- 您現在的位置：買賣IC網 > PDF目錄373877 > AD5343* (Analog Devices, Inc.) 2.5 V to 5.5 V. 230 uA. Parallel Interface Dual Voltage-Output 8-/10-/12-Bit DACs PDF資料下載
參數資料
| 型號： | AD5343* |
| 廠商： | Analog Devices, Inc. |
| 英文描述： | 2.5 V to 5.5 V. 230 uA. Parallel Interface Dual Voltage-Output 8-/10-/12-Bit DACs |
| 中文描述： | 2.5伏至5.5伏230微安。并行接口雙電壓輸出數模轉換器8-/10-/12-Bit |
| 文件頁數： | 18/20頁 |
| 文件大?。?/td> | 274K |
REV. 0
AD5332/AD5333/AD5342/AD5343
–
18
–
Coarse and Fine Adjustment Using the AD5332/AD5333/
AD5342/AD5343
The DACs in the AD5332/AD5333/AD5342/AD5343 can be
paired together to form a coarse and fine adjustment function,
as shown in Figure 39. DAC A is used to provide the coarse
adjustment while DAC B provides the fine adjustment. Varying
the ratio of R1 and R2 will change the relative effect of the coarse
and fine adjustments. With the resistor values shown the output
amplifier has unity gain for the DAC A output, so the output
range is 0 V to 2.5 V – 1 LSB. For DAC B the amplifier has a gain
of 7.6
×
10
–3
, giving DAC B a range equal to 2 LSBs of DAC A.
The circuit is shown with a 2.5 V reference, but reference volt-
ages up to V
DD
may be used. The op amps indicated will allow a
rail-to-rail output swing.
Note that the AD5343 has only a single reference input. If using
the AD5332, AD5333, or AD5342, both reference inputs must
be connected.
GND
V
DD
= 5V
EXT
REF
AD780/REF192
WITH V
DD
= 5V
V
IN
V
OUT
R2
51.2k
V
OUT
+5V
0.1 F
0.1 F
10 F
AD5332/AD5333/
AD5342/AD5343
GND
V
REF
A*
V
DD
V
OUT
A
R1
390
V
REF
B*
*NOT AD5343
V
OUT
B
R4
390
R3
51.2k
Figure 39. Coarse and Fine Adjustment
Power Supply Bypassing and Grounding
In any circuit where accuracy is important, careful consideration
of the power supply and ground return layout helps to ensure
the rated performance. The printed circuit board on which the
AD5332/AD5333/AD5342/AD5343 is mounted should be
designed so that the analog and digital sections are separated,
and confined to certain areas of the board. If the device is in a
system where multiple devices require an AGND-to-DGND
connection, the connection should be made at one point only.
The star ground point should be established as closely as pos-
sible to the device. The AD5332/AD5333/AD5342/AD5343
should have ample supply bypassing of 10
μ
F in parallel with
0.1
μ
F on the supply located as close to the package as pos-
sible, ideally right up against the device. The 10
μ
F capacitors
are the tantalum bead type. The 0.1
μ
F capacitor should have
low Effective Series Resistance (ESR) and Effective Series Induc-
tance (ESI), like the common ceramic types that provide a low
impedance path to ground at high frequencies to handle tran-
sient currents due to internal logic switching.
The power supply lines of the device should use as large a trace
as possible to provide low impedance paths and reduce the effects
of glitches on the power supply line. Fast switching signals such
as clocks should be shielded with digital ground to avoid radiat-
ing noise to other parts of the board, and should never be run
near the reference inputs. Avoid crossover of digital and ana-
log signals. Traces on opposite sides of the board should run
at right angles to each other. This reduces the effects of feed-
through through the board. A microstrip technique is by far
the best, but not always possible with a double-sided board. In
this technique, the component side of the board is dedicated to
ground plane while signal traces are placed on the solder side.
相關PDF資料 |
PDF描述 |
|---|---|
| AD5343 | 2.5 V to 5.5 V, 115 uA, Parallel Interface Single Voltage-Output 8-/10-/12-Bit DACs |
| AD5343BRU | Dual 12-bit 65MSPS ADC with serialized LVDS Output 48-VQFN -40 to 85 |
| AD5334BRU | 2.5 V to 5.5 V, 500 uA, Parallel Interface Quad Voltage-Output 8-/10-/12-Bit DACs |
| AD5327 | Dual-Channel 14bit, 65MSPS Analog-to-Digital Converter 80-HTQFP -40 to 85 |
| AD5338 | 2.5 V to 5.5 V, 250 UA, 2-Wire Interface Dual-Voltage Output, 8-/10-/12-Bit DACs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD5343BRU | 制造商:Analog Devices 功能描述:DAC 2-CH Resistor-String 12-bit 20-Pin TSSOP 制造商:Analog Devices 功能描述:12BIT DAC DUAL SMD 5343 TSSOP20 |
| AD5343BRU-REEL | 制造商:Analog Devices 功能描述:DAC 2-CH Resistor-String 12-bit 20-Pin TSSOP T/R |
| AD5343BRU-REEL7 | 制造商:Analog Devices 功能描述:DAC 2-CH Resistor-String 12-bit 20-Pin TSSOP T/R |
| AD5343BRUZ | 功能描述:IC DAC 12BIT DUAL VOUT 20TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 設置時間:4µs 位數:12 數據接口:串行 轉換器數目:2 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-uMAX 包裝:管件 輸出數目和類型:2 電壓，單極 采樣率（每秒）:* 產品目錄頁面:1398 (CN2011-ZH PDF) |
發布緊急采購，3分鐘左右您將得到回復。