 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁
12
REV. 2.6, DEC. 29, 2003
P/N: PM0515
MX29F001T/B
WRITE PULSE "GLITCH" PROTECTION
Noise pulses of less than 5ns(typical) on CE or WE will
not initiate a write cycle.
LOGICAL INHIBIT
Writing is inhibited by holding any one of OE = VIL, CE =
VIH or WE = VIH. To initiate a write cycle CE and WE
must be a logical zero while OE is a logical one.
POWER SUPPLY DECOUPLING
In order to reduce power switching effect, each device
should have a 0.1uF ceramic capacitor connected be-
tween its VCC and GND. (Using a 10uF bulk capacitor
connected for high current condition is available if nec-
essary.)
CHIP PROTECTION WITH 12V SYSTEM
The MX29F001T/B features hardware chip protection.
Which will disable both program and erase operations.
To activate this mode, the programming equipment must
force VID on address pin A9 and control pin OE, (sug-
gest VID=12V) A6=VIL and CE=VIL.(see Table 2) Pro-
gramming of the protection circuitry begins on the falling
edge of the WE pulse and is terminated with the rising
edge of the same. Please refer to chip protect algorithm
and waveform.
To verify programming of the protection circuitry, the pro-
gramming equipment must force VID on address pin A9
( with CE and OE at VIL and WE at VIH. When A1=1, it
will produce a logical "1" code at device output Q0 for
the protected status. Otherwise the device will produce
00H for the unprotected status. In this mode, the ad-
dress, except for A1, are don't care. Address locations
with A1 = VIL are reserved to read manufacturer and
device codes.(Read Silicon ID)
It is also possible to determine if the chip is protected in
the system by writing a Read Silicon ID command. Per-
forming a read operation with A1=VIH, it will produce a
logical "1" at Q0 for the protected status.
CHIP UNPROTECT WITH 12V SYSTEM
The MX29F001T/B also features the chip unprotect
mode, so that all sectors are unprotected after chip
unprotect completion to incorporate any changes in the
code.
To activate this mode, the programming equipment must
force VID on control pin OE and address pin A9. The CE
pins must be set at VIL. Pins A6 must be set to VIH.(see
Table 2) Refer to chip unprotect algorithm and wave-
form for the chip unprotect algorithm. The unprotection
mechanism begins on the falling edge of the WE pulse
and is terminated with the rising edge of the same.
It is also possible to determine if the chip is unprotected
in the system by writing the Read Silicon ID command.
Performing a read operation with A1=VIH, it will produce
00H at data outputs (Q0-Q7) for an unprotected sector. It
is noted that all sectors are unprotected after the chip
unprotect algorithm is completed.
CHIP PROTECTION WITHOUT 12V SYSTEM
The MX29F001T/B also feature a hardware chip protec-
tion method in a system without 12V power supply. The
programming equipment do not need to supply 12 volts
to protect all sectors. The details are shown in chip pro-
tect algorithm and waveform.
CHIP UNPROTECT WITHOUT 12V SYSTEM
The MX29F001T/B also feature a hardware chip
unprotection method in a system without 12V power sup-
ply. The programming equipment do not need to supply
12 volts to unprotect all sectors. The details are shown
in chip unprotect algorithm and waveform.
POWER-UP SEQUENCE
The MX29F001T/B powers up in the Read only mode. In
addition, the memory contents may only be altered after
successful completion of the predefined command se-
quences.
相關PDF資料 |
PDF描述 |
|---|---|
| 29F002B-12 | 2M-BIT [256K x 8] CMOS FLASH MEMORY |
| 29F002B-55 | 2M-BIT [256K x 8] CMOS FLASH MEMORY |
| 29F002B-70 | 2M-BIT [256K x 8] CMOS FLASH MEMORY |
| 29F002B-90 | 2M-BIT [256K x 8] CMOS FLASH MEMORY |
| 29F002T-12 | 2M-BIT [256K x 8] CMOS FLASH MEMORY |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 29F002 | 制造商:MCNIX 制造商全稱:Macronix International 功能描述:2M-BIT [256K x 8] CMOS FLASH MEMORY |
| 29F002B-12 | 制造商:MCNIX 制造商全稱:Macronix International 功能描述:2M-BIT [256K x 8] CMOS FLASH MEMORY |
| 29F002B-55 | 制造商:MCNIX 制造商全稱:Macronix International 功能描述:2M-BIT [256K x 8] CMOS FLASH MEMORY |
| 29F002B-70 | 制造商:MCNIX 制造商全稱:Macronix International 功能描述:2M-BIT [256K x 8] CMOS FLASH MEMORY |
| 29F002B-90 | 制造商:MCNIX 制造商全稱:Macronix International 功能描述:2M-BIT [256K x 8] CMOS FLASH MEMORY |
發布緊急采購，3分鐘左右您將得到回復。