- 您現在的位置：買賣IC網 > PDF目錄67389 > AT42QT1111-AU (ATMEL CORP) PROXIMITY SENSOR-CAPACITIVE, 0-5V, SQUARE, SURFACE MOUNT PDF資料下載
參數資料
| 型號： | AT42QT1111-AU |
| 廠商： | ATMEL CORP |
| 元件分類： | 速度傳感器和接近開關 |
| 英文描述： | PROXIMITY SENSOR-CAPACITIVE, 0-5V, SQUARE, SURFACE MOUNT |
| 封裝： | 7 X 7 MM, 1 MM HEIGHT, 0.80 MM PITCH, ROHS COMPLIANT, PLASTIC, MS-026ABA, TQFP-32 |
| 文件頁數： | 18/50頁 |
| 文件大?。?/td> | 637K |
| 代理商： | AT42QT1111-AU |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁
25
9571B–AT42–08/10
AT42QT1111-MU/AT42QT1111-AU
0 = only one key is in detect (specified by “KEY_NUM”)
1 = more than one key in detect.
ERROR: 0 = there are no keys in an error state; 1 = at least one key is in error state.
KEY_NUM: the key number (0 to 10) of the key in detect (if there is only one), or the number of
the first key to go into detection when there are more than one.
6.3
All Keys (0xC1)
Returns a 2-byte bit-field report indicating the detection status of all 11 keys.
KEY_n: 0 = key n out of detect, 1 = key n in detect (where n is 0–10).
6.4
Device Status (0xC2)
This command returns a 1-byte bit-field report indicating the overall status of the QT1111.
Bits 7 is always 1; the other bits are as follows:
DETECT: 0 = no key in detect, 1 = at least 1 key in detect.
CYCLE: 0 = cycle time is good, 1 = cycle time over-run. A cycle time over-run occurs when it
takes longer to measure and process all the keys than the assigned cycle time.
ERROR: 0 = no key in error state, 1 = at least 1 key in error.
CHANGE: 0 = CHANGE pin is asserted, 1 = CHANGE pin is floating.
EEPROM: 0 = EEPROM is good, 1 = EEPROM has an error. If there are no settings stored in
EEPROM, the EEPROM error bit is set and a zero EEPROM CRC is returned.
RESET: set to 1 after power-on or reset, cleared when “Device Status” is read.
GUARD: 0 = guard channel is not in detect, 1 = guard channel is active or in detect. This bit will
be zero if the guard channel is not enabled.
6.5
EEPROM CRC (0xC3)
This command returns a 1-byte CRC checksum for the setup data in EEPROM.
6.6
RAM CRC (0xC4)
This command returns a 1-byte CRC checksum for the setup data in RAM.
Table 6-3.
Send All Keys Report Format
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Byte 0
KEY_10
KEY_9
KEY_8
Byte 1
KEY_7
KEY_6
KEY_5
KEY_4
KEY_3
KEY_2
KEY_1
KEY_0
Table 6-4.
Device Status Report Format
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Byte 0
1
DETECT
CYCLE
ERROR
CHANGE
EEPROM
RESET
GUARD
相關PDF資料 |
PDF描述 |
|---|---|
| AT76C453AC-MY19T | IMAGE SENSOR-CMOS, 708(H) X 494(V) PIXEL, 30fps, SURFACE MOUNT |
| ATF-33143-TR2 | X BAND, Si, N-CHANNEL, RF SMALL SIGNAL, HEMFET |
| ATF-33143-BLK | X BAND, Si, N-CHANNEL, RF SMALL SIGNAL, HEMFET |
| ATF-33143-TR1 | X BAND, Si, N-CHANNEL, RF SMALL SIGNAL, HEMFET |
| ATF-50189 | 0 MHz - 2400 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AT42QT1111-AU QS383 | 制造商:Atmel Corporation 功能描述:QTOUCH 11 KEY TOUCH SENSOR IC |
| AT42QT1111MU | 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:QTouch? 11-key Sensor IC |
| AT42QT1111-MU | 功能描述:電容觸摸傳感器 QTouch 11 Key Touch Sensor IC RoHS:否 制造商:Microchip Technology 電源電壓: 通道數量: 封裝 / 箱體: 尺寸: 溫度范圍: |
| AT42QT1111-MU QS384 | 制造商:Atmel Corporation 功能描述:QTOUCH 11 KEY TOUCH SENSOR IC |
| AT42QT1244-AU | 功能描述:電容觸摸傳感器 QMatrix FMEA 24 Key Sensor IC RoHS:否 制造商:Microchip Technology 電源電壓: 通道數量: 封裝 / 箱體: 尺寸: 溫度范圍: |
發布緊急采購，3分鐘左右您將得到回復。