參數資料
型號: 73K224L-IH
廠商: TDK Corporation
英文描述: V.22bis/V.22/V.21/ Bell 212A/Bell 103 Single-Chip Modem
中文描述: V.22bis/V.22/V.21 /貝爾212A/Bell 103單芯片調制解調器
文件頁數: 4/32頁
文件大?。?/td> 206K
代理商: 73K224L-IH
73K224L
V.22bis/V.22/V.21/Bell 212A/Bell 103
Single-Chip Modem
4
PIN DESCRIPTION
POWER
NAME
GND
TYPE
I
DESCRIPTION
System Ground.
VDD
I
Power supply input, 5V -5% +10%. Bypass with 0.22 μF and 22 μF capacitors to
GND.
VREF
O
An internally generated reference voltage. Bypass with 0.22 μF capacitor to
GND.
ISET
I
Chip current reference. Sets bias current for op-amps. The chip current is set by
connecting this pin to VDD through a 2 M
resistor. Iset should be bypassed to
GND with a 0.22 μF capacitor.
PARALLEL MICROPROCESSOR INTERFACE
ALE
I
Address latch enable. The falling edge of ALE latches the address on AD0-AD2
and the chip select on
CS
.
AD0- AD7
I/O
/Tristate
Address/data bus. These bidirectional tri-state multiplexed lines carry infor-
mation to and from the internal registers.
CS
I
Chip select. A low on this pin allows a read cycle or a write cycle to occur. AD0-
AD7 will not be driven and no registers will be written if
CS
(latched) is not active.
CS
is latched on the falling edge of ALE.
CLK
O
Output clock. This pin is selectable under processor control to be either the
crystal frequency (for use as a processor clock) or 16 x the data rate for use as a
baud rate clock in QAM/DPSK modes only. The pin defaults to the crystal
frequency on reset.
INT
O
Interrupt. This open drain /weak pull-up, output signal is used to inform the
processor that a detect flag has occurred. The processor must then read the
detect register to determine which detect triggered the interrupt.
INT
will stay
active until the processor reads the detect register or does a full reset.
RD
I
Read. A low requests a read of the 73K224L internal registers. Data cannot be
output unless both
RD
and the latched
CS
are active or low.
RESET
I
Reset. An active high signal on this pin will put the chip into an inactive state. All
control register bits (CR0, CR1, CR2, CR3, Tone) will be reset. The output of the
CLK pin will be set to the crystal frequency. An internal pull down resistor permits
power on reset using a capacitor to VDD.
WR
I
Write. A low on this informs the 73K224L that data is available on AD0-AD7 for
writing into an internal register. Data is latched on the rising edge of
WR
. No data
is written unless both
WR
and the latched
CS
are active (low).
NOTE: The serial control mode is provided by tying ALE high and
CS
low. In this configuration AD7 becomes
DATA and AD0, AD1 and AD2 become the address only.
相關PDF資料
PDF描述
73K224L-IP V.22bis/V.22/V.21/ Bell 212A/Bell 103 Single-Chip Modem
73K321L-IH CCITT V.23, V.21 Single-Chip Modem
73K321L-IP CCITT V.23, V.21 Single-Chip Modem
73K321L Miniature Switch, High Precision
73K322L-IH CCITT V.23, V.22, V.21 Single-Chip Modem
相關代理商/技術參數
參數描述
73K224L-IH/F 功能描述:電信集成電路 Single Chip Modem w/Integrated Hybrid RoHS:否 制造商:STMicroelectronics 類型:Telecom IC - Various 工作電源電壓:4.75 V to 5.25 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-100 封裝:Tray
73K224L-IHR/F 功能描述:電信集成電路 Single Chip Modem w/Integrated Hybrid RoHS:否 制造商:STMicroelectronics 類型:Telecom IC - Various 工作電源電壓:4.75 V to 5.25 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-100 封裝:Tray
73K224L-IP 功能描述:電信集成電路 RoHS:否 制造商:STMicroelectronics 類型:Telecom IC - Various 工作電源電壓:4.75 V to 5.25 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-100 封裝:Tray
73K224L-IP/F 功能描述:電信集成電路 RoHS:否 制造商:STMicroelectronics 類型:Telecom IC - Various 工作電源電壓:4.75 V to 5.25 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-100 封裝:Tray
73K244L-IP 制造商:TDK 功能描述:Single Chip Modem