參數資料
型號: C161CS-32R
廠商: INFINEON TECHNOLOGIES AG
英文描述: 16-Bit Single-Chip Microcontroller
中文描述: 16位單片機
文件頁數: 37/89頁
文件大小: 876K
代理商: C161CS-32R
C161CS/JC/JI-32R
C161CS/JC/JI-L
Data Sheet
33
V3.0, 2001-01
CAN-Modules
The integrated CAN-Modules handle the completely autonomous transmission and
reception of CAN frames in accordance with the CAN specification V2.0 part B (active),
i.e. the on-chip CAN-Modules can receive and transmit standard frames with 11-bit
identifiers as well as extended frames with 29-bit identifiers.
The modules provide Full CAN functionality on up to 15 message objects each.
Message object 15 may be configured for Basic CAN functionality. Both modes provide
separate masks for acceptance filtering which allows to accept a number of identifiers in
Full CAN mode and also allows to disregard a number of identifiers in Basic CAN mode.
All message objects can be updated independent from the other objects and are
equipped for the maximum message length of 8 bytes.
The bit timing is derived from the XCLK and is programmable up to a data rate of
1 MBaud. Each CAN-Module uses two pins of Port 4 or Port 8 to interface to an external
bus transceiver. The interface pins are assigned via software.
Module CAN2
(C161CS only) is identical with the first one, except that it uses a separate
address area and a separate interrupt node.
The two CAN modules can be internally coupled by assigning their interface pins to the
same two port pins, or they can interface to separate CAN buses.
Note: When one or both of the on-chip CAN Modules are used with the interface lines
assigned to Port 4, the interface lines override the segment address lines and the
segment address output on Port 4 is therefore limited to 6/4 bits i.e. address lines
A21/A19 … A16. CS lines can be used to increase the total amount of addressable
external memory.
IIC Module
The integrated IIC Bus Module handles the transmission and reception of frames over
the two-line IIC bus in accordance with the IIC Bus specification. The on-chip IIC Module
can receive and transmit data using 7-bit or 10-bit addressing and it can operate in slave
mode, in master mode or in multi-master mode.
Several physical interfaces (port pins) can be established under software control. Data
can be transferred at speeds up to 400 kbit/sec.
Two interrupt nodes dedicated to the IIC module allow efficient interrupt service and also
support operation via PEC transfers.
Note: The port pins associated with the IIC interfaces feature open drain drivers only, as
required by the IIC specification.
相關PDF資料
PDF描述
C161K 16-Bit Single-Chip Microcontroller
C161O 16-Bit Single-Chip Microcontroller
C161PI RSD Series - Econoline Unregulated DC-DC Converters; Input Voltage (Vdc): 12V; Output Voltage (Vdc): 3.3V; Power: 1W; 1kVDC and 3kVDC Isolation Options; Approved for Medical Applications; Suitable for Automated Assembly; 8, 10 and 12 pin Pinning Style Options; Optional Continuous Short Circuit Protected; Efficiency to 85%
C161RI 16-Bit CMOS Single-Chip Microcontroller
C161SI-32F 16-bit microcontrollers(16位微控制器)
相關代理商/技術參數
參數描述
C161CSLFCABXUMA1 制造商:Infineon Technologies AG 功能描述:MCU 16-BIT C166 CISC/RISC ROMLESS 5V 128-PIN TQFP 制造商:Infineon Technologies AG 功能描述:16 BIT ROM/ROMLESS - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC MCU 16BIT ROMLESS 128TQFP
C161CSLFCAFXQMA1 制造商:Infineon Technologies AG 功能描述:MCU 16-BIT C166 CISC/RISC ROMLESS 5V 128-PIN TQFP 制造商:Infineon Technologies AG 功能描述:16 BIT ROM/ROMLESS - Trays 制造商:Infineon Technologies AG 功能描述:IC MCU 16BIT ROM/LESS TQFP-128-2
C161CSLFCAFXQMA2 功能描述:IC MCU 16BIT 128TQFP 制造商:infineon technologies 系列:* 零件狀態:最後搶購 標準包裝:1
C161CSLFCAFXUMA1 制造商:Infineon Technologies AG 功能描述:16 BIT ROM/ROMLESS - Tape and Reel
C161CSLFCAFXUMA2 功能描述:IC MCU 16BIT 128TQFP 制造商:infineon technologies 系列:* 零件狀態:最後搶購 標準包裝:1