- 您現在的位置：買賣IC網 > PDF目錄378284 > ADC12762 (National Semiconductor Corporation) 12-Bit, 1.4 MHz, 300 mW A/D Converter with Input Multiplexer and Sample/Hold PDF資料下載
參數資料
| 型號： | ADC12762 |
| 廠商： | National Semiconductor Corporation |
| 英文描述： | 12-Bit, 1.4 MHz, 300 mW A/D Converter with Input Multiplexer and Sample/Hold |
| 中文描述： | 12位，1.4兆赫，300毫瓦的A / D輸入多路復用器和轉換器采樣/保持 |
| 文件頁數： | 15/20頁 |
| 文件大?。?/td> | 427K |
| 代理商： | ADC12762 |
Applications Information
(Continued)
Since the current flowing through the SENSE lines is essen-
tially zero, there is negligible voltage drop across R
and the
1 k
resistor, so the voltage at the inverting input of the op
amp accurately represents the voltage at the top (or bottom)
of the ladder. The op amp drives the FORCE input and
forces the voltage at the ends of the ladder to equal the volt-
age at the op amps’s non-inverting input, plus or minus its in-
put offset voltage. For this reason op amps with low V
,
such as the LMC6081, should be used for this application.
When used in this configuration, the ADC12762 has less
than 4 LSBs of offset and gain error without any user adjust-
ments.
The 0.1 μF and 10 μF capacitors on the force inputs provide
high frequency decoupling of the reference ladder. The 500
force resistors isolate the op amps from this large capacitive
load. The 0.01 μF/1 k
network provides zero phase shift at
high frequencies to ensure stability. Note that the positive op
amp supply voltage must be at least 2.5V above the refer-
ence voltage and that a negative op amp supply is needed to
supply the sub-zero voltage to the V
pin. The
V
output should be bypassed to analog ground with a
0.1 μF ceramic capacitor.
The reference inputs are fully differential and define the zero
to full-scale range of the input signal. They can be configured
to span up to 5V (V
= 0V, V
= 5V), or they can be
connected to different voltages (within the 0V to 5V limits)
when other input spans are required. The ADC12762 is
tested at V
= 0V, V
= 4.096V. Re-
ducing the reference voltage span to less than 4V increases
the sensitivity (reduces the LSB size) of the converter; how-
ever noise performance degrades when lower reference
voltages are used. A plot of dynamic performance vs refer-
ence voltage is given in the Typical Performance Character-
istics section.
If the converter will be used in an application where DC ac-
curacy is secondary to dynamic performance, then a simpler
reference circuit may suffice. The circuit shown in Figure 11
will introduce several LSBs of offset and gain error, but INL,
DNL, and all dynamic specifications will be unaffected.
All bypass capacitors should be located as close to the
ADC12762 as possible to minimize noise on the reference
ladder. The V
output should be bypassed to analog
ground with a 0.1 μF ceramic capacitor.
The LM4040 shunt voltage reference is available with a
4.096V output voltage. With initial accuracies as low as
±
0.1%, it makes an excellent reference for the ADC12762.
DS012811-33
FIGURE 10. Reference Ladder Force and Sense Inputs
www.national.com
15
相關PDF資料 |
PDF描述 |
|---|---|
| ADC12762CCV | Low Dropout Linear 1-cell Li-Ion Charge Controller with AutoCompTM, 4.2V 8-MSOP -20 to 70 |
| ADC128S022 | 8-Channel, 50 kSPS to 200 kSPS, 12-Bit A/D Converter |
| ADC128S022CIMT | 8-Channel, 50 kSPS to 200 kSPS, 12-Bit A/D Converter |
| ADC128S022CIMTX | 8-Channel, 50 kSPS to 200 kSPS, 12-Bit A/D Converter |
| ADC128S022EVAL | 8-Channel, 50 kSPS to 200 kSPS, 12-Bit A/D Converter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADC12762CCV | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:12-Bit, 1.4 MHz, 300 mW A/D Converter with Input Multiplexer and Sample/Hold |
| ADC12762CCVX | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Single-Ended Data Acquisition System |
| ADC1276X | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:ADC1276X 14BIT 10MSPS ADC|Data Sheet |
| ADC128 | 制造商:MPSIND 制造商全稱:MPS Industries, Inc. 功能描述:1W, Miniature SIP, Single & Dual Output DC/DC Converters |
| ADC1280X | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:ADC1280X 10BIT 30MSPS ADC ADC1280X|Data Sheet |
發布緊急采購，3分鐘左右您將得到回復。