參數資料
型號: AT89C51ID2-SLRIM
廠商: Atmel
文件頁數: 22/157頁
文件大?。?/td> 0K
描述: IC MCU FLASH 8051 64K 5V 44-PLCC
標準包裝: 1
系列: 89C
核心處理器: 8051
芯體尺寸: 8-位
速度: 60MHz
連通性: I²C,SPI,UART/USART
外圍設備: POR,PWM,WDT
輸入/輸出數: 34
程序存儲器容量: 64KB(64K x 8)
程序存儲器類型: 閃存
EEPROM 大?。?/td> 2K x 8
RAM 容量: 2K x 8
電壓 - 電源 (Vcc/Vdd): 2.7 V ~ 5.5 V
振蕩器型: 外部
工作溫度: -40°C ~ 85°C
封裝/外殼: 44-LCC(J 形引線)
包裝: 剪切帶 (CT)
其它名稱: AT89C51ID2SLRIMCT
118
AT89C51ID2
4289C–8051–11/05
Table 89. Program Lock Bits
Note:
U: unprogrammed or "one" level.
P: programmed or "zero" level.
X: do not care
WARNING: Security level 2 and 3 should only be programmed after Flash and code
verification.
These security bits protect the code access through the parallel programming interface.
They are set by default to level 4. The code access through the ISP is still possible and
is controlled by the "software security bits" which are stored in the extra Flash memory
accessed by the ISP firmware.
To load a new application with the parallel programmer, a chip erase must first be done.
This will set the HSB in its inactive state and will erase the Flash memory. The part ref-
erence can always be read using Flash parallel programming modes.
Default Values
The default value of the HSB provides parts ready to be programmed with ISP:
BLJB: Programmed force ISP operation.
X2: Unprogrammed to force X1 mode (Standard Mode).
XRAM: Unprogrammed to valid XRAM
LB2-0: Security level four to protect the code from a parallel access with maximum
security.
Software Registers
Several registers are used, in factory and by parallel programmers. These values are
used by Atmel ISP.
These registers are in the "Extra Flash Memory" part of the Flash memory. This block is
also called "XAF" or eXtra Array Flash. They are accessed in the following ways:
Commands issued by the parallel memory programmer.
Commands issued by the ISP software.
Calls of API issued by the application software.
Several software registers described in Table 90.
Program Lock Bits
Protection description
Security
level
LB0
LB1
LB2
1
U
No program lock features enabled.
2P
U
MOVC instruction executed from external program memory is disabled
from fetching code bytes from internal memory, EA is sampled and
latched on reset, and further parallel programming of the on chip code
memory is disabled.
ISP and software programming with API are still allowed.
Writing EEprom Data from external parallel programmer is disabled but
still allowed from internal code execution.
3X
P
U
Same as 2, also verify code memory through parallel programming
interface is disabled.
Writing And Reading EEPROM Data from external parallel programmer
is disabled but still allowed from internal code execution..
4
X
P
Same as 3, also external execution is disabled. (Default)
相關PDF資料
PDF描述
PIC16C923-04/L IC MCU OTP 4KX14 LCD DVR 68PLCC
PIC18F2423-I/SO IC PIC MCU FLASH 8KX16 28SOIC
PIC16C57-LP/SO IC MCU OTP 2KX12 28SOIC
PIC18LF6410-I/PT IC PIC MCU FLASH 8KX16 64TQFP
AT89C51IC2-SLRIM IC MCU FLASH 8051 32K 5V 44-PLCC
相關代理商/技術參數
參數描述
AT89C51ID2-SLRUM 功能描述:8位微控制器 -MCU C51ID2 64K FLASH TWI 32KHz 5V RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
AT89C51ID2-SLSIM 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8-bit Flash Microcontroller
AT89C51ID2-SLSUM 功能描述:8位微控制器 -MCU 64K FLASH 32KHz 3.5-5V Ind. RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
AT89C51ID2-SMSIM 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8-bit Flash Microcontroller
AT89C51ID2-UM 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8-bit Flash Microcontroller