- 您現在的位置：買賣IC網 > PDF目錄19462 > ADSP-21061KSZ-200 (Analog Devices Inc)IC DSP CONTROLLER 32BIT 240MQFP PDF資料下載
參數資料
| 型號： | ADSP-21061KSZ-200 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 3/52頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DSP CONTROLLER 32BIT 240MQFP |
| 產品培訓模塊： | SHARC Processor Overview |
| 標準包裝： | 1 |
| 系列： | SHARC® |
| 類型： | 浮點 |
| 接口： | 同步串行端口（SSP） |
| 時鐘速率： | 50MHz |
| 非易失內存： | 外部 |
| 芯片上RAM： | 128kB |
| 電壓 - 輸入/輸出： | 5.00V |
| 電壓 - 核心： | 5.00V |
| 工作溫度： | 0°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 240-BFQFP 裸露焊盤 |
| 供應商設備封裝： | 240-MQFP-EP（32x32） |
| 包裝： | 托盤 |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁
Rev. D | Page 11 of 52 | May 2013
TFSx
I/O
Transmit Frame Sync (Serial Ports 0, 1).
RFSx
I/O
Receive Frame Sync (Serial Ports 0, 1).
EBOOT
I
EPROM Boot Select.
When EBOOT is high, the ADSP-21061 is configured for booting from an 8-bit EPROM.
When EBOOT is low, the LBOOT and BMS inputs determine booting mode. See the table in the BMS pin
description below. This signal is a system configuration selection that should be hardwired.
LBOOT
I
Link Boot.
Must be tied to GND.
BMS
I/O/T*
Boot Memory Select. Output
: Used as chip select for boot EPROM devices (when EBOOT = 1,
LBOOT = 0). In a multiprocessor system, BMS is output by the bus master. Input: When low, indicates that no
booting will occur and that ADSP-21061 will begin executing instructions from external memory. See table
below. This input is a system configuration selection that should be hardwired. *Three-statable only in
EPROM boot mode (when BMS is an output).
EBOOT
LBOOT
BMS
Booting Mode
1
0
Output
EPROM (Connect BMS to EPROM chip select.)
0
1(Input)
Host Processor.
0
0 (Input)
No Booting. Processor executes from external memory.
CLKIN
I
Clock In.
External clock input to the ADSP-21061. The instruction cycle rate is equal to CLKIN. CLKIN may
not be halted, changed, or operated below the minimum specified frequency.
RESET
I/A
Processor Reset.
Resets the ADSP-21061 to a known state and begins program execution at the program
memory location specified by the hardware reset vector address. This input must be asserted (low) at
power-up.
TCK
I
Test Clock (JTAG).
Provides an asynchronous clock for JTAG boundary scan.
TMS
I/S
Test Mode Select (JTAG).
Used to control the test state machine. TMS has a 20 k internal pull-up resistor.
TDI
I/S
Test Data Input (JTAG).
Provides serial data for the boundary scan logic. TDI has a 20 k internal pull-up
resistor.
TDO
O
Test Data Output (JTAG).
Serial scan output of the boundary scan path.
TRST
I/A
Test Reset (JTAG).
Resets the test state machine. TRST must be asserted (pulsed low) after power-up or held
low for proper operation of the ADSP-21061. TRST has a 20 k internal pull-up resistor.
EMU
O
Emulation Status.
Must be connected to the ADSP-21061 EZ-ICE target board connector only. EMU has a
50 k internal pull-up resistor.
ICSA
O
Reserved.
Leave unconnected.
VDD
P
Power Supply
. (30 pins). See Operating Conditions (5 V) and Operating Conditions (3.3 V).
GND
G
Power Supply Return.
(30 pins)
NC
Do Not Connect.
Reserved pins which must be left open and unconnected.
Table 2. Pin Descriptions (Continued)
Pin
Type
Function
A = Asynchronous, G = Ground, I = Input, O = Output, P = Power Supply, S = Synchronous, (A/D) = Active Drive, (O/D) = Open-Drain,
T = Three-State (when SBTS is asserted, or when the ADSP-21061 is a bus slave)
相關PDF資料 |
PDF描述 |
|---|---|
| VE-2WL-CY-F1 | CONVERTER MOD DC/DC 28V 50W |
| RSO-2415D/H2 | CONV DC/DC 1W 18-36VIN +/-15VOUT |
| VE-B1R-CX-B1 | CONVERTER MOD DC/DC 7.5V 75W |
| AYM24DTMD-S189 | CONN EDGECARD 48POS R/A .156 SLD |
| TMP03FSZ-REEL | IC SENSOR TEMP/SERIAL OC 8SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADSP-21061L | 制造商:Analog Devices 功能描述: |
| ADSP-21061LAS-160 | 制造商:AD 制造商全稱:Analog Devices 功能描述:ADSP-2106x SHARC DSP Microcomputer Family |
| ADSP-21061LAS-176 | 制造商:Analog Devices 功能描述:DSP Floating-Point 32-Bit 44MHz 44MIPS 240-Pin MQFP Tray 制造商:Analog Devices 功能描述:IC MICROCOMPUTER DSP |
| ADSP-21061LASZ-176 | 功能描述:IC DSP CONTROLLER 32BIT 240MQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - DSP（數字式信號處理器） 系列:SHARC® 標準包裝:40 系列:TMS320DM64x, DaVinci™ 類型:定點 接口:I²C，McASP，McBSP 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:160kB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:0°C ~ 90°C 安裝類型:表面貼裝 封裝/外殼:548-BBGA，F(xiàn)CBGA 供應商設備封裝:548-FCBGA（27x27） 包裝:托盤 配用:TMDSDMK642-0E-ND - DEVELPER KIT W/NTSC CAMERA296-23038-ND - DSP STARTER KIT FOR TMS320C6416296-23059-ND - FLASHBURN PORTING KIT296-23058-ND - EVAL MODULE FOR DM642TMDSDMK642-ND - DEVELOPER KIT W/NTSC CAMERA |
| ADSP-21061LKB-160 | 功能描述:IC DSP CONTROLLER 32BIT 225BGA RoHS:否 類別:集成電路 (IC) >> 嵌入式 - DSP（數字式信號處理器） 系列:SHARC® 標準包裝:2 系列:StarCore 類型:SC140 內核 接口:DSI，以太網，RS-232 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:1.436MB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:-40°C ~ 105°C 安裝類型:表面貼裝 封裝/外殼:431-BFBGA，F(xiàn)CBGA 供應商設備封裝:431-FCPBGA（20x20） 包裝:托盤 |
發布緊急采購，3分鐘左右您將得到回復。