參數資料
型號: 73S1215F-44IMR/F/P
廠商: Maxim Integrated Products
文件頁數: 78/136頁
文件大?。?/td> 0K
描述: IC SMART CARD READER PROG 44-QFN
產品培訓模塊: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝: 2,500
系列: 73S12xx
核心處理器: 80515
芯體尺寸: 8-位
速度: 24MHz
連通性: I²C,智能卡,UART/USART,USB
外圍設備: LED,POR,WDT
輸入/輸出數: 9
程序存儲器容量: 64KB(64K x 8)
程序存儲器類型: 閃存
RAM 容量: 2K x 8
電壓 - 電源 (Vcc/Vdd): 2.7 V ~ 5.5 V
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 44-VFQFN 裸露焊盤
包裝: 帶卷 (TR)
73S1215F Data Sheet
DS_1215F_003
46
Rev. 1.4
Table 42: Timers/Counters Mode Description
M1
M0
Mode
Function
0
Mode 0
13-bit Counter/Timer.
0
1
Mode 1
16-bit Counter/Timer.
1
0
Mode 2
8-bit auto-reload Counter/Timer.
1
Mode 3
If Timer 1 M1 and M0 bits are set to '1', Timer 1 stops. If Timer 0 M1
and M0 bits are set to '1', Timer 0 acts as two independent 8-bit
Timer/Counters.
Mode 0
Putting either timer/counter into mode 0 configures it as an 8-bit timer/counter with a divide-by-32
prescaler. In this mode, the timer register is configured as a 13-bit register. As the count rolls over from
all 1’s to all 0’s, it sets the timer overflow flag TF0. The overflow flag TF0 then can be used to request an
interrupt. The counted input is enabled to the timer when TRx = 1 and either GATE = 0 or TX = 1 (setting
GATE = 1 allows the timer to be controlled by external input TX, to facilitate pulse width measurements).
TRx are control bits in the special function register TCON; GATE is in TMOD. The 13-bit register consists
of all 8 bits of TH1 and the lower 5 bits of TL0. The upper 3 bits of TL0 are indeterminate and should be
ignored. Setting the run flag (TRx) does not clear the registers. Mode 0 operation is the same for timer 0
as for timer 1.
Mode 1
Mode 1 is the same as mode 0, except that the timer register is run with all 16 bits.
Mode 2
Mode 2 configures the timer register as an 8-bit counter (TLx) with automatic reload. The overflow from
TLx not only sets TFx, but also reloads TLx with the contents of THx, which is preset by software. The
reload leaves THx unchanged.
Mode 3
Mode 3 has different effects on timer 0 and timer 1. Timer 1 in mode 3 simply holds its count. The effect
is the same as setting TR1 = 0. Timer 0 in mode 3 establishes TL0 and TH0 as two separate counters.
TL0 uses the timer 0 control bits: C/T, GATE, TR0, INT0, and TF0. TH0 is locked into a timer function
(counting machine cycles) and takes over the use of TR1 and TF1 from timer 1. Thus, TH0 now controls
the "timer 1" interrupt. Mode 3 is provided for applications requiring an extra 8-bit timer or counter. When
timer 0 is in mode 3, timer 1 can be turned on and off by switching it out of and into its own mode 3, or
can still be used by the serial channel as a baud rate generator, or in fact, in any application not requiring
an interrupt from timer 1 itself.
相關PDF資料
PDF描述
73S1215F-44IM/F/P IC SMART CARD READER PROG 44-QFN
73S1210F-68IM/F/P IC SMART CARD READER PROG 68-QFN
73S1210F-44IMR/F/P IC SMART CARD READER PROG 44-QFN
MAXQ613E-0000+ IC MCU 16BIT IR MOD 32LQPF
73S1210F-44IM/F/P IC SMART CARD READER PROG 44-QFN
相關代理商/技術參數
參數描述
73S1215F-44MR/F/PC 制造商:Maxim Integrated Products 功能描述:MXM73S1215F-44MR/F/PC SCR +PIN PAD, SRL
73S1215F-68IM/F 功能描述:8位微控制器 -MCU 80515 SoC w/USB & PINpad RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
73S1215F-68IM/F/P 功能描述:IC SMART CARD READER PROG 68-QFN RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:73S12xx 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:260 系列:73S12xx 核心處理器:80515 芯體尺寸:8-位 速度:24MHz 連通性:I²C,智能卡,UART/USART,USB 外圍設備:LED,POR,WDT 輸入/輸出數:9 程序存儲器容量:64KB(64K x 8) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:2K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:68-VFQFN 裸露焊盤 包裝:管件
73S1215F-68IM/F/PB 功能描述:8位微控制器 -MCU 73S1215F-68IM/F WITH FACTORY LOADED FIRMW RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
73S1215F68IMLV1.15 制造商:Maxim Integrated Products 功能描述:8-bit Microcontrollers - MCU 80515 SoC w/USB & PINpad