- 您現在的位置：買賣IC網 > PDF目錄8667 > ADV7120KSTZ30-REEL (Analog Devices Inc)IC DAC VIDEO 3CH 30MHZ 48-LQFP PDF資料下載
參數資料
| 型號： | ADV7120KSTZ30-REEL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 11/12頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DAC VIDEO 3CH 30MHZ 48-LQFP |
| 產品培訓模塊： | Data Converter Fundamentals DAC Architectures |
| 標準包裝： | 2,000 |
| 設置時間： | 12ns |
| 位數： | 8 |
| 數據接口： | 并聯 |
| 轉換器數目： | 3 |
| 電壓電源： | 單電源 |
| 功率耗散（最大）： | 625mW |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 48-LQFP |
| 供應商設備封裝： | 48-LQFP（7x7） |
| 包裝： | 帶卷 (TR) |
| 輸出數目和類型： | 3 電流，單極 |
| 采樣率（每秒）： | 30M |
ADV7120
REV. B
–8–
A resistance RSET connected between FS ADJUST and GND
determines the amplitude of the output video level according to
the following equations:
IOG (mA) = 12,082
× V
REF (V)/RSET (
)
(1)
IOR, IOB (mA) = 8,628
× V
REF (V)/RSET ()
(2)
If SYNC is not being encoded onto the green channel, then
Equation 1 will be similar to Equation 2.
Using a variable value of RSET, as shown in Figure 4, allows for
accurate adjustment of the analog output video levels. Use of a
fixed 560
R
SET resistor yields the analog output levels as
quoted in the specification page. These values also correspond
to the RS-343A video waveform values as shown in Figure 3.
TO DACs
ADV7120*
V
AA
V
REF
GND
1k
FS ADJUST
R
SET
560
500
100
*ADDITIONAL CIRCUITRY, INCLUDING
DECOUPLING COMPONENTS,
EXCLUDED FOR CLARITY
ANALOG POWER PLANE
COMP
0.1
F
5V
+
AD589
(1.235V
VOLTAGE
REFERENCE)
I
REF ≈ 4mA
Figure 4. Reference Circuit
D/A Converters
The ADV7120 contains three matched 8-bit D/A converters.
The DACs are designed using an advanced, high speed, seg-
mented architecture. The bit currents corresponding to each
digital input are routed to either the analog output (bit = “1”)
or GND (bit = “0”) by a sophisticated decoding scheme. As all
three DACs is optimized. As well as matching, the use of identi-
cal current sources in a monolithic design guarantees monoto-
nicity and low glitch. The onboard operational amplifier
stabilizes the full-scale output current against temperature and
power supply variations.
Analog Outputs
The ADV7120 has three analog outputs, corresponding to the red,
green and blue video signals. A fourth analog output (ISYNC) can be
used if it is required to encode video synchronization information
onto the green signal. In this case, ISYNC is connected to IOG .
(See “Video Synchronization and Control” section.)
The red, green and blue analog outputs of the ADV7102 are
high impedance current sources. Each one of these three RGB
current outputs is capable of directly driving a 37.5
load, such
as a doubly terminated 75
coaxial cable. Figure 5a shows the
required configuration for each of the three RGB outputs con-
nected into a doubly terminated 75
load. This arrangement
will develop RS-343A video output voltage levels across a 75
monitor.
TERMINATION REPEATED THREE TIMES
FOR RED, GREEN AND BLUE DACs
DACs
IOR, IOG, IOB
(CABLE)
Z
O = 75
Z
S = 75
(SOURCE
TERMINATION)
Z
L = 75
(MONITOR)
Figure 5a. Analog Output Termination for RS-343A
One suggested method of driving RS-170 video levels into a 75
monitor is shown in Figure 5b. The output current levels of the
DACs remain unchanged but the source termination resistance,
ZS, on each of the three DACs is increased from 75
to 150 .
TERMINATION REPEATED THREE TIMES
FOR RED, GREEN AND BLUE DACs
DACs
IOR, IOG, IOB
(CABLE)
Z
O = 75
Z
S = 150
(SOURCE
TERMINATION)
Z
L = 75
(MONITOR)
Figure 5b. Analog Output Termination for RS-170
More detailed information regarding load terminations for vari-
ous output configurations, including RS-343A and RS-170, is
available in an application note entitled “Video Formats & Re-
quired Load Terminations” available from Analog Devices,
publication number E1228-15-1/89.
Figure 3 shows the video waveforms associated with the three
RGB outputs driving the doubly terminated 75
load of Figure
5a. As well as the gray scale levels, black level to white level, the
diagram also shows the contributions of SYNC and BLANK.
These control inputs add appropriately weighted currents to the
analog outputs, producing the specific output level requirements
for video applications. Table I details how the SYNC and
BLANK
inputs modify the output levels.
Gray Scale Operation
The ADV7120 can be used for stand-alone, gray scale (mono-
chrome) or composite video applications (i.e., only one channel
used for video information). Any one of the three channels, red,
green or blue, can be used to input the digital video data. The
two unused video data channels should be tied to logical zero.
相關PDF資料 |
PDF描述 |
|---|---|
| VE-J5N-MX-B1 | CONVERTER MOD DC/DC 18.5V 75W |
| VE-230-MW-B1 | CONVERTER MOD DC/DC 5V 100W |
| VE-22W-MW-B1 | CONVERTER MOD DC/DC 5.5V 100W |
| VE-J53-MX-B1 | CONVERTER MOD DC/DC 24V 75W |
| VE-JVX-MY | CONVERTER MOD DC/DC 5.2V 50W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADV7120KSTZ50 | 功能描述:IC DAC VIDEO 3-CH 50MHZ 48-LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:1 系列:- 設置時間:4.5µs 位數:12 數據接口:串行，SPI? 轉換器數目:1 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOICN 包裝:剪切帶 (CT) 輸出數目和類型:1 電壓，單極；1 電壓，雙極 采樣率（每秒）:* 其它名稱:MCP4921T-E/SNCTMCP4921T-E/SNRCTMCP4921T-E/SNRCT-ND |
| ADV7121 | 制造商:AD 制造商全稱:Analog Devices 功能描述:CMOS 80 MHz, Triple 10-Bit Video DACs |
| ADV7121JN30 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Video DAC without Color Palette |
| ADV7121JN50 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Video DAC without Color Palette |
| ADV7121JN80 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Video DAC without Color Palette |
發布緊急采購，3分鐘左右您將得到回復。