- 您現在的位置：買賣IC網 > PDF目錄366550 > AM79C930 (Advanced Micro Devices, Inc.) PCnet-Mobile Single-Chip Wireless LAN Media Access Controller PDF資料下載
參數資料
| 型號： | AM79C930 |
| 廠商： | Advanced Micro Devices, Inc. |
| 英文描述： | PCnet-Mobile Single-Chip Wireless LAN Media Access Controller |
| 中文描述： | PCnet -移動單芯片無線局域網媒體接入控制器 |
| 文件頁數： | 94/161頁 |
| 文件大?。?/td> | 691K |
| 代理商： | AM79C930 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁當前第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁
AMD
P R E L I M I N A R Y
94
Am79C930
TIR8: Transmit Control
This register is the Transmitter Control register.
Bit
Name
Reset Value
Description
7
TXRES
0
Transmit Reset. When this bit is set to 1, the internal Transmit Re-
set signal is asserted. When this bit is set to 0, the internal Transmit
Reset signal is deasserted. The transmit FIFO is NOT reset
by TXRES.
Transmit FIFO Reset. When this bit is set to 1, the internal Transmit
FIFO Reset signal is asserted. When this bit is set to 0, the internal
Transmit FIFO Reset signal is deasserted.
DMA Select. When this bit is set to 1, the TXFIFO Not_Full signal is
routed to both of the 80188 DMA channels. When this bit is set to 0,
the TXFIFO Not_Full signal is routed to only DMA channel 1 of
the 80188.
Enable CRC-based Transmission. When this bit is set to 1, the in-
itiation of a transmission will commence when the logical AND of
the TXS bit (TIR8, bit 0) and the CRC32_GOOD output of the
CRC32 block becomes TRUE. Typically, the EN_TX_CRC bit and
the TXS bit are set together during a reception, such that if the re-
ception concludes with a correct CRC32 indication, then the trans-
mit state machine will automatically be started. When this bit is set
to 0, initiation of transmission will commence solely on the basis of
the setting of the TXS bit (TIR8, bit 0).
Rate Switch. When this bit is set to 1, the rate of data transmission
will automatically change immediately following the transmission of
the last bit of the PFL
th
byte that follows the last bit of the Start of
Frame Delimiter, where PFL is defined in TCR3, bits [3:0}. Since
the PFL field of TCR3 is typically used to demark the PHY HEADER
from the MAC data (and hence, it is used to determine the starting
point for MAC CRC32 calculation), the rate switch will typically oc-
cur on the PHY/MAC boundary. The rate of transmission will
change from DR to DR XOR 0x1, where DR is the Data Rate field as
defined in TCR30, bits [2:0}. When this bit is set to 0, no rate switch
will occur. RX operations are unaffected by this bit. For rate switch-
ing on the RX side, an external decode to RX clock and TX data is
typically performed.
Transmit CRC type. These two bits are used to determine the na-
ture of the CRC field that is appended to the current frame. These
bits must be stable throughout any given transmission. The follow-
ing interpretations have been assigned to these bits:
6
TXFR
0
5
DMA_SEL
0
4
EN_TX_CRC
0
3
RATE_SW
–
2–1
TCRC[1:0]
00b
TCRC[1:0]
Transmitted CRC
00
01
10
11
No CRC is appended
CRC8 is appended
CRC32 is appended
No CRC is appended
0
TXS
0
Transmit Start.
When this bit is set to 1, then the transmit state machine begins op-
eration. The transmit state machine is edge-sensitive; that is, this
bit must be reset to 0 and set again to 1 before a subsequent trans-
mission will begin. The transmit busy bit will be set in the transmit
status register (TIR9) to indicate the state of transmit. Resetting this
bit to 0 during transmission will not cause the current transmission
to be aborted. Transmission abort is performed with the TXRES bit.
相關PDF資料 |
PDF描述 |
|---|---|
| AM79C930VCW | PCnet-Mobile Single-Chip Wireless LAN Media Access Controller |
| AM79C940VCW | Media Access Controller for Ethernet (MACE) |
| AM79C940 | Media Access Controller for Ethernet (MACE) |
| AM79C940JCW | Media Access Controller for Ethernet (MACE) |
| AM79C940KCW | Media Access Controller for Ethernet (MACE) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AM79C930EVAL-HW | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Am79C930EVAL-HW - PCnet-Mobile Evaluation Kit |
| AM79C930VC/W | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnet-Mobile Single-Chip Wireless LAN Media Access Controller |
| AM79C930VCW | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnet-Mobile Single-Chip Wireless LAN Media Access Controller |
| AM79C940 | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:Media Access Controller for Ethernet (MACE) |
發布緊急采購，3分鐘左右您將得到回復。