2009 Teridian Semiconductor Corporation Rev 1.3 MR0:" />
參數資料
型號： 78Q2120C09-CGTR/F
廠商： Maxim Integrated
文件頁數： 3/35頁
文件大?。?/td> 0K
描述： IC TXRX 10/100BASE-TX 64LQFP
標準包裝： 1,500
系列： *
78Q2120C
10/100BASE-TX
Transceiver
Page: 11 of 35
2009 Teridian Semiconductor Corporation
Rev 1.3
MR0: Control Register
BIT
SYMBOL TYPE DEFAULT DESCRIPTION
0.15
RESET
R/SC
0
Reset: Setting this bit to ‘1’ resets the device and sets all registers
to their default states. This bit is self-clearing.
0.14
LOOPBK
R/W
0
Loopback: When this bit is set to ‘1’, no transmission of data on the
network medium occurs and any receive data on the network
medium is ignored. The loopback signal path will encompass most
of the digital circuitry.
0.13
SPEEDSL
R/W
(1)
Speed Selection: This bit determines the speed of operation of the
78Q2120C. Setting this bit to ‘1’ indicates 100Base-TX operation
and a ‘0’ indicates 10Base-T mode. This bit will default to a ‘1’ upon
reset. If the TECH[2:0] pins are all logic zero and auto-negotiation is
not enabled, this bit will be writeable. If auto-negotiation is not
enabled and the TECH[2:0] pins are set to indicate that only
10Base-T is supported, this bit will be forced to logic zero and will
not be writeable.
If auto-negotiation is not enabled and the
TECH[2:0] pins are set to indicate that only 100Base-TX is
supported, this bit will be forced to logic one and will not be
writeable. When auto-negotiation is enabled, this bit will not be
writeable and will have no effect on the 78Q2120C.
If the
TECH[2:0] pins are brought to zero from another value, this bit will
retain its original value until it is overwritten.
0.12
ANEGEN
R/W
(1)
Auto-Negotiation Enable: Setting this bit to ‘1’ enables the auto-
negotiation process. This bit can only be set if the ANEGA pin is a
logic one and will default to ‘1’ upon reset. If this bit is cleared to ‘0’,
manual speed and duplex mode selection is accomplished through
bits 0.13 (SPEEDSL) and 0.8 (DUPLEX) of the Control Register or
the TECH[2:0] pins according to the table shown in the section
describing the TECH[2:0] pins. If the ANEGA pin is brought from ‘0’
to ‘1’ and reset is not asserted, this bit will remain at ‘0’ until a ‘1’ is
written.
0.11
PWRDN
R/W
0
Power-Down:
The device may be placed in a low power
consumption state by setting this bit to ‘1’. While in the power-down
state, the device will still respond to management transactions.
Setting the PWRDN pin high also activates the power-down state.
0.10
ISO
R/W
(0)
Isolate: When set to ‘1’, the device presents a high-impedance on
its MII output pins. This allows for multiple PHY’s to be attached to
the same MII interface. When the device is isolated, it still responds
to management transactions. The default value of this bit depends
on the ISODEF pin. When ISODEF pin is tied high, the ISO bit
defaults to high. Otherwise, it defaults to low. The Isolate mode can
also be activated using the ISO pin.
0.9
RANEG
R/SC
0
Restart Auto-Negotiation: Normally, the Auto-Negotiation process is
started at power up. The process can be restarted by setting this bit
to ‘1’. This bit is self-clearing.
相關PDF資料
PDF描述
T95S224K035LZAL CAP TANT 0.22UF 35V 10% 1507
FIN3.50RD FIREFLEX FIBERGLASS 3.5" RED 50'
UH4PDC-M3/87A DIODE 4A 200V 25NS DUAL TO277A
V48C48H75B2 CONVERTER MOD DC/DC 48V 75W
V48C48H75B CONVERTER MOD DC/DC 48V 75W
相關代理商/技術參數
參數描述
78Q2120C09-DB 功能描述:以太網開發工具 78Q2120C09 Demo Boa RoHS:否 制造商:Micrel 產品:Evaluation Boards 類型:Ethernet Transceivers 工具用于評估:KSZ8873RLL 接口類型:RMII 工作電源電壓:
78Q2120-CGT 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10/100BASE-TX Ethernet Transceiver
78Q2123 制造商:TERIDIAN 制造商全稱:TERIDIAN 功能描述:10/100BASE-TX Transceiver
78Q2123/F 功能描述:以太網 IC 10/100 Fast Ethernet MicroPHY RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray
78Q2123/F1 功能描述:以太網 IC RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*