參數資料
型號: A14100A-1CQ256C
廠商: Microsemi SoC
文件頁數: 13/90頁
文件大?。?/td> 0K
描述: IC FPGA 10K GATES 256-CQFP
標準包裝: 1
系列: ACT™ 3
LAB/CLB數: 1377
輸入/輸出數: 228
門數: 10000
電源電壓: 4.5 V ~ 5.5 V
安裝類型: 表面貼裝
工作溫度: 0°C ~ 70°C
封裝/外殼: 256-BFCQFP,帶拉桿
供應商設備封裝: 256-CQFP(75x75)
Detailed Specifications
2- 12
R e visio n 3
Power Dissipation
P = [ICC standby + Iactive] * VCC * IOL * VOL * N + IOH* (VCC – VOH) * M
EQ 3
where:
ICC standby is the current flowing when no inputs or outputs are changing
Iactive is the current flowing due to CMOS switching.
IOL and IOH are TTL sink/source current.
VOL and VOH are TTL level output voltages.
N is the number of outputs driving TTL loads to VOL.
M equals the number of outputs driving TTL loads to VOH.
An accurate determination of N and M is problematical because their values depend on the design and
on the system I/O. The power can be divided into two components: static and active.
Static Power Component
Microsemi FPGAs have small static power components that result in lower power dissipation than PALs
or PLDs. By integrating multiple PALs/PLDs into one FPGA, an even greater reduction in board-level
power dissipation can be achieved.
The power due to standby current is typically a small component of the overall power. Standby power is
calculated in Table 2-9 for commercial, worst case conditions.
The static power dissipated by TTL loads depends on the number of outputs driving high or low and the
DC load current. Again, this value is typically small. For instance, a 32-bit bus sinking 4 mA at 0.33 V will
generate 42 mW with all outputs driving low, and 140 mW with all outputs driving high. The actual
dissipation will average somewhere between as I/Os switch states with time.
Active Power Component
Power dissipation in CMOS devices is usually dominated by the active (dynamic) power dissipation. This
component is frequency dependent, a function of the logic and the external I/O. Active power dissipation
results from charging internal chip capacitances of the interconnect, unprogrammed antifuses, module
inputs, and module outputs, plus external capacitance due to PC board traces and load device inputs.
An additional component of the active power dissipation is the totem-pole current in CMOS transistor
pairs. The net effect can be associated with an equivalent capacitance that can be combined with
frequency and voltage to represent active power dissipation.
Equivalent Capacitance
The power dissipated by a CMOS circuit can be expressed by EQ 4.
Power (W) = CEQ * VCC
2 * F
EQ 4
Where:
CEQ is the equivalent capacitance expressed in pF.
VCC is the power supply in volts.
F is the switching frequency in MHz.
Table 2-9 Standby Power Calculation
ICC
VCC
Power
2 mA
5.25 V
10.5 mW
相關PDF資料
PDF描述
EP1S40B956C5 IC STRATIX FPGA 40K LE 956-BGA
EP1S40B956I6 IC STRATIX FPGA 40K LE 956-BGA
EP1S40F1508C5 IC STRATIX FPGA 40K LE 1508-FBGA
A54SX32-1CQ208 IC FPGA SX 48K GATES 208-CQFP
93C56B-I/MS IC EEPROM 2KBIT 2MHZ 8MSOP
相關代理商/技術參數
參數描述
A14100A-1CQ256E 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:HiRel FPGAs
A14100A-1CQ256M 制造商:Microsemi Corporation 功能描述:FPGA ACT 3 Family 10K Gates 1377 Cells 125MHz 0.8um Technology 5V 256-Pin CQFP 制造商:Microsemi Corporation 功能描述:FPGA ACT 3 10K GATES 1377 CELLS 125MHZ 0.8UM 5V 256CQFP - Trays 制造商:Microsemi Corporation 功能描述:IC FPGA 10K GATES 256-CQFP MIL
A14100A-1PG256B 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:HiRel FPGAs
A14100A-1PG256C 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:HiRel FPGAs
A14100A-1PG256E 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:HiRel FPGAs