- 您現在的位置：買賣IC網 > PDF目錄9737 > AD7879-1ACPZ-500R7 (Analog Devices Inc)IC ADC 12BIT CTRLR TOUCH 16LFCSP PDF資料下載
參數資料
| 型號： | AD7879-1ACPZ-500R7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 25/41頁 |
| 文件大小： | 0K |
| 描述： | IC ADC 12BIT CTRLR TOUCH 16LFCSP |
| 標準包裝： | 1 |
| 類型： | 電阻 |
| 觸摸面板接口： | 4 線 |
| 輸入數/鍵： | 1 TSC |
| 分辨率（位）： | 12 b |
| 評估套件： | 可供 |
| 數據接口： | I²C，串行 |
| 數據速率/采樣率 (SPS，BPS)： | 105k |
| 電壓基準： | 內部 |
| 電源電壓： | 1.6 V ~ 3.6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-VQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 16-LFCSP-VQ |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 779 (CN2011-ZH PDF) |
| 其它名稱： | AD7879-1ACPZ-500R7DKR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁當前第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁
AD7879/AD7889
Rev. C | Page 30 of 40
INTERRUPTS
The AD7879/AD7889 have a dual function interrupt output,
INT, as well as a pen-down interrupt, PENIRQ. The INT output
can be configured as a data available interrupt (DAV), as an
out-of-limit interrupt (INT), or as a GPIO interrupt.
DAV—Data Available Interrupt
The behavior of the interrupt output is controlled by Bit 13 in
Control Register 3. In default mode (Bit 13 = 0), INT operates
as a data available interrupt (DAV). When the AD7879/AD7889
finish a conversion or a conversion sequence, the interrupt is
asserted to let the host know that new ADC data is available in
the result registers.
While the ADC is idle or is converting, DAV is high. When the
ADC has finished converting and new data has been written to
the result registers, DAV goes low. Reading the result registers
resets DAV to a high condition. DAV is also reset if a new con-
version is started by the AD7879/AD7889 because the timer
expired. The host should read the result registers only when
DAV is low. To ensure correct operation of the DAV mode
when using the SPI interface, it is necessary to write 0x0000
to Register 0x81 after a set of register reads. This clears the
internal data read signal.
ADC
CONVERTING
SETUP
BY HOST
IDLE
NEW DATA
AVAILABLE
HOST READS
RESULTS
IDLE
tCONV
AD7879/
AD7889
STATUS
DAV
07667-
034
Figure 35. Operation of DAV Output
When the on-board timer is programmed to perform automatic
conversions, limited time is available to the host to read the
result registers before another sequence of conversions begins.
The DAV signal is reset high when the timer expires, and the
host should not access the result registers while DAV is high.
INT—Out-of-Limit Interrupt
The INT pin operates as an alarm or interrupt output when
Bit 13 in Control Register 3 (Address 0x03) is set to 1. The
output goes low if any one of the interrupt sources is asserted.
The results of high and low limit comparisons on the AUX,
VBAT, and TEMP channels are interrupt sources. An out-of-
limit comparison sets a status bit in the interrupt register. A
separate status bit for the high limit and the low limit on each
channel indicates which limit was exceeded. The interrupt
sources can be masked by setting the corresponding enable bit
in this register to 1. There is one enable bit per channel.
PENIRQ—Pen Interrupt
The pen interrupt request output (PENIRQ) goes low whenever
the screen is touched and the PENIRQ enable bit is set to 0
(Control Register 1, Bit 15). When PENIRQ enable is set to 1,
the pen interrupt request output is disabled.
The pen interrupt equivalent output circuitry is shown in
Figure 36. This digital logic output has an internal 50 k pull-
up resistor, so it does not need an external pull-up. The
PENIRQ output idles high, and the PENIRQ circuitry is always
enabled in master mode (ADC mode = 11), except during
conversions.
07667-
035
X+
TOUCH
SCREEN
Y+
50k
Y–
X–
PENIRQ
ENABLE
PENIRQ
VCC
Figure 36. PENIRQ Output Equivalent Circuit
When the screen is touched, PENIRQ goes low. This generates
an interrupt request to the host. When the screen touch ends,
PENIRQ immediately goes high if the ADC is idle. If the ADC
is converting, PENIRQ goes high when the ADC becomes idle.
The PENIRQ operation for these two conditions is shown in
07667-
036
SCREEN
PENIRQ
ADC
STATUS
TOUCHED
NOT
TOUCHED
NOT
TOUCHED
NOT
TOUCHED
NOT
TOUCHED
ADC IDLE
SCREEN
PENIRQ
ADC
STATUS
TOUCHED
ADC IDLE
ADC
CONVERTING
ADC IDLE
RELEASE NOT
DETECTED
PENIRQ
DETECTS
RELEASE
PENIRQ
DETECTS
RELEASE
PENIRQ
DETECTS
TOUCH
PENIRQ
DETECTS
TOUCH
Figure 37. PENIRQ Operation for ADC Idle and ADC Converting
相關PDF資料 |
PDF描述 |
|---|---|
| QT60160-ISG QS129 | SENSOR IC MTRX TOUCH16KEY 32-QFN |
| SY100EL12ZC TR | IC DRIVER LOW IMPEDANCE 8-SOIC |
| SY100EL12ZC | IC DRIVER LOW IMPEDANCE 8-SOIC |
| SY100E416JI TR | IC LINE RCVR QUINT DIFF 28-PLCC |
| AD7148ACPZ-1500RL7 | IC CAP-TO-DGTL CONV PROG 16LFCSP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7879-1ACPZ-RL | 功能描述:IC ADC 12BIT CTLR TOUCH 16LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 觸摸屏控制器 系列:- 標準包裝:96 系列:- 類型:- 觸摸面板接口:- 輸入數/鍵:- 分辨率（位）:- 評估套件:* 數據接口:- 數據速率/采樣率 (SPS，BPS):- 電壓基準:- 電源電壓:- 電流 - 電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| AD7879-1WACPZ-RL | 功能描述:IC ADC 12BIT CTRLR TOUCH 16LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 觸摸屏控制器 系列:- 標準包裝:96 系列:- 類型:- 觸摸面板接口:- 輸入數/鍵:- 分辨率（位）:- 評估套件:* 數據接口:- 數據速率/采樣率 (SPS，BPS):- 電壓基準:- 電源電壓:- 電流 - 電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| AD7879-1WACPZ-RL7 | 功能描述:IC ADC 12BIT CTRLR TOUCH 16LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 觸摸屏控制器 系列:- 標準包裝:96 系列:- 類型:- 觸摸面板接口:- 輸入數/鍵:- 分辨率（位）:- 評估套件:* 數據接口:- 數據速率/采樣率 (SPS，BPS):- 電壓基準:- 電源電壓:- 電流 - 電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| AD7879-1WARUZ-RL | 功能描述:IC ADC 12BIT CTRLR TOUCH 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 觸摸屏控制器 系列:- 標準包裝:96 系列:- 類型:- 觸摸面板接口:- 輸入數/鍵:- 分辨率（位）:- 評估套件:* 數據接口:- 數據速率/采樣率 (SPS，BPS):- 電壓基準:- 電源電壓:- 電流 - 電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| AD7879-1WARUZ-RL7 | 功能描述:IC ADC 12BIT CTRLR TOUCH 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 觸摸屏控制器 系列:- 標準包裝:96 系列:- 類型:- 觸摸面板接口:- 輸入數/鍵:- 分辨率（位）:- 評估套件:* 數據接口:- 數據速率/采樣率 (SPS，BPS):- 電壓基準:- 電源電壓:- 電流 - 電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。