- 您現在的位置：買賣IC網 > PDF目錄11722 > ADUC7039BCP6Z (Analog Devices Inc)IC MCU ARM7 BATT SENSER 32LFCSP PDF資料下載
參數資料
| 型號： | ADUC7039BCP6Z |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 57/92頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MCU ARM7 BATT SENSER 32LFCSP |
| 標準包裝： | 1 |
| 系列： | MicroConverter® ADuC7xxx |
| 核心處理器： | ARM7 |
| 芯體尺寸： | 16/32-位 |
| 速度： | 20.48MHz |
| 連通性： | LIN，SPI |
| 外圍設備： | POR，溫度傳感器，WDT |
| 輸入/輸出數： | 6 |
| 程序存儲器容量： | 64KB（32K x 16） |
| 程序存儲器類型： | 閃存 |
| RAM 容量： | 1K x 32 |
| 電壓 - 電源 (Vcc/Vdd)： | 3.5 V ~ 18 V |
| 數據轉換器： | A/D 2x16b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 115°C |
| 封裝/外殼： | 32-VFQFN 裸露焊盤，CSP |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁當前第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁
ADuC7039
Data Sheet
Rev. D | Page 60 of 92
IRQ
The IRQ is the exception signal to enter the IRQ mode of the
processor. It is used to service the general-purpose interrupt
handling of internal and external events.
All 32 bits are logically OR’ed to create a single IRQ signal to the
ARM7TDMI-S core. The four 32-bit registers dedicated to IRQ
follow.
IRQSIG
IRQSIG is a read-only register that reflects the status of the
different IRQ sources. If a peripheral generates an IRQ signal,
the corresponding bit in the IRQSIG is set; otherwise, it is
cleared. The IRQSIG bits are cleared when the interrupt in the
particular peripheral is cleared. All IRQ sources can be masked
in the IRQEN MMR.
IRQEN
IRQEN provides the value of the current enable mask. When
a bit is set to 1, the corresponding source request is enabled
to create an IRQ exception. When a bit is set to 0, the corre-
sponding source request is disabled or masked which does
not create an IRQ exception. The IRQEN register cannot be
used to disable an interrupt.
IRQCLR
IRQCLR is a write-only register that allows the IRQEN register
to clear to mask an interrupt source. Each bit set to 1 clears the
corresponding bit in the IRQEN register without affecting the
remaining bits. The pair of registers, IRQEN
and IRQCLR, allow independent manipulation of the enable
mask without requiring an atomic read-modify-write.
IRQSTA
IRQSTA is a read-only register that provides the current enabled
IRQ source status (effectively a logic AND of the IRQSIG and
IRQEN bits). When set to 1, that source generates an active IRQ
request to the ARM7TDMI-S core. There is no priority encoder
or interrupt vector generation. This function is implemented in
software in a common interrupt handler routine.
Fast Interrupt Request (FIQ)
The fast interrupt request (FIQ) is the exception signal to enter
the FIQ mode of the processor. It is provided to service data
transfer or communication channel tasks with low latency. The
FIQ interface is identical to the IRQ interface and provides the
second level interrupt (highest priority). Four 32-bit registers
are dedicated to FIQ: FIQSIG, FIQEN, FIQCLR, and FIQSTA.
Bit 31 to Bit 1 of FIQSTA are logically OR’ed to create the FIQ
signal to the core and to Bit 0 of both the FIQ and IRQ registers
(FIQ source).
The logic for FIQEN and FIQCLR does not allow an interrupt
source to be enabled in both IRQ and FIQ masks. A bit set to
1 in FIQEN clears, as a side effect, the same bit in IRQEN.
Likewise, a bit set to 1 in IRQEN clears, as a side effect, the
same bit in FIQEN. An interrupt source can be disabled in
both IRQEN and FIQEN masks.
Programmed Interrupts
Because the programmed interrupts are not maskable, they are
controlled by another register, SWICFG that writes into both
IRQSTA and IRQSIG registers and/or the FIQSTA and FIQSIG
registers at the same time.
The 32-bit register dedicated to software interrupt is SWICFG
described in Table 45. This MMR allows the control of a pro-
grammed source interrupt.
Table 45. SWICFG MMR Bit Designations
Bit
Description
31 to 3
Reserved.
2
Programmed interrupt FIQ.
Setting/clearing this bit corresponds to
setting/clearing Bit 1 of FIQSTA and FIQSIG.
1
Programmed interrupt IRQ.
Setting/clearing this bit corresponds to
setting/clearing Bit 1 of IRQSTA and IRQSIG.
0
Reserved.
Note that any interrupt signal must be active for at least
the minimum interrupt latency time, to be detected by the
interrupt controller and to be detected by the user in the
IRQSTA/FIQSTA register.
相關PDF資料 |
PDF描述 |
|---|---|
| ADUC7022BCPZ32 | IC MCU FLSH 32K ANLG I/O 40LFCSP |
| VE-BTJ-IX-F1 | CONVERTER MOD DC/DC 36V 75W |
| ADUC7023BCPZ62I | IC MCU 12BIT 62KB FLASH 32LFCSP |
| D38999/26MB98HN | CONN PLUG 6POS STRAIGHT W/PINS |
| VE-B7L-IW-F1 | CONVERTER MOD DC/DC 28V 100W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADUC7039BCP6Z-RL | 功能描述:IC MCU ARM7 BATT SENSER 32LFCSP RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:MicroConverter® ADuC7xxx 標準包裝:38 系列:Encore!® XP® 核心處理器:eZ8 芯體尺寸:8-位 速度:5MHz 連通性:IrDA，UART/USART 外圍設備:欠壓檢測/復位，LED，POR，PWM，WDT 輸入/輸出數:16 程序存儲器容量:4KB（4K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 3.6 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 105°C 封裝/外殼:20-SOIC（0.295"，7.50mm 寬） 包裝:管件 其它名稱:269-4116Z8F0413SH005EG-ND |
| ADUC7039WBCPZ | 制造商:Analog Devices 功能描述:FLASH 64K ARM7 DUAL 16-BIT ADC LIN I.C. - Trays 制造商:Analog Devices 功能描述:IC MCU ARM7 64KB FLASH 32LFCSP 制造商:Analog Devices 功能描述:Flash 64k ARM7 Dual 16-Bit ADC LIN I.C. |
| ADUC7039WBCPZ-RL | 制造商:Analog Devices 功能描述:FLASH 64K ARM7 DUAL 16-BIT ADC LIN I.C. - Tape and Reel 制造商:Analog Devices 功能描述:IC MCU ARM7 64KB FLASH 32LFCSP 制造商:Analog Devices 功能描述:Flash 64k ARM7 Dual 16-Bit ADC LIN I.C. |
| ADUC7060 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Power, Precision Analog Microcontroller, Dual Sigma-Delta ADCs, Flash/EE, ARM7TDMI |
| ADUC7060BCPZ32 | 功能描述:IC MCU 24BIT 32KB FLASH 48LFCSP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:MicroConverter® ADuC7xxx 產品培訓模塊:MCU Product Line Introduction XMEGA Introduction AVR XMEGA USB Connectivity 標準包裝:90 系列:AVR® XMEGA 核心處理器:AVR 芯體尺寸:8/16-位 速度:32MHz 連通性:I²C，IrDA，SPI，UART/USART 外圍設備:欠壓檢測/復位，DMA，POR，PWM，WDT 輸入/輸出數:50 程序存儲器容量:192KB（96K x 16） 程序存儲器類型:閃存 EEPROM 大小:4K x 8 RAM 容量:16K x 8 電壓 - 電源 (Vcc/Vdd):1.6 V ~ 3.6 V 數據轉換器:A/D 16x12b; D/A 2x12b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:64-TQFP 包裝:托盤 配用:ATSTK600-RC14-ND - STK600 SOCKET/ADAPTER 64TQFPATSTK600-TQFP64-ND - STK600 SOCKET/ADAPTER 64-TQFPATAVRONEKIT-ND - KIT AVR/AVR32 DEBUGGER/PROGRMMRATAVRISP2-ND - PROGRAMMER AVR IN SYSTEM |
發布緊急采購，3分鐘左右您將得到回復。