- 您現在的位置：買賣IC網 > PDF目錄37420 > CLRC66301HN (NXP Semiconductors N.V.) Contactless reader IC PDF資料下載
參數資料
| 型號： | CLRC66301HN |
| 廠商： | NXP Semiconductors N.V. |
| 元件分類： | 通信及網絡 |
| 英文描述： | Contactless reader IC |
| 封裝： | CLRC66301HN<SOT617-3 (HVQFN32)|<<http://www.nxp.com/packages/SOT617-3.html<1<Always Pb-free,;CLRC66301HN<SOT617-3 (HVQFN32)|<<http://www.nxp.com/packages/SOT617-3.html< |
| 文件頁數： | 78/100頁 |
| 文件大?。?/td> | 856K |
| 代理商： | CLRC66301HN |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁當前第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁
CLRC663
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2011. All rights reserved.
Preliminary data sheet
COMPANY PUBLIC
Rev. 3.1 — 26 September 2011
171131
79 of 126
NXP Semiconductors
CLRC663
Contactless reader IC
10.5.5 Test Data Output (TDO)
The TDO pin provides an output stream of serial information from the IR chain or the DR
chains. The value of TDO depends on the current TAP state, the current instruction, and
the data in the chain being accessed. In order to save power when the JTAG port is not
being used, the TDO pin is placed in an inactive drive state when not actively shifting out
data. Because TDO can be connected to the TDI of another controller in a daisy-chain
configuration, the IEEE Standard 1149.1 expects the value on TDO to change on the
falling edge of TCK.
By default, the internal pull-up resistor on the TDO pin is enabled after reset. This assures
that the pin remains at a constant logic level when the JTAG port is not being used. The
internal pull-up and pull-down resistors can be turned off to save internal power if a High-Z
output value is acceptable during certain TAP controller states
10.5.6 Instruction register
The instruction register handles the working mode of the boundary scan cell. basically
there are three modes. BYPASS, SAMPLE/PRELOAD and EXTEST. According to the
standard also the definition of further commands are allowed. The CLRC663 Boundary
scan interface has Clamp and HighZ as additional instructions.
10.5.7 Data register
According to the IEEE1149.1 standard there are two types of data register defined:
bypass, boundary scan
The bypass register enable the possibility to bypass a devise when part of the scan path.
The boundary scan register is the chain of the boundary cells. The size of this register can
differ per device, in the CLRC663 it has the size of 8 bits.
10.5.8 Boundary scan cell
The boundary scan cell opens the possibility to control a hardware pin independent of its
normal usecase. Basically the cell can only do one of the following: control, output and
Input.
10.5.9 Boundary scan path
This chapter shows the boundary scan path of the CLRC663.
Fig 23. Boundary scan cell path structure
001aam306
TAP
LOGIC
TAP
IC1
IC2
TCK
TMS
TCK
TMS
TDO
Boundary scan cell
TDI
相關PDF資料 |
PDF描述 |
|---|---|
| CLT-114-02-G-D-BE | 28 CONTACT(S), FEMALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT |
| CLT-114-02-L-D-BE | 28 CONTACT(S), FEMALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT |
| CLT-115-02-F-D-BE | 30 CONTACT(S), FEMALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT |
| CLT-115-02-G-D-BE | 30 CONTACT(S), FEMALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT |
| CLT-115-02-L-D-BE | 30 CONTACT(S), FEMALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CLRC66301HN,151 | 功能描述:射頻收發器 13.56MHz 5V HVQFN32 RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| CLRC66301HN,157 | 功能描述:射頻收發器 13.56MHz 5V HVQFN32 RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| CLRC66301HN,551 | 功能描述:射頻收發器 Contactless readr IC IC RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| CLRC66301HN,557 | 功能描述:射頻收發器 Contactless readr IC IC RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| CLRC66302HN,118 | 制造商:NXP Semiconductors 功能描述:CLRC66302HN/HVQFN32/REEL13// - Tape and Reel 制造商:NXP Semiconductors 功能描述:IC CONTACTLESS READER 32HVQFN |
發布緊急采購，3分鐘左右您將得到回復。