參數資料
型號： 935257900551
廠商： NXP SEMICONDUCTORS
元件分類： 顏色信號轉換
英文描述： COLOR SIGNAL ENCODER, PQCC84
封裝： PLASTIC, SOT-189-2, LCC-84
文件頁數： 41/42頁
文件大小： 289K
代理商： 935257900551
1996 Jul 08
8
Philips Semiconductors
Preliminary specication
Digital Video Encoder (EURO-DENC)
SAA7182; SAA7183
FUNCTIONAL DESCRIPTION
The digital video encoder (EURO-DENC) encodes digital
luminance and colour difference signals into analog CVBS
and simultaneously S-Video signals. NTSC-M, PAL B/G
and SECAM standards and sub-standards are supported.
Both interlaced and non-interlaced operation is possible
for all standards.
In addition to RED, GREEN and BLUE converted
components, the dematrixed YUV input is available on
three separate analog outputs.
The basic encoder function consists of subcarrier
generation and colour modulation also insertion of
synchronization signals. Luminance and chrominance
signals are filtered in accordance with the standard
requirements of RS-170-A and
“CCIR 624”.
For ease of analog post filtering the signals are twice
oversampled with respect to the pixel clock before
digital-to-analog conversion.
For total filter transfer characteristics see
Figs 3, 4, 5, 6, 7 and 8. The DACs for Y, C and CVBS are
realized with full 10-bit resolution, DACs for RGB are with
9-bit resolution.
The MPEG port (MP) accept 8 lines multiplexed Cb-Y-Cr
data.
The 8-bit multiplexed Cb-Y-Cr formats are
“CCIR 656”
(D1 format) compatible, but the SAV, EAV etc. codes are
not decoded.
Alternatively, 8-bits Y on MP port and 8-bit multiplexed Cb,
Cr on DP port can be chosen as input.
A crystal-stable master clock (LLC) of 27 MHz, which is
twice the CCIR line-locked pixel clock of 13.5 MHz, needs
to be supplied externally. Optionally, a crystal oscillator
input/output pair of pins and an on-chip clock driver is
provided.
It is also possible to connect a Philips Digital Video
Decoder (SAA7111 or SAA7151B) in conjunction with a
CREF clock qualifier to EURO-DENC. Via RTCI pin
connected to RTCO of a decoder, information concerning
actual subcarrier, PAL-ID (see
“data sheet SAA7111” )
definite subcarrier phase can be inserted.
The EURO-DENC synthesizes all necessary internal
signals, colour subcarrier frequency, and synchronization
signals, from that clock. The encoder is always timing
master for the MPEG port (MP), but it can additionally be
configured as slave with respect to the RCV trigger inputs.
European teletext encoding is supported if an appropriate
teletext bitstream is applied to the TTX pin.
The IC also contains Closed Caption and Extended Data
Services Encoding (Line 21), and supports anti-taping
signal generation in accordance with Macrovision; it also
supports overlay via KEY and three control bits by a 24
× 8
LUT.
A number of possibilities are provided for setting of
different video parameters such as:
Black and blanking level control
Colour subcarrier frequency
Variable burst amplitude etc.
During reset (RESET = LOW) and after reset is released,
all digital I/O stages are set to input mode. A reset forces
the I2C-bus interface to abort any running bus transfer and
sets register 3A to 03H, register 61 to 06H and
registers 6BH and 6EH to 00H. All other control registers
are not influenced by a reset.
Data manager
In the data manager, real time arbitration on the data
stream to be encoded is performed.
Depending on the polarity of pin KEY, the MP input
(or MP/DP input) or OVL input are selected to be encoded
to CVBS and Y/C signals, and output as RGB.
KEY controls OVL entries of a programmable LUT for
encoded signals and for RGB output. The common KEY
switching signal can be disabled by software for the
signals to be encoded (Y, C and CVBS), such that OVL will
appear on RGB outputs, but not on Y, C and CVBS.
OVL input under control of KEY can be also used to insert
decoded teletext information or other on-screen data.
Optionally, the OVL colour LUTs located in this block, can
be read out in a pre-defined sequence (8 steps per active
video line), achieving, for example, a colour bar test
pattern generator without need for an external data
source. The colour bar function is only under software
control.
相關PDF資料
PDF描述
935257900557 COLOR SIGNAL ENCODER, PQCC84
935260050118 QUAD 1-CHANNEL, SGL POLE SGL THROW SWITCH, PDSO14
935260050112 QUAD 1-CHANNEL, SGL POLE SGL THROW SWITCH, PDSO14
933372970653 QUAD 1-CHANNEL, SGL POLE SGL THROW SWITCH, PDSO14
933296650652 QUAD 1-CHANNEL, SGL POLE SGL THROW SWITCH, PDIP14
相關代理商/技術參數
參數描述
935260093112 制造商:NXP Semiconductors 功能描述:IC AVIC ADV BASESTATION 14SOIC
935261069122 制造商:NXP Semiconductors 功能描述:IC SECURITY TRANSPONDER PLLMC
935262025112 制造商:NXP Semiconductors 功能描述:SUB ONLY IC
935262217118 制造商:NXP Semiconductors 功能描述:Real Time Clock Serial 8-Pin SO T/R
935264217557 制造商:NXP Semiconductors 功能描述:SUB ONLY IC
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*