- 您現在的位置：買賣IC網 > PDF目錄10684 > AD7790BRMZ (Analog Devices Inc)IC ADC 16BIT SIGMA-DELTA 10-MSOP PDF資料下載
參數資料
| 型號： | AD7790BRMZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 8/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 16BIT SIGMA-DELTA 10-MSOP |
| 標準包裝： | 50 |
| 位數： | 16 |
| 采樣率（每秒）： | 120 |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 230µW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 105°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 10-TFSOP，10-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 10-MSOP |
| 包裝： | 管件 |
| 輸入數目和類型： | 1 個差分，雙極 |
| 產品目錄頁面： | 779 (CN2011-ZH PDF) |
AD7790
Data Sheet
Rev. A | Page 16 of 20
Continuous Read Mode
Rather than write to the communications register each time a
conversion is complete to access the data, the AD7790 can be
placed in continuous read mode. By writing 001111XX to the
communications register, the user only needs to apply the
appropriate number of SCLK cycles to the ADC and the 16-bit
word will automatically be placed on the DOUT/RDY line
when a conversion is complete.
When DOUT/RDY goes low to indicate the end of a conver-
sion, sufficient SCLK cycles must be applied to the ADC and
the data conversion will be placed on the DOUT/RDY line.
When the conversion is read, DOUT/RDY will return high
until the next conversion is available. In this mode, the data can
be read only once. Also, the user must ensure that the data-
word is read
before the next conversion is complete. If the user has not read
the conversion before the completion of the next conversion or
if insufficient serial clocks are applied to the AD7790 to read
the word, the serial output register is reset when the next con-
version is complete and the new conversion is placed in the
output serial register.
To exit the continuous read mode, the instruction 001110XX
must be written to the communications register while the RDY
pin is low. While in the continuous read mode, the ADC
monitors activity on the DIN line so that it can receive the
instruction to exit the continuous read mode. Additionally, a
reset will occur if 32 consecutive 1s are seen on DIN. Therefore,
DIN should be held low in continuous read mode until an
instruction is to be written to the device.
03538-0-011
DIN
SCLK
DOUT/RDY
CS
0x3C
DATA
Figure 10. Continuous Read
相關PDF資料 |
PDF描述 |
|---|---|
| AD8611AR-REEL | IC COMP SNGL 4NS ULTRFAST 8-SOIC |
| AD7789BRMZ | IC ADC 24BIT LP 10-MSOP |
| LT1720CS8#TR | IC COMP DUAL R-R 4MA 4.5NS 8SOIC |
| LTC1445IS#TRPBF | IC COMP W/REF LOWPWR QUAD 16SOIC |
| CS5530-ISZ | IC ADC 24BIT 1CH W/LNA 20SSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7790BRMZ | 制造商:Analog Devices 功能描述:IC 24-BIT ADC |
| AD7790BRMZ-REEL | 功能描述:IC ADC 16BIT SIGMA-DELTA 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| AD7791 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Power, Buffered 24-Bit Sigma-Delta ADC |
| AD7791BRM | 功能描述:IC ADC 24BIT BUFFERED LP 10MSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| AD7791BRM-REEL | 制造商:Analog Devices 功能描述:ADC Single Delta-Sigma 120sps 24-bit Serial 10-Pin MSOP T/R 制造商:Analog Devices 功能描述:ADC SGL DELTA-SIGMA 0.12KSPS 24BIT SERL 10MSOP - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。