- 您現在的位置：買賣IC網 > PDF目錄1888 > AD1934WBSTZ-RL (Analog Devices Inc)IC DAC 8CH W/ON-CHIP PLL 48LQFP PDF資料下載
參數資料
| 型號： | AD1934WBSTZ-RL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 5/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DAC 8CH W/ON-CHIP PLL 48LQFP |
| 標準包裝： | 2,000 |
| 位數： | 24 |
| 數據接口： | 串行，SPI? |
| 轉換器數目： | 8 |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 105°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 48-LQFP |
| 供應商設備封裝： | 48-LQFP（7x7） |
| 包裝： | 帶卷 (TR) |
| 輸出數目和類型： | 8 電壓，單極 |
| 采樣率（每秒）： | * |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
Data Sheet
AD1934
Rev. D | Page 13 of 28
SERIAL CONTROL PORT
The AD1934 has an SPI control port that permits programming
and reading back of the internal control registers for the ADCs,
DACs, and clock system. A standalone mode is also available
for operation without serial control; standalone is configured
at reset by connecting CIN, CCLK, and CLATCH to ground.
In standalone mode, all registers are set to default, except the
internal MCLK enable, which is set to 1. The ADC ABCLK and
ALRCLK clock ports are set to master/slave by the connecting
the COUT pin to either DVDD or ground. Standalone mode
only supports stereo mode with an I2S data format and 256 fS
MCLK rate. Refer to Table 11 for details. If CIN, CCLK, and
CLATCH are not grounded, the AD1934 SPI port is active. It
is recommended to use a weak pull-up resistor on CLATCH in
applications that have a microcontroller. This pull-up resistor
ensures that the AD1934 recognizes the presence of a micro-
controller.
The SPI control port of the AD1934 is a 4-wire serial control
port. The format is similar to the Motorola SPI format except
the input data-word is 24 bits wide. The serial bit clock and
latch can be completely asynchronous to the sample rate of the
DACs. Figure 9 shows the format of the SPI signal. The first
byte is a global address with a read/write bit. For the AD1934,
the address is 0x04, shifted left 1 bit due to the R/W bit. The
second byte is the AD1934 register address and the third byte
is the data.
Table 11. SPI vs. Standalone Mode Configuration
DAC Control
COUT
CIN
CLATCH
CCLK
SPI
OUT
IN
1 (Pull-Up)
IN
Standalone
0
D0
D8
D22
D23
D9
CLATCH
CCLK
CIN
COUT
tCCH tCCL
tCDS tCDH
tCLS
tCCP
tCLH
tCOTS
tCOD
tCOE
06
10
6-
0
10
Figure 9. Format of SPI Signal
相關PDF資料 |
PDF描述 |
|---|---|
| AD1937WBSTZ | IC CODEC 4/ADC DIFF OUT 64-LQFP |
| AD1938WBSTZ | IC CODEC 24BIT 4ADC/8DAC 48LQFP |
| AD1939WBSTZ-RL | AUDIO CODEC W/ON CHIP 4ADC 8DAC |
| AD1953YSTZ | IC DSP DAC AUDIO3CH/26BIT 48LQFP |
| AD1954YSTZRL | IC DAC AUDIO 3CHAN 26BIT 48LQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD1934YSTZ | 功能描述:IC DAC 8CH W/ON-CHIP PLL 48LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 設置時間:4µs 位數:12 數據接口:串行 轉換器數目:2 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-uMAX 包裝:管件 輸出數目和類型:2 電壓，單極 采樣率（每秒）:* 產品目錄頁面:1398 (CN2011-ZH PDF) |
| AD1934YSTZ-RL | 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述: |
| AD1935 | 制造商:AD 制造商全稱:Analog Devices 功能描述:4 ADC/8 DAC with PLL, 192 kHz, 24 Bit CODEC |
| AD1935XSTZ | 制造商:AD 制造商全稱:Analog Devices 功能描述:4 ADC/8 DAC with PLL, 192 kHz, 24 Bit CODEC |
| AD1935XSTZRL | 制造商:AD 制造商全稱:Analog Devices 功能描述:4 ADC/8 DAC with PLL, 192 kHz, 24 Bit CODEC |
發布緊急采購，3分鐘左右您將得到回復。