- 您現在的位置：買賣IC網 > PDF目錄1888 > AD1928YSTZ (Analog Devices Inc)IC CODEC 2ADC 8DAC W/PLL 48LQFP PDF資料下載
參數資料
| 型號： | AD1928YSTZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 6/32頁 |
| 文件大小： | 0K |
| 描述： | IC CODEC 2ADC 8DAC W/PLL 48LQFP |
| 標準包裝： | 1 |
| 類型： | 通用 |
| 數據接口： | 串行 |
| 分辨率（位）： | 24 b |
| ADC / DAC 數量： | 2 / 8 |
| 三角積分調變： | 是 |
| S/N 比，標準 ADC / DAC (db)： | 94 / 94 |
| 動態范圍，標準 ADC / DAC (db)： | 105 / 108 |
| 電壓 - 電源，模擬： | 3 V ~ 3.6 V |
| 電壓 - 電源，數字： | 3 V ~ 3.6 V |
| 工作溫度： | -40°C ~ 105°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 48-LQFP |
| 供應商設備封裝： | 48-LQFP（7x7） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
AD1928
Rev. B | Page 14 of 32
ground connections with other unrelated digital output signals.
When the PLL is used, jitter in the reference clock is attenuated
above a certain frequency depending on the loop filter.
RESET AND POWER-DOWN
The function of the RST pin sets all the control registers to
their default settings. To avoid pops, reset does not power
down the analog outputs. After RST is deasserted and the PLL
acquires lock condition, an initialization routine runs inside the
AD1928. This initialization lasts for approximately 256 master
clock cycles.
The power-down bits in the PLL and Clock Control 0, DAC
Control 1, and ADC Control 1 registers power down the
respective sections. All other register settings are retained. The
reset pin, PD/RST, should be pulled low by an external resistor
to guarantee proper startup.
SERIAL CONTROL PORT
The AD1928 has an SPI control port that permits programming
and reading back of the internal control registers for the ADCs,
DACs, and clock system. There is also a standalone mode
available for operation without serial control that is configured
at reset using the serial control pins. All registers are set to
default, except the internal master clock enable is set to 1
and ADC BCLK and LRCLK master/slave is set by the COUT
pin. Standalone mode only supports stereo mode with an I2S
details. It is recommended to use a weak pull-up resistor on
CLATCH in applications that have a microcontroller. This pull-
up resistor ensures that the AD1928 recognizes the presence of
a microcontroller.
The SPI control port of the AD1928 is a 4-wire serial control
port. The format is similar to the Motorola SPI format, except
the input data-word is 24 bits wide. The serial bit clock and
latch can be completely asynchronous to the sample rate of the
ADCs and DACs. Figure 11 shows the format of the SPI signal.
The first byte is a global address with a read/write bit. For the
AD1928, the address is 0x04, shifted left 1 bit due to the R/W
bit. The second byte is the AD1928 register address and the
third byte is the data.
Table 11. Standalone Mode Selection
ADC Clocks
CIN
COUT
CCLK
CLATCH
Slave
0
Master
0
1
0
D0
D8
D22
D23
D9
CLATCH
CCLK
CIN
COUT
tCCH tCCL
tCDS tCDH
tCLS
tCCP
tCLH
tCOTS
tCOD
tCOE
06
62
3-
0
11
Figure 11. Format of SPI Signal
相關PDF資料 |
PDF描述 |
|---|---|
| AD1933WBSTZ-RL | IC DAC 24BIT SRL/SPI 64LQFP |
| AD1934WBSTZ-RL | IC DAC 8CH W/ON-CHIP PLL 48LQFP |
| AD1937WBSTZ | IC CODEC 4/ADC DIFF OUT 64-LQFP |
| AD1938WBSTZ | IC CODEC 24BIT 4ADC/8DAC 48LQFP |
| AD1939WBSTZ-RL | AUDIO CODEC W/ON CHIP 4ADC 8DAC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD1928YSTZ-RL | 功能描述:IC CODEC 2ADC 8DAC W/PLL 48LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 編解碼器 系列:- 標準包裝:2,500 系列:- 類型:立體聲音頻 數據接口:串行 分辨率（位）:18 b ADC / DAC 數量:2 / 2 三角積分調變:是 S/N 比，標準 ADC / DAC (db):81.5 / 88 動態范圍，標準 ADC / DAC (db):82 / 87.5 電壓 - 電源，模擬:2.6 V ~ 3.3 V 電壓 - 電源，數字:1.7 V ~ 3.3 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-WFQFN 裸露焊盤 供應商設備封裝:48-TQFN-EP（7x7） 包裝:帶卷 (TR) |
| AD1933 | 制造商:AD 制造商全稱:Analog Devices 功能描述:8-Channel DAC with PLL and Differential Outputs, 192 kHz, 24 Bits |
| AD1933WBSTZ | 功能描述:IC DAC 24BIT SRL/SPI 64LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:1 系列:- 設置時間:4.5µs 位數:12 數據接口:串行，SPI? 轉換器數目:1 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOICN 包裝:剪切帶 (CT) 輸出數目和類型:1 電壓，單極；1 電壓，雙極 采樣率（每秒）:* 其它名稱:MCP4921T-E/SNCTMCP4921T-E/SNRCTMCP4921T-E/SNRCT-ND |
| AD1933WBSTZ-RL | 功能描述:IC DAC 24BIT SRL/SPI 64LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:LTC263x 12-, 10-, and 8-Bit VOUT DAC Family 特色產品:LTC2636 - Octal 12-/10-/8-Bit SPI VOUT DACs with 10ppm/°C Reference 標準包裝:91 系列:- 設置時間:4µs 位數:10 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:8 電壓電源:單電源 功率耗散（最大）:2.7mW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-DFN-EP（4x3） 包裝:管件 輸出數目和類型:8 電壓，單極 采樣率（每秒）:* |
| AD1933YSTZ | 功能描述:IC DAC 24BIT SRL/SPI 8CH RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:1 系列:- 設置時間:4.5µs 位數:12 數據接口:串行，SPI? 轉換器數目:1 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOICN 包裝:剪切帶 (CT) 輸出數目和類型:1 電壓，單極；1 電壓，雙極 采樣率（每秒）:* 其它名稱:MCP4921T-E/SNCTMCP4921T-E/SNRCTMCP4921T-E/SNRCT-ND |
發布緊急采購，3分鐘左右您將得到回復。