- 您現在的位置：買賣IC網 > PDF目錄5822 > AD8220BRMZ-R7 (Analog Devices Inc)IC AMP INST JFET R-R 15MA 8MSOP PDF資料下載
參數資料
| 型號： | AD8220BRMZ-R7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 15/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP INST JFET R-R 15MA 8MSOP |
| 產品培訓模塊： | Power Line Monitoring |
| 設計資源： | Fully Isolated Input Module Based on AD7793, ADuM5401, and a High Performance In-Amp (CN0067) |
| 標準包裝： | 1,000 |
| 放大器類型： | 儀表 |
| 電路數： | 1 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 2 V/µs |
| -3db帶寬： | 1.5MHz |
| 電流 - 輸入偏壓： | 10pA |
| 電壓 - 輸入偏移： | 125µV |
| 電流 - 電源： | 750µA |
| 電流 - 輸出 / 通道： | 15mA |
| 電壓 - 電源，單路/雙路(±)： | 4.5 V ~ 36 V，±2.25 V ~ 18 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 8-MSOP |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
AD8220
Rev. B | Page 22 of 28
RF INTERFERENCE
RF rectification is often a problem in applications where there are
large RF signals. The problem appears as a small dc offset voltage.
The AD8220 by its nature has a 5 pF gate capacitance, CG, at its
inputs. Matched series resistors form a natural low-pass filter that
reduces rectification at high frequency (see Figure 61). The
relationship between external, matched series resistors and the
internal gate capacitance is expressed as follows:
G
DIFF
RC
FilterFreq
π
2
1
G
CM
RC
FilterFreq
π
2
1
AD8220
VOUT
CG
–VS
REF
–VS
R
+IN
–IN
+15V
–15V
0.1F
10F
0.1F
10F
03
57
9-
0
30
Figure 61. RFI Filtering Without External Capacitors
To eliminate high frequency common-mode signals while using
smaller source resistors, a low-pass RC network can be placed at
the input of the instrumentation amplifier (see Figure 62). The
filter limits the input signal bandwidth according to the following
relationship:
)
2
(
π
2
1
G
C
D
DIFF
C
R
FilterFreq
)
(
π
2
1
G
C
CM
C
R
FilterFreq
Mismatched CC capacitors result in mismatched low-pass filters.
The imbalance causes the AD8220 to treat what would have
been a common-mode signal as a differential signal. To reduce
the effect of mismatched external CC capacitors, select a value of
CD greater than 10 times CC. This sets the differential filter
frequency lower than the common-mode frequency.
R
AD8220
+15V
+IN
–IN
0.1F
10F
0.1F
REF
VOUT
–15V
CD
CC
10nF
1nF
4.02k
03
57
9-
00
3
Figure 62. RFI Suppression
COMMON-MODE INPUT VOLTAGE RANGE
The common-mode input voltage range is a function of the
input range and the outputs of Internal Amplifier A1, Internal
Amplifier A2, and Internal Amplifier A3, the reference voltage,
and the gain. Figure 27 to Figure 30 show common-mode
voltage ranges for various supply voltages and gains.
DRIVING AN ADC
An instrumentation amplifier is often used in front of an ADC
to provide CMRR and additional conditioning, such as a voltage
level shift and gain (see Figure 63). In this example, a 2.7 nF
capacitor and a 1 kΩ resistor create an antialiasing filter for the
AD7685. The 2.7 nF capacitor also serves to store and deliver
the necessary charge to the switched capacitor input of the
ADC. The 1 kΩ series resistor reduces the burden of the 2.7 nF
load from the amplifier. However, large source impedance in
front of the ADC can degrade THD.
The example shown in Figure 63 is for sub-60 kHz applications.
For higher bandwidth applications where THD is important,
the series resistor needs to be small. At worst, a small series
resistor can load the AD8220, potentially causing the output to
overshoot or ring. In such cases, a buffer amplifier, such as the
AD8615, should be used after the AD8220 to drive the ADC.
AD8220
AD7685
4.7F
ADR435
+5V
2.7nF
REF
1k
1.07k
+2.5V
+IN
–IN
±50mV
+5V
0.1F
10F
0
357
9-
0
33
Figure 63. Driving an ADC in a Low Frequency Application
相關PDF資料 |
PDF描述 |
|---|---|
| 2-50871-2 | CONN SOCKET RCPT .056-.065 30AU |
| 5050863-5 | CONN SOCKET RCPT .014-.026 30AU |
| AD8139ARDZ-REEL7 | IC AMP DIFF R-R LN LDIST 8SOIC |
| LTC6082IGN#TRPBF | IC AMP R-R QUAD I/O 16-SSOP |
| FG450 | FUSE INDUST 450A 550V BS IEC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8220BRMZ-RL | 功能描述:IC AMP INST JFET R-R 15MA 8MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:13 V/µs 增益帶寬積:3MHz -3db帶寬:- 電流 - 輸入偏壓:65pA 電壓 - 輸入偏移:3000µV 電流 - 電源:1.4mA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作溫度:-40°C ~ 85°C 安裝類型:通孔 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-PDIP 包裝:管件 |
| AD8220-EVAL | 制造商:AD 制造商全稱:Analog Devices 功能描述:JFET Input Instrumentation Amplifier with Rail-to-Rail Output in MSOP Package |
| AD8220-EVALZ | 制造商:Analog Devices 功能描述:Evaluation Board For JFET Instrumentation Amplifier Evaluation Board 制造商:Analog Devices 功能描述:JFET INSTRUMENTATION AMP EVAL BD - Bulk 制造商:Analog Devices 功能描述:AD8220 Evaluation Board |
| AD8220TRMZ-EP | 功能描述:IC OP AMP JFET RR 8MSOP 制造商:analog devices inc. 系列:- 包裝:管件 零件狀態:在售 放大器類型:J-FET 電路數:1 輸出類型:滿擺幅 壓擺率:2 V/μs -3db 帶寬:1.5MHz 電流 - 電源:750μA 電流 - 輸出/通道:15mA 電壓 - 電源，單/雙（±）:4.5 V ~ 36 V，±2.25 V ~ 18 V 工作溫度:-55°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商器件封裝:8-MSOP 標準包裝:50 |
| AD8220TRMZ-EP-R7 | 功能描述:IC OP AMP JFET RR 8MSOP 制造商:analog devices inc. 系列:- 包裝:帶卷（TR） 零件狀態:在售 放大器類型:J-FET 電路數:1 輸出類型:滿擺幅 壓擺率:2 V/μs -3db 帶寬:1.5MHz 電流 - 電源:750μA 電壓 - 電源，單/雙（±）:4.5 V ~ 36 V，±2.25 V ~ 18 V 工作溫度:-55°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商器件封裝:8-MSOP 標準包裝:1,000 |
發布緊急采購，3分鐘左右您將得到回復。