- 您現在的位置：買賣IC網 > PDF目錄4175 > A1225A-1PQG100I (Microsemi SoC)IC FPGA 2500 GATES 100-PQFP IND PDF資料下載
參數資料
| 型號： | A1225A-1PQG100I |
| 廠商： | Microsemi SoC |
| 文件頁數： | 2/54頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC FPGA 2500 GATES 100-PQFP IND |
| 產品變化通告： | A1225A Family Discontinuation 18/Apr/2012 |
| 標準包裝： | 66 |
| 系列： | ACT™ 2 |
| LAB/CLB數： | 451 |
| 輸入/輸出數： | 83 |
| 門數： | 2500 |
| 電源電壓： | 4.5 V ~ 5.5 V |
| 安裝類型： | 表面貼裝 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 100-BQFP |
| 供應商設備封裝： | 100-PQFP（14x20） |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁
Detailed Specifications
2- 4
R e v ision 8
Static Power Component
Microsemi FPGAs have small static power components that result in lower power dissipation than PALs
or PLDs. By integrating multiple PALs/PLDs into one FPGA, an even greater reduction in board-level
power dissipation can be achieved.
The power due to standby current is typically a small component of the overall power. Standby power is
calculated in Table 2-5 for commercial, worst case conditions.
The static power dissipated by TTL loads depends on the number of outputs driving high or low and the
DC load current. Again, this value is typically small. For instance, a 32-bit bus sinking 4 mA at 0.33 V will
generate 42 mW with all outputs driving low, and 140 mW with all outputs driving high. The actual
dissipation will average somewhere between as I/Os switch states with time.
Active Power Component
Power dissipation in CMOS devices is usually dominated by the active (dynamic) power dissipation. This
component is frequency dependent, a function of the logic and the external I/O. Active power dissipation
results from charging internal chip capacitances of the interconnect, unprogrammed antifuses, module
inputs, and module outputs, plus external capacitance due to PC board traces and load device inputs.
An additional component of the active power dissipation is the totem-pole current in CMOS transistor
pairs. The net effect can be associated with an equivalent capacitance that can be combined with
frequency and voltage to represent active power dissipation.
Equivalent Capacitance
The power dissipated by a CMOS circuit can be expressed by EQ 3.
Power (W) = CEQ * VCC2 * F
EQ 3
Where:
CEQ is the equivalent capacitance expressed in pF.
VCC is the power supply in volts.
F is the switching frequency in MHz.
Equivalent capacitance is calculated by measuring ICC active at a specified frequency and voltage for
each circuit component of interest. Measurements have been made over a range of frequencies at a
fixed value of VCC. Equivalent capacitance is frequency independent so that the results may be used
over a wide range of operating conditions. Equivalent capacitance values are shown in Table 2-6.
Table 2-5 Standby Power Calculation
ICC
VCC
Power
2 mA
5.25 V
10.5 mW
Table 2-6 CEQ Values for Microsemi FPGAs
Item
CEQ Value
Modules (CEQM)
5.8
Input Buffers (CEQI)
12.9
Output Buffers (CEQO)
23.8
Routed Array Clock Buffer Loads (CEQCR)3.9
相關PDF資料 |
PDF描述 |
|---|---|
| IDT71V416L15BEGI8 | IC SRAM 4MBIT 15NS 48FBGA |
| XC4025E-2HQ240C | IC FPGA 1024 CLB'S 240-HQFP |
| IDT71V416L12BEGI8 | IC SRAM 4MBIT 12NS 48FBGA |
| XC4020E-3HQ240C | IC FPGA 784 CLB'S 240-HQFP |
| XC4020E-2HQ240C | IC FPGA 784 CLB'S 240-HQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| A1225A-1TQ176B | 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:ACT2 Family FPGAs |
| A1225A-1TQ176C | 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:ACT2 Family FPGAs |
| A1225A-1TQ176I | 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:ACT2 Family FPGAs |
| A1225A-1TQ176M | 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:ACT2 Family FPGAs |
| A1225A-1VQ176B | 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:ACT2 Family FPGAs |
發布緊急采購，3分鐘左右您將得到回復。